SPORTAGE FEATURES & FUNCTIONS GUIDE22*IF EQUIPPED
\fENTER PANEL
Manual \flimate \fontrol*
Defrost Outside Windshield:
1. Set Fan Speed to the highest position
2. Set Temperature to Hot
3. Press the Front Defrost button
Defog Inside Windshield:
1. Set Fan Speed to desired position
2. Set Temperature to desired position
3. Press the Front Defrost button
REMINDERS:
Your Manual Climate Control system may differ from those in the illustrations. See your Owner’s Manual for more details
Warm air may ow in through vents if Recirculated Air button is not pressed ON (LED lit)
Air Flow Modes
To select Air Flow modes, press
the Mode selection buttons:
Face-Level
Bi-Level
F lo o r- L evel
Floor/Defrost-Level
Fan speed control knob
Front windshield defroster button
Air conditioning ON/OFF button*
Recirculated/fresh air button
Rear window defroster button
Temperature control knob
Air flow mode buttons
Defrost mode activates A /C and opens Fresh Air vent to help dehumidify the air and improve Defroster performanceMA X A /C mode automatically engages Recirculated AirKeep inside glass as clean as possible to reduce window fogging
QUICK TIPS
SPORTAGE FEATURES & FUNCTIONS GUIDE30*IF EQUIPPED
OTHER KEY FEATURES
How to Sync Transmitter with HomeLink®*
Erasing programmed buttons:
If programming for the rst time, begin with Step 1 (repeating this step will
delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the left
A and center D buttons simultaneously until the
indicator light C begins to ash (to reprogram buttons, skip this step)
2. Press and hold the desired button
A B D and hold the button on the
transmitter while it is approximately 1 to 3 inches away from the mirror. The
HomeLink
® Indicator light C will ash rapidly once the frequency signal has
been successfully programmed
To nish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink
® button up to three times
Press and hold the left
A and center D buttons simultaneously for
approximately 20 seconds, and then release both buttons within 30 seconds. Operating HomeLink
®:
Press one of the programmed HomeLink® buttons .
REMINDER: Mirror indicator light C will illuminate when automatic dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program
your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more
information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink® / Auto-Dimming Rearview Mirror* is designed to
reduce glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters into one location.
To turn automatic dimming ON, press
button F
To turn automatic dimming OFF, press
button G
HomeLink® with Auto-Dimming
Rearview Mirror*
A HomeLink® button
B HomeLink® button
C Indicator light
D HomeLink® button
E Glare detection sensor
F Automatic dimming ON
G Automatic dimming OFF
You can reprogram a single HomeLink® button by repeating Step 2
Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
ABCDEFG
