2015 INFINITI Q60 COUPE steering

10
111213
15
16
17
18
19
20
212122
1
3456
2
*See your Owner’s Manual for information.
1 INSTRUMENT BRIGHTNESS CONTROL*
2 TRIP COMPUTER SWITCHES
3 HEADLIGHT AND TURN SIGNAL CONTROL
4 LOW TIRE PRESSURE WARNING LIGHT
5 VEHICLE INFORMATION DISPLAY
6 WINDSHIELD WIPER AND WASHER SWITCH
7 TRIP A/B RESET BUTTON*
8 STEERING WHEEL SWITCHES FOR
AUDIO*/BLUETOOTH®
9 CRUISE CONTROL
10 PUSH BUTTON IGNITION SWITCH
11 VEHICLE DYNAMIC CONTROL (VDC) OFF SWITCH*
12 TRUNK RELEASE SWITCH
13 REAR SONAR SYSTEM SWITCH*
14 TILT AND TELESCOPIC STEERING COLUMN*
15 INTELLIGENT KEY PORT
16 HOOD RELEASE*
17 CONTROL PANEL DISPLAY
18 AUDIO SYSTEM
19 AUTOMATIC CLIMATE CONTROLS
20 FRONT PASSENGER AIR BAG STATUS LIGHT*
21 CLIMATE CONTROLLED SEAT SWITCHES*
22 HARD TOP OPEN/CLOSE SWITCH
(CONVERTIBLE MODELS)
Behind
steering wheel Behind
steering wheel
Behind
steering wheel
89
7
Behind
steering wheel14
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 39/15/14 1:25 PM

7
1
Trunk Lid Release
Use one of the following methods to open the trunk:
Push the trunk open request switch 1 for more



than one second while carrying the INFINITI




Intelligent Key with you.


Press the trunk button HOLD on the Intelligent Key for
more than one second.

Push down on the trunk lid release switch 2

located on the instrument panel to the left of the





steering wheel.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
Seat Adjustments
To slide the seat forward or backward, push the
control switch
1 forward or backward.
To recline the seatback, push the switch
2
forward or backward.
SEAT LIFTER
To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch

4 up or down.
POWER LUMBAR SUPPORT (driver’s seat)

To adjust the seat lumbar support, push the front or back end of the swi\
tch 3.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (sectio\
n 1) ” of your
Owner’s Manual.
2
123
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 79/15/14 1:26 PM

8
first drive features
Seat Belt Guide (Convertible models)
Unsnap the seat belt guide 1 to allow rear seat



passengers easier access.
Before fastening the seat belt, make sure the seat
belt is inserted into the seat belt guide and the
snaps are securely fastened.
When using the seat belt guide, do not allow the
seat belt to twist so that it will retract correctly.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)”\
of your
Owner’s Manual.
Automatic Drive Positioner (if so equipped)
Two positions for the driver’s seat, steering column and outside mirr\
ors can be stored in the
automatic drive positioner memory.
Follow this procedure to set the memory positions:



•

Confirm the shift lever is in the
P (PARK) position
(automatic transmission) or the parking brake is
applied (manual transmission).
•


Push the ignition switch to the
ON position.



•

Adjust the driver’s seat, steering column and outside mirrors to the \
desired positions using
the adjusting switches for each feature.



•

Push the
SET switch and within 5 seconds, push the memory switch (1 or 2) for at least 1 second.



•

The indicator light on the memory switch you select will illuminate for \
approximately 5 seconds.




•

The driver’s seat, steering column and outside mirror positions are n\
ow set to your preference.
These memorized positions can also be linked to your INFINITI Intelligen\
t Key. To link a
memorized position to your INFINITI Intelligent Key, press the UNLOCK button on the key fob
after completing the previous step.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Passenger Rear Seat Entry/Exit
For ease in entering and exiting the rear passenger
areas of the vehicle, perform the following steps:



1.

Release the front seat belt guide and seat belt

(Convertible models).



2.

Pull the seatback lever 1 upward to fold the
front seatback forward. Make sure that the front
seatback is completely folded.



3.


To slide the front seat forward, firmly push

the seatback button
2. The front seat will
move forward.Coupe
Convertible
1
12
21
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 89/15/14 1:26 PM

18
system guide
For vehicles equipped with Navigation:



•



Refer to “Voice recognition (section 9)” of your
Navigation System Owner’s Manual for more
information.
The “Help” command can be used to hear a list of
available commands at any time.
Reduce background noise as much as possible by closing
windows and pointing HVAC vents away from the ceiling.
Say commands after the tone or press the or button to say a command at any time.
Speak naturally without long pauses and without raising your voice.
When speaking Phonebook names, please be aware some phones require the l\
ast name
to be spoken before the first name. For example, “Michael Smith” m\
ay be spoken as
“Smith Michael”.
To cancel a Voice Recognition session, simply wait 5 seconds, say “Ca\
ncel” or “Quit”, or
press and hold the
button for 5 seconds.
If the Voice Recognition system does not recognize your voice commands, \
train the system
using the Speaker Adaptation Mode. See your Owner’s Manual for detail\
ed information.
For more detailed information and instructions, refer to your cellular p\
hone’s Owner’s
Manual and visit
www.InfinitiUSA.com/bluetooth.
Bluetooth® System with Navigation (if so equipped)
CONNECTING PROCEDURE
The vehicle must be stationary when connecting
the phone.







1.
Press the

PHONE button on the instrument panel or
the
button on the steering wheel and select the
“Connect Phone” key.
2.


Initiate connecting from the phone.
• The connecting procedure varies according to each


cellular phone model. For detailed connecting
instructions and a list of compatible phones, please
visit www.InfinitiUSA.com/bluetooth.
• When prompted for a PIN code, enter “1234” from


the handset. (The PIN code is assigned by INFINITI
and cannot be changed.)


3.

When connecting is complete, the screen will return


to the “Phone” menu.
Microphone
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 189/15/14 1:27 PM

19
PHONEBOOK SETUP

Depending on your cellular phone, the system may automatically download \
your cellular
phone’s entire phonebook to the vehicle’s Bluetooth® system.
If the phonebook does not download automatically, the vehicle phonebook \
may be set for
up to 40 entries.
To manually download entries:



1.
Press the
button and select the “Quick Dial” key.



2.


Select the “Add New” key at the top of the display.

There are different methods to input a phone
number. Select one of the following options:



•


“Copy from Call History” to save a number from

the Outgoing, Incoming or Missed Calls lists.



•


“Copy from the Phonebook” to save a number

that has been downloaded from your handset to
the vehicle.



•


“Enter Number by Keypad” to input the number

and name manually.
MAKING A CALL
To make a call, follow this procedure:


1.

Press the
button on the steering wheel. The “Phone”
menu will appear on the control panel display.


2.

Select the “Quick Dial”

, “Call History”, “Phonebook”
or “Dial Number” key.
3.


Select the desired entry from the list.
4.


Select “Call” to start dialing the number.
RECEIVING/ENDING A CALL
To accept the call, press the button on the
steering wheel or touch the “Answer” key.
To reject the call, touch the “Reject Call” key.
To hang-up, press the button or touch the “Hang
Up” key.
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 199/15/14 1:28 PM

20
system guide
Bluetooth® System without Navigation (if so equipped)
PAIRING PROCEDURE

1.
Press the
button on the steering wheel. The
system announces the available commands.
2.


Say “Connect Phone”. The system acknowledges

the command and announces the next set of
available commands.
3.


Say “Add Phone”. The system acknowledges the

command and asks you to initiate connecting from
the phone handset.


4.

Initiate pairing from the phone.



•


The connecting procedure varies according to each cellular phone model. \

For detailed connecting instructions and a list of compatible phones,
please visit

www.InfinitiUSA.com/bluetooth.



•


When prompted for a PIN code, enter “1234” from the handset. (The\
PIN code
is assigned by INFINITI and cannot be changed.)
5.


Say the name of the phone when the system asks you to provide one. You c\
an give the
phone a name of your choice.
PHONEBOOK REGISTRATION
When the cellular phone is connected to the in-vehicle module, the data \
stored in the
cellular phone, such as phonebook, outgoing call logs, incoming call log\
s and missed call
logs, is automatically transferred and registered to the system.
The availability of this function depends on each cellular phone. The co\
pying procedure
also varies according to each cellular phone. See your cellular phone’\
s Owner’s Manual for
more information.
Up to 1,000 entries per registered cellular phone can be stored in the p\
honebook.
MAKING A CALL
1.


Press the button on the steering wheel. A tone will sound.
2.


Say “Call”. The system acknowledges the command and announces the \
next set of
available commands.
3.


Say the registered person’s name. The system acknowledges the command\
and
announces the next set of available commands.
4.


Say “Yes”. The system acknowledges the command and makes the call.\
RECEIVING/ENDING A CALL
To accept the call, press the
button on the steering wheel.
To reject the call, press the button.
To hang-up, press the button.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)”
of your Owner’s
Manual or please visit www.InfinitiUSA.com/bluetooth.
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 209/15/14 1:28 PM