SPORTAGE FEATURES & FUNCTIONS GUIDE30*IF EQUIPPED
OTHER KEY FEATURES
How to Sync Transmitter with HomeLink®*
Erasing programmed buttons:
If programming for the rst time, begin with Step 1 (repeating this step will
delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the left
A and center D buttons simultaneously until the
indicator light C begins to ash (to reprogram buttons, skip this step)
2. Press and hold the desired button
A B D and hold the button on the
transmitter while it is approximately 1 to 3 inches away from the mirror. The
HomeLink
® Indicator light C will ash rapidly once the frequency signal has
been successfully programmed
To nish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink
® button up to three times
Press and hold the left
A and center D buttons simultaneously for
approximately 20 seconds, and then release both buttons within 30 seconds. Operating HomeLink
®:
Press one of the programmed HomeLink® buttons .
REMINDER: Mirror indicator light C will illuminate when automatic dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program
your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more
information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink® / Auto-Dimming Rearview Mirror* is designed to
reduce glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters into one location.
To turn automatic dimming ON, press
button F
To turn automatic dimming OFF, press
button G
HomeLink® with Auto-Dimming
Rearview Mirror*
A HomeLink® button
B HomeLink® button
C Indicator light
D HomeLink® button
E Glare detection sensor
F Automatic dimming ON
G Automatic dimming OFF
You can reprogram a single HomeLink® button by repeating Step 2
Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
ABCDEFG
