2015 MAZDA MODEL 3 HATCHBACK boot

7–7
If Trouble Arises
Flat Tyre
CAUTION
  When using the temporary spare
tyre, driving stability may decrease
compared to when using only the
conventional tyre. Drive carefully.
  To avoid damage to the temporary
spare tyre or to the vehicle, observe
the following precautions:
 


 Do not exceed 80 km/h (50 mph).



 Avoid driving over obstacles. Also,
do not drive through an automatic
car wash. This tyre's diameter is
smaller than a conventional tyre,
so the ground clearance is reduced
about 10 mm (0.4 in).
 


 Do not use a tyre chain on this tyre
because it will not fi t properly.




 Do not use your temporary spare
tyre on any other vehicle, it has
been designed only for your
Mazda.
 


 Use only one temporary spare tyre
on your vehicle at the same time.
To remove the spare tyre
1. Lift the boot/luggage compartment mat.
Boot/Luggage compartment mat
2. Turn the spare tyre hold-down bolt
anticlockwise.
Spare tyre hold-down bolt
To secure the spare tyre
Store the spare tyre in the reverse order
of removal. After storing, verify that the
spare tyre is stored securely.
.B[EB@&'&&"@&EJUJPOJOEC







7–13
If Trouble Arises
Flat Tyre
WARNING
Do not adhere the speed restriction
sticker to the padded area on the
steering wheel:
Adhering the speed restriction sticker
to the padded area on the steering
wheel is dangerous because the air
bag may not operate (deploy) normally
resulting in serious injury. In addition,
do not adhere the sticker to areas where
warning lights or the speedometer
cannot be viewed.
14. When the tyre infl ates to the specifi ed
tyre infl ation pressure, turn the air
compressor switch OFF, turn the sleeve
of the injection hose to the left, and pull
it out of the tyre valve. Turn the sleeve
of the injection hose to the left, and pull
it out of the tyre valve.
15. Remove the compressor hose from the
injection valve of the bottle. After that,
install the injection hose to the injection
valve of the bottle to prevent leakage of
any remaining sealant.
CAUTION
The remaining sealant in the hose may
spray out when the hose is removed.
Remove the hose carefully because you
may not be able to remove the sealant
contacting clothing or other objects.
16. Install the tyre valve cap.
17. Put the puncture tyre repair kit into the
boot/luggage compartment.
18. Start driving immediately to spread the
sealant in the tyre.
CAUTION
Carefully drive the vehicle at a speed of
80 km/h (50 mph) or less. If the vehicle
is driven at a speed of 80 km/h (50 mph)
or more, the vehicle may vibrate.
NOTE
(With Tyre Pressure Monitoring
System)
If the tyre is not properly infl ated, the
tyre pressure monitoring system warning
light will illuminate (page 4-40 ).
19. After driving the vehicle for about 10
minutes or 5 km (3 miles), connect
the air compressor to the tyre using
Step 9 of the procedure, and check the
tyre infl ation pressure using the tyre
pressure gauge on the air compressor. If
the tyre infl ation pressure is lower than
the specifi ed tyre infl ation pressure,
turn the air compressor ON and wait
until it reaches the specifi ed tyre
infl ation pressure.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.7–50
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Seat Belt Warning Beep
Front seat
If the vehicle speed exceeds about 20
km/h (12 mph) with the driver or front
passenger's seat belt unfastened, a warning
beep sounds continuously. If the seat belt
remains unfastened, the beep sound stops
once and then continues for about 90
seconds. The beep stops after the driver or
front passenger's seat belt is fastened.
NOTE
  Some models do not have the seat
belt warning beep for the front
passenger's seat.
  Placing heavy items on the front
passenger seat may cause the front
passenger seat belt warning function
to operate depending on the weight
of the item.
  To allow the front passenger seat
weight sensor to function properly,
do not place and sit on an additional
seat cushion on the front passenger
seat. The sensor may not function
properly because the additional
seat cushion could cause sensor
interference.
  When a small child sits on the front
passenger seat, it is possible that the
warning beep will not operate.
Rear seat
The warning beep only sounds if a seat
belt is unfastened after being fastened.
Ignition Not Switched Off (STOP)
Warning Beep *
If the driver's door is opened while
the ignition is switched to ACC, a
continuous beep sound will be heard to
notify the driver that the ignition has not
been switched off (STOP). Left in this
condition, the keyless entry system will
not operate, the car cannot be locked, and
the battery power will be depleted.
Key Removed from Vehicle
Warning Beep
A beep sound will be heard 6 times and
the KEY warning light (red) will fl ash
continuously if the ignition has not been
switched off, all the doors are closed, and
the key is removed from the vehicle. This
is to notify the driver that the key has been
removed from the vehicle and the ignition
has not been switched off.
NOTE
Because the key utilizes low-intensity
radio waves, the Key Removed From
Vehicle Warning may activate if the key
is carried together with a metal object
or it is placed in a poor signal reception
area.
Request Switch Inoperable
Warning Beep (With the advanced
keyless function)
If the request switch is pressed with a door
open or ajar or the ignition has not been
switched off while the key is being carried,
a beep will be heard for about 2 seconds to
indicate that the doors and the liftgate/boot
lid cannot be locked.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.7–51
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Key Left-in-luggage Compartment
Warning Beep (With the advanced
keyless function)
If the key is left in the boot with all doors
locked and the boot lid closed, a beep
sound is heard for about 10 seconds to
remind the driver the key has been left in
the boot. If this happens, open the boot
lid by pressing the electric boot lid opener
and remove the key. A key removed from
the boot may not function because its
functions may have been temporarily
suspended. To restore the key function,
perform the applicable procedure (page
3-8 ).
Key Left-in-vehicle Warning Beep
(With the advanced keyless
function)
If a key is left in the vehicle cabin and all
the doors and the boot are locked using
a separate key, a beep sound is heard for
about 10 seconds to remind the driver
that the key has been left in the vehicle
cabin. If this happens, open the door and
remove the key. A key removed from the
vehicle this way may not function because
its functions may have been temporarily
suspended. Perform the applicable
procedure to restore the functions of the
key (page 3-8 ).
i-stop Warning Beep
















 If the driver's door is opened while
engine idling is stopped, the warning
sound operates to notify the driver that
engine idling is stopped. It stops when
the driver's door is closed.
 


 The warning sound operates if the
following operations are performed
while the engine idling is stopped. In
such cases, the engine does not restart
automatically to ensure safety. Start the
engine using the normal method.
 

 
(European model)
 The driver's seat belt is unfastened and
the driver's door is opened.
 

 
(Except European model)



 
(Manual transaxle)
 With the shift lever in a position other
than neutral, the driver's seat belt is
unfastened and the driver's door is
opened.
 

 
(Automatic transaxle)
 With the selector lever in the D or
M (not in second gear fi xed mode)
position, the driver's seat belt is
unfastened and the driver's door is
opened.
i-ELOOP Warning Beep *
The beep will activate if you attempt to
drive the vehicle under the following
conditions.
 


 The i-ELOOP indicator light is fl ashing
green.
 


 “i-ELOOP Charging” is indicated in the
centre display (Type C/Type D audio).
The beep will stop when the vehicle is
stopped. Make sure the indicator light is
no longer illuminated and the message
is no longer displayed before driving the
vehicle.
.B[EB@&'&&"@&EJUJPOJOEC







7–54
If Trouble Arises
When Liftgate/Boot Lid Cannot be Opened
When Liftgate/Boot Lid
Cannot be Opened
If the vehicle battery is dead or there is a
malfunction in the electrical system and
the liftgate/boot lid can not be opened,
perform the following procedure as an
emergency measure to Open it:
(Hatchback)
1. Remove the cap on the interior
surface of the liftgate with a fl athead
screwdriver.
Cap
2. Turn the lever to the right to unlock the
liftgate.
Lever
Cap
(Saloon)
1. Open the cover.
2. (European models)
Open the cap.
Cover
Cap
3. (European models)
Turn the screw anticlockwise and
remove it, and then remove the inner
cover.
Screw
.B[EB@&'&&"@&EJUJPOJOEC







7–55
If Trouble Arises
When Liftgate/Boot Lid Cannot be Opened
4. Move the lever to the left to fold the
seatback.
Cover
Lever
5. Move the lever to the left to open the
boot lid.
After performing this emergency measure,
have the vehicle inspected at an expert
repairer, we recommend an Authorised
Mazda Repairer as soon as possible.
.B[EB@&'&&"@&EJUJPOJOEC







8–20
Customer Information
Electromagnetic Compatibility
Aerial positions:
: front right of roof
: front left of roof
: centre of roof
: both sides of liftgate (Hatchback)
: both sides of boot lid (Saloon)
Frequency Band (MHz) Maximum output power (Wattage) Aerial Positions
50 — 54 50
68 — 87.5 50
142 — 176 50
380 — 470 50
806 — 940 10
1200 — 1300 10
1710 — 1885 10
1885 — 2025 10
2400 — 2500 0.01 *1 In a cabin *1
*1 Only for Bluetooth ®
NOTE
After the installation of RF transmitters, check for disturbances from and to all electrical
equipment in the vehicle, both in the standby and transmit modes.
Check all electrical equipment:
 
 with the ignition ON 
 with the engine running 
 during a road test at various speeds.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.9–13
Specifi cations
Specifi cations
Interior light
Light bulb Category
Wattage UNECE *1
Boot light (Saloon) 3 —
Luggage compartment light (Hatchback) 5 —
Overhead lights (Front)/Map lights
* 8 —
Overhead light (Front) * 10 —
Overhead light (Rear) * 10 —
Vanity mirror lights * 2 —
*1 UNECE stands for United Nations Economic Commission for Europe.
Ty r e s
Sample tyre mark and its meaning
Nominal section width
Nominal aspect ratio in %
Construction codeMud and snow
Speed symbol
Load index (not on ZR tyres)
Nominal rim diameter in inches
Tyre mark information
Choose the proper tyres for your vehicle using the following tyre mark information.
Speed symbol Maximum permissible speed
Q Up to 160 km/h (99 mph)
R Up to 170 km/h (105 mph)
S Up to 180 km/h (111 mph)
T Up to 190 km/h (118 mph)
U Up to 200 km/h (124 mph)
H Up to 210 km/h (130 mph)
V Up to 240 km/h (149 mph)
W Up to 270 km/h (167 mph)
Y Up to 300 km/h (186 mph)
ZR Over 240 km/h (149 mph)
.B[EB@&'&&"@&EJUJPOJOEC