2015 MAZDA MODEL 3 HATCHBACK ECU

2–29
Essential Safety Equipment
Child Restraint
Rear-facing type
WARNING
Always install a rear-facing child seat
in the correct seat position:
Installing a rear-facing child seat
without fi rst consulting the table
“Child-Restraint System Suitability for
Various Seat Positions” is dangerous.
A rear-facing child seat installed on the
wrong seat position cannot be properly
secured. In a collision, the child could
hit something or someone in the vehicle
and be seriously injured or even killed.
Never use a rear-facing child-restraint
system on the front passenger seat
protected by an air bag:
NEVER use a rearward facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it,
DEATH or SERIOUS INJURY to the
CHILD can occur.
The child-restraint system can be hit
by the deploying air bag and knocked
out of position. A child in the child-
restraint system could be seriously
injured or killed. If your vehicle is
equipped with a front passenger air
bag deactivation switch, always set the
switch to the OFF position if installing
a rear-facing child-restraint system on
the front passenger seat is unavoidable.
Front-facing type
WARNING
Never install a front-facing child seat
in the wrong seat position:
Installing a front-facing child seat
without fi rst consulting the table
“Child-Restraint System Suitability for
Various Seat Positions” is dangerous. A
front-facing child seat installed in the
wrong seat position cannot be properly
secured. In a collision, the child could
hit something or someone in the vehicle
and be seriously injured or even killed.
Do not install a front-facing child-
restraint system on the front passenger
seat unless it is unavoidable:
In a collision, the force of a deploying
air bag could cause serious injury or
death to the child. If installing a front-
facing child-restraint system on the
front passenger seat is unavoidable,
move the front passenger seat as far
back as possible and make sure that the
front passenger air bag deactivation
switch is in the OFF position. Refer to
Front Passenger Air Bag Deactivation
Switch (page 2-44 ).
.B[EB@&'&&"@&EJUJPOJOEC







2–30
Essential Safety Equipment
Child Restraint
Junior Seat Installation Position
A junior seat is used in the front-facing
position only.
Refer to the table, “Child-Restraint System
Suitability for Various Seat Positions”
for junior seat installation position (page
2-31 ).
WARNING
Always install a junior seat in the
correct seat position:
Installing a junior seat without fi rst
consulting the table “Child-Restraint
System Suitability for Various Seat
Positions” is dangerous. A junior seat
installed on the wrong seat position
cannot be properly secured. In a
collision, the child could hit something
or someone in the vehicle and be
seriously injured or even killed.
WARNING
Do not install a front-facing child-
restraint system on the front passenger
seat unless it is unavoidable:
In a collision, the force of a deploying
air bag could cause serious injury or
death to the child. If installing a front-
facing child-restraint system on the
front passenger seat is unavoidable,
move the front passenger seat as far
back as possible and make sure that the
front passenger air bag deactivation
switch is in the OFF position. Refer to
Front Passenger Air Bag Deactivation
Switch (page 2-44 ).
.B[EB@&'&&"@&EJUJPOJOEC







2–31
Essential Safety Equipment
Child Restraint
Child-Restraint System Suitability for Various Seat
Positions Table
(Europe and countries conforming to the UNECE 16 regulation)
Provided information in the table shows your child-restraint system suitability for various
seating position. For installation suitability of other manufacturer child-restraint system,
carefully consult the manufacturer's instructions which accompany the child-restraint
system.
ISOFIX anchor-secured child-restraint systems
Mass group Size
Class Fixture Seat Positions
Vehicle ISOFIX
positions
Rear seat (centre) Front passenger
seat (outboard)
Rear seat
(outboard)
Carrycot F ISO/L1 X X X
G ISO/L2 X X X
(1) X X X
GROUP 0 Up to 10
kg (less than 22 lb) E ISO/R1 IL X X
(1) X X X
GROUP 0
Up to
13 kg (less than 29
lb) E ISO/R1 IL X X
D ISO/R2 IL X X
C ISO/R3 IL X X
(1) X X X
GROUP 1 9 kg — 18
kg (20 lb — 40 lb) D ISO/R2 IL X X
C ISO/R3 IL X X
B ISO/F2 IUF X X
B1 ISO/F2X IUF X X
A ISO/F3 IUF X X
(1) X X X
GROUP 2 15 kg —
25 kg (33 lb — 55
lb) (1) X X X
GROUP 3 22 kg —
36 kg (48 lb — 79
lb) (1) X X X
(1) For the CRS which do not carry the ISO/XX size class identifi cation (A to G), for the applicable mass group,
the car manufacturer shall indicate the vehicle specifi c ISOFIX child-restraint system(s) recommended for each
position.
Key of letters to be inserted in the above table:
IUF = suitable for ISOFIX forward child-restraints systems of universal category approved for use in this mass
group.
IL = suitable for particular ISOFIX child-restraint systems (CRS).
These ISOFIX CRS are those of the “specifi c vehicle”, “restricted” or “semi-universal” categories.
.B[EB@&'&&"@&EJUJPOJOEC







2–32
Essential Safety Equipment
Child Restraint
A Mazda genuine child-restraint system can be installed. Regarding child-restraint systems which can be installed,
refer to the accessories catalog.
(Except Europe)
Regarding child-restraint systems which can be installed to your Mazda, consult an expert repairer, we recommend
an Authorised Mazda Repairer.
X = ISOFIX position not suitable for ISOFIX child-restraint systems in this mass group and/or this size class.
NOTE
When installing a child-restraint system to the rear seat, adjust the front seat position so
that the front seat does not contact the child-restraint system. Refer to Seat Operation on
page 2-5 .
Except ISOFIX anchor-secured child-restraint systems
System
group Age group Weight
group Child-
restraint
system type Front passenger seat Rear seat
(outboard) Rear
seat
(centre) Without
air bag
deactivation
switch
With air bag
deactivation
switch
ON
(Air bag
enabled) OFF
(Air bag
disabled)
GROUP 0 Up to
approximately
9 months old Less than 10
kg (less than
22 lb) Baby seat X X L U L *1
GROUP 0 Up to
approximately
2 years old Less than 13
kg (less than
29 lb) Baby seat X X L U L *1
GROUP 1 Approximately
8 months to 4
years old 9 kg — 18 kg
(20 lb — 40
lb) Child seat L *2 L *2 L *2 U X
GROUP 2
Approximately
3 to 7 years old 15 kg — 25
kg (33 lb —
55 lb) Junior seat L *2 L *2 L *2 U X
GROUP 3
Approximately
6 to 12 years
old 22 kg — 36
kg (48 lb —
79 lb) Junior seat L *2 L *2 L *2 U X
Key of letters to be inserted in the above table:
U = Suitable for “universal” category restraints approved for use in this mass group.
L = A Mazda genuine child-restraint system can be installed. Regarding child-restraint systems which can be
installed, refer to the accessories catalog.
(Except Europe)
Regarding child-restraint systems which can be installed to your Mazda, consult an expert repairer, we recommend
an Authorised Mazda Repairer.
X = Seat position not suitable for children in this mass group.
*1 When a child-restraint system is installed to the rear centre seat, do not seat occupants in the rear right outboard
seat position.
.B[EB@&'&&"@&EJUJPOJOEC







2–33
Essential Safety Equipment
Child Restraint
*2 When installing a child-restraint system to the front passenger seat, adjust the seat slide position as far back as
possible. Adjust the seat bottom to the highest position so that the seat belt can securely fasten the child-restraint
system.
Refer to Seat Operation on page 2-5 .
NOTE
When installing a child-restraint system, the following points must be observed:
 
 If the child-restraint system does not fi t into the seatback because of the head restraint,
adjust the head restraint height or remove the head restraint so that the child-restraint
system fi ts into the seatback.
 Refer to Head Restraints on page 2-11 . 
 When installing a child-restraint system to the rear seat, adjust the front seat position
so that the front seat does not contact the child-restraint system.
 Refer to Seat Operation 2-5 .
(Other countries)
Please comply with the legal regulations concerning the use of child-restraint systems in
your country.
.B[EB@&'&&"@&EJUJPOJOEC







2–34
Essential Safety Equipment
Child Restraint
Installing Child-Restraint
Systems
Anchor Bracket
Anchor brackets for securing child-
restraint systems are equipped in the
vehicle. Locate each anchor position using
the illustration.
To install a child-restraint system, if the
seat is equipped with a head restraint,
remove it. Always follow the instruction
manual accompanying the child-restraint
system.
Anchor bracket location
Use the indicated anchor bracket locations
when installing a child-restraint system
equipped with a tether.
Anchor bracketFor right
For left For centre
(Saloon)
(Hatchback)
For left
For right
WARNING
Always attach the tether strap to the
correct tether anchor position:
Attaching the tether strap to the
incorrect tether anchor position is
dangerous. In a collision, the tether
strap could come off and loosen the
child-restraint system. If the child-
restraint system moves it could result in
death or injury to the child.
.B[EB@&'&&"@&EJUJPOJOEC







2–36
Essential Safety Equipment
Child Restraint
Using ISOFIX Anchor
WARNING
Follow the manufacturer's instructions
for the use of the child-restraint
system:
An unsecured child-restraint system
is dangerous. In a sudden stop or a
collision it could move causing serious
injury or death to the child or other
occupants. Make sure any child-
restraint system is properly secured in
place according to the manufacturer's
instructions.
Make sure the child-restraint system is
properly secured:
A child-restraint system that is not
secured is dangerous. In a sudden stop
or collision, it can become a projectile
and hit someone, causing serious
injury. When not in use, remove it
from the vehicle, put it in the luggage
compartment or at least make sure
it is securely fastened to the ISOFIX
anchors.
WARNING
Make sure there are no seat belts or
foreign objects near or around the
ISOFIX anchor-secured child-restraint
system:
Not following the child-restraint system
manufacturer's instructions when
installing the child-restraint system is
dangerous. If seat belts or a foreign
object prevent the child-restraint
system from being securely attached
to the ISOFIX anchors and the child-
restraint system is installed improperly,
the child-restraint system could move
in a sudden stop or collision causing
serious injury or death to the child or
other occupants. When installing the
child-restraint system, make sure there
are no seat belts or foreign objects
near or around the ISOFIX anchors.
Always follow the child-restraint system
manufacturer's instructions.
1. First, adjust the front seat to allow
clearance between the child-restraint
system and the front seat (page 2-5 ).
2. Make sure the seatback is securely
latched by pushing it back until it is
fully locked.
.B[EB@&'&&"@&EJUJPOJOEC







2–37
Essential Safety Equipment
Child Restraint
3. Expand the area between the seat
bottom and the seatback slightly to
verify the locations of the ISOFIX
anchor.
NOTE
The markings above the ISOFIX
anchors indicate the locations of the
ISOFIX anchors for the attachment of a
child-restraint system.
4. Raise the head restraint to the top
locked position.
Refer to Head Restraints on page 2-11 .
5. Secure the child-restraint system using
the ISOFIX anchor, following the
child-restraint system manufacturer's
instruction.
6. If your child-restraint system came
equipped with a tether, that probably
means it is very important to properly
secure the tether for child safety. Please
carefully follow the child-restraint
system manufacturer's instructions
when installing tethers (page 2-34 ).
WARNING
Always attach the tether strap to the
correct tether anchor position:
Attaching the tether strap to the
incorrect tether anchor position is
dangerous. In a collision, the tether
strap could come off and loosen the
child-restraint system. If the child-
restraint system moves it could result in
death or injury to the child.
Always remove the head restraint and
set the tether strap:
Routing the tether strap on top of
the head restraint is dangerous. In a
collision the tether strap could slide off
the head restraint and loosen the child-
restraint system. The child-restraint
system could move which may result in
death or injury to the child.
Anchor bracket
Tether strap(Saloon)
.B[EB@&'&&"@&EJUJPOJOEC