2015 LEXUS LX570 ECO mode

1391-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Deactivating the curtain shield airbags in a vehicle rollover
ON/OFF (hold for a few seconds) The RSCA OFF indicator turns on
(only when the “ENGINE START
STOP” switch is in IGNITION ON
mode.)
The roll sensing function for the
curtain shield airbags and seat belt
pretensioners will turn back on
automatically each time the
“ENGINE START STOP” switch is
turned to IGNITION ON mode.■
This switch only should be used
In a situation where the inflation is not desired (such as during extreme off road
driving). ■
Operating conditions when the RSCA OFF indicator is on ●
The curtain shield airbag and seat belt pr etensioner will not activate in a vehicle
rollover. ●
The curtain shield airbag will activate in a severe side impact. ●
The pretensioner will activate in a severe frontal collision.
CAUTION■
While normal driving
Make sure the RSCA OFF indicator is not turned on. If it is left on, the curtain shield
airbag will not activate in th e event of an accident, which may result in death or seri-
ous injury.

1551-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the sh oulder belt and
then allow it to retract slightly in
order to activate the ALR lock
mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system down into th e second seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended. STEP 4
STEP 5

1571-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the shoulder strap
and then allow it to retract slightly
into the ALR lock mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system into the second seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
If the child restraint system has a top tether strap, the top tether
strap should be latched onto the top tether strap anchor.
(  P. 152) STEP 4
STEP 5
STEP 6

1611-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) ■
Laws and regulations pertaining to Anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to the SAE J1819.
CAUTION■
When installing a booster seat
Do not fully extend the shoulder belt to prevent the belt from going to ALR lock
mode: (  P. 95)
ALR mode causes the belt to tighten only which could cause injury or discomfort to
the child. ■
When installing a child restraint system
Follow the directions given in the child restraint system installation manual and fix
the child restraint syst em securely in place.
If the child restraint system is not correctly fixed in place, the child or other passen-
gers may be seriously injured or even kill ed in the event of sudden braking, sudden
swerving or an accident. ●
If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child
restraint system to the right-hand second
seat. ●
Child restraint system installed on the third
seat should not contact the second seat-

1672-1. Driving procedures
2
When driving
LX570_OM_OM60L96U_(U) Starting on a steep uphill
Firmly set the parking brake and shift the shift lever to “D”.
Gently depress the accelerator pedal.
Release the parking brake.■
Driving in the rain ●
Drive carefully when it is raining, becaus e visibility will be reduced, the windows
may become fogged-up, and th e road will be slippery.●
Drive carefully when it starts to rain, because the road surface will be especially
slippery. ●
Refrain from high speeds when driving on an expressway in the rain, because
there may be a layer of water between the tires and the road surface, prevent-
ing the steering and brakes from operating properly.■
Engine speed while driving
In the following conditions, the engine speed may become high while driving. This is
due to automatic up-shifting control or do wn-shifting implementation to meet driv-
ing conditions. It does not indicate sudden acceleration.●
The vehicle is judged to be driving uphill or downhill ●
When the accelerator pedal is released ●
When the brake pedal is depressed while power mode is selected (  P. 183)■
Breaking in your new Lexus
To extend the life of the vehicle, the following precautions are recommended to
observe: ●
For the first 200 miles (300 km):
Avoid sudden stops. ●
For the first 500 miles (800 km):
Do not tow a trailer. ●
For the first 1000 miles (1600 km):
• Do not drive at extremely high speeds.
• Avoid sudden acceleration.
• Do not drive continuously in the low gears.
• Do not drive at a constant speed for extended periods. STEP 1
STEP 2
STEP 3

1682-1. Driving procedures
LX570_OM_OM60L96U_(U) ■
Drum-in-disc type parking brake system
Your vehicle has a drum-in-disc type park ing brake system. This type of brake sys-
tem needs bedding-down of the brake shoe s periodically or whenever the parking
brake shoes and/or drum are replaced. Ha ve your Lexus dealer perform the bed-
ding down operation. ■
Operating your vehicle in a foreign country
Comply with the relevant vehicle registration laws and confirm the availability of the
correct fuel. (  P. 888)■
Eco Driving Indicator
Eco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), Eco Driving Indicator Light will
turn on.
Eco Driving Indicator Zone Display
Suggests Zone of Eco driving with current
Eco driving ratio based on acceleration.
Zone of Eco driving
Eco driving ratio based on acceleration
If the vehicle exceeds Zone of Eco driving,
the right side of Eco Driving Indicator
Zone Display will blink and Eco Driving
Indicator Light will turn off.
Eco Driving Indicator Light will not operate in
the following conditions: ●
The shift lever is in anything other than
“D”. ●
The paddle shift switch (if equipped) is
operating. ●
The vehicle is set to second start mode or
power mode. (  P. 183)●
The vehicle speed is approximately 81 mph
(130 km/h) or higher. ●
The Crawl Control is operating. (  P.
337)

1772-1. Driving procedures
2
When driving
LX570_OM_OM60L96U_(U) Engine (ignition) switch Performing the following operations when carrying the electronic key on
your person starts the engine or changes “ENGINE START STOP” switch
modes.
■ Starting the engine
Check that the parking brake is set.
Check that the shift lever is set in “P”.
Sit in the driver’s seat and firmly depress the brake pedal. The “ENGINE START STOP” switch indicator turns green.
Press the “ENGINE START
STOP” switch. The engine can be started from
any “ENGINE START STOP”
switch mode.
Continue depressing the brake
pedal until the engine is com-
pletely started. The engine will
crank until it starts or for up to
30 seconds, whichever is less.STEP 1
STEP 2
STEP 3
STEP 4

1802-1. Driving procedures
LX570_OM_OM60L96U_(U) ■
Note for the entry function
 P. 43
CAUTION■
When starting the engine
Always start the engine while sitting in th e driver’s seat. Do not depress the acceler-
ator while starting the engi ne under any circumstances.
Doing so may cause an accident resulting in death or serious injury. ■
Stopping the engine in an emergency
If you want to stop the engine in an emergency while driving the vehicle, press and
hold the “ENGINE START STOP” switch fo r more than 2 seconds, or press it
briefly 3 times or more in succession. (  P. 883)
However, do not touch the “ENGINE START STOP” switch while driving except in
an emergency. Turning the engine off while driving will not cause loss of steering or
braking control, but the power assist to these systems will be lost. This will make it
more difficult to steer and brake, so you should pull over and stop the vehicle as
soon as it is safe to do so.
NOTICE■
To prevent battery discharge
Do not leave the “ENGINE START STOP ” switch in ACCESSORY or IGNITION
ON mode for long periods of ti me without the engine running.■
When starting the engine ●
Do not race a cold engine. ●
If the engine becomes difficult to start or stalls frequently, have your vehicle
checked by your Lexus dealer immediately.■
Symptoms indicating a malfunction with the “ENGINE START STOP” switch
If the “ENGINE START STOP” switch seem s to be operating somewhat differently
than usual, such as the swit ch sticking slightly, there may be a malfunction. Contact
your Lexus dealer immediately.