Bulbs, Light.............................313
Camera, Rear............................375
Capacities, Fluid..........................592
Caps, Filler
Oil (Engine)...........................531
Carbon Monoxide Warning..................310
Car Washes.............................553
Cellular Phone...........................637
Certification Label.........................400
Changing A Flat Tire.......................476
Chart, Tire Sizing.........................562
Check Engine Light (Malfunction Indicator Light) . .513
Checking Your Vehicle For Safety..............309
Checks, Safety...........................309
Child Restraint...........................287
Child Restraints
Booster Seats..........................293
Child Restraints........................287
Child Seat Installation....................306
How To Stow An Unused ALR Seat Belt.......302
Infants And Child Restraints...............290
Install A LATCH-compatible Child Restraint . . . .301
Installing Child Restraints Using The Vehicle Seat
Belt.................................303
LATCH Positions.......................296
Locating The LATCH Anchorages............299
Lower Anchors And Tethers For Children......295
Older Children And Child Restraints.........291
Seating Positions........................294
Child Safety Locks.........................64
Clean Air Gasoline........................389
Cleaning
Wheels...............................555
Windshield Wiper Blades..................536
Climate Control..........................113
Automatic............................119
Manual..............................113
660 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
