2015 HYUNDAI I20 lock

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
FFront lamps(1) Front Map Lamp
(2) Front Room LampFront Map Lamp:Press either the right or left lens to
turn the map lamp on or off. This light
produces a spot beam for convenient
use as a map lamp at night or as a
personal lamp for the driver and the
front passenger.
Front Room Lamp:The Front Room Lamp Switch acti-
vates the front and rear room lamps
when the switch is pressed in either of
the three positions indicated below:
: The front or rear room lampscome on when the front or
rear doors are opened if the
engine is running or not. When
doors are unlocked by the
remote key or smart key, the
front and rear lamps come on
for approximately 15 seconds
as long as any door is not
opened. The front and rear
room lamps go out gradually
after approximately 15 sec-
onds if the door is closed.
However, if the ignition switch
is in the ON position or all
doors are locked, the front and
rear lamps will turn off imme-
diately. If a door is opened with
the ignition switch in the ACC
position or the LOCK/OFF
position, the front and rear
lamps stay on for about 20
minutes. However, if a door is
opened with the ignition switch
in the ON position, the lamps
stays on continuously. : With the Front Room Lamp in
this position, the front and
rear room lamps remain on
at all times.
: With the Front Room Lamp in this position the front and
rear room lamps remain off
at all times.
Information
When the map lamp (1) is turned ON
by pressing the lens, the map lamp
will not turn off even if the front room
lamp switch is in the OFF position.i
OIB044015

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3Types of warning indicator and
sound
••If an object is in between sensors
or close to a sensor, the displayed
indicator may differ from the above
illustration.
• Do not wash the vehicle's sensor with high pressure water.
• When you shift into the R (Reverse) position and one or
more of the below situation occurs,
this may indicate a malfunction
with the parking assist system.
• You don't hear an audible warning sound or the buzzer sounds inter-
mittently.
If this occurs, we recommend that
the system be checked by an
authorized HYUNDAI dealer.
Non-operational conditions of Parking Distance Warning(Reverse) SystemThe Parking Distance Warning
(Reverse) System may not operate
normally when:• Moisture is frozen to the sensor.
• The sensor is covered or stained
with foreign material, such as snow
or water, or the sensor cover is
blocked.There is a possibility of a parking
assist system malfunction when:• Driving on uneven road surfacessuch as unpaved roads, gravel,
bumps, or gradient.
• Objects generating excessive noise such as vehicle horns, loud motor-
cycle engines, or truck air brakes
can interfere with the sensor.
• Heavy rain or water spray is present.
• Wireless transmitters or mobile phones are present near the sensor.
• The sensor is covered with snow.
• Any non-factory equipment or accessories have been installed, or
if the vehicle bumper height or sen-
sor installation has been modified.
NOTICE
Distance from
object
Warning
indicator
Warning sound
120cm ~ 61cm
(47 in. ~ 24 in.)
Buzzer beeps
intermittently.
60cm ~ 31cm
(24 in. ~ 12 in.)
Buzzer beeps
more frequently.
Less than
30 cm (12 in.)
Buzzer beeps continuously.
• is displayed. (if equipped)

)' #10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3SSunglass holder (if equipped)To open the sunglass holder, press
the cover and the holder will slowly
open. Place your sunglasses in the
compartment door with the lenses
facing out.
To close the sunglass holder, push
back into position. Make sure the sun-
glass holder is closed while driving.
OIB044023
•
Do not keep objects except sun-
glasses inside the sunglass
holder. Such objects can be
thrown from the holder in the
event of a sudden stop or an
accident, possibly injuring the
passengers in the vehicle.
•
Do not open the sunglass holder
while the vehicle is moving. The
rear view mirror of the vehicle
can be blocked by an open sun-
glass holder.
•
Do not put the glasses forcibly
into a sunglass holder. It may
cause personal injury if you try to
open it forcibly when the glasses
are jammed in holder.
WARNING

)' 
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
''#)+*'&*+$)"*+(Clock (if equipped)To set the time:
The ignition switch must be in the
ACC position or the ON position.
1. Press the SETUP CLOCK button.
2. Select "Clock" →"Clock Settings"
by using the TUNE knob.
3. Set the clock by using the TUNE knob.
Digital clock (if equipped)
Whenever the battery terminals or
related fuses are disconnected, you
must reset the time.
When the ignition switch is in the
ACC or ON position, the clock but-
tons operate as follows:Press the "H" button to advance the
time displayed by one hour.Press the "M" button to advance the
time displayed by one minute.To change the 12 hour format to the
24 hour format, press the "H" and
"M" button simultaneously for more
than 4 seconds.
For example, if the "H" and "M" but-
ton is pressed when the time is 10:15
p.m., the display will change to 22:15
Do not adjust the clock while driv-
ing. You may lose your steering
control and cause severe personal
injury or accidents.
WARNING
OIB044038
Do not adjust the clock while driv-
ing. You may lose your steering
control and cause severe personal
injury or accidents.
WARNING

AAntenna
Type A,BThe roof antenna receives DRM and
both AM and FM broadcast signals.
Rotate the roof antenna in a counter-
clockwise direction to remove it.
Rotate it in a clockwise direction to
reinstall it.Type C The shark fin antenna receives trans-
mitted data. (for example: AM/FM,
and DRM)• Before entering a place with a low height clearance, be sure that the
antenna is removed.
• Be sure to r emove the antenna
before washing the vehicle in an
automatic car wash or it may be
damaged.
• When reinsta lling your antenna, it
is important that it is fully tightened
and adjusted to the upright position
to ensure proper reception. But it
could be removed when parking
the vehicle. Installation of aftermarket an
tenna
may result in water leakage, wind
noise, rattling & improper radio oper-
ation. We recommend to us e the
antenna available with an authorized
HYUNDAI dealer.
Information
Some models do not have audio (plas-
tic blanking cover) system, and will
not supply radio main cable. Thus if
you want to insert Aftermarket audio
or OEM audio to listen radio broad-
casting service, we recommend to use
the feeder cable available with an
authorized HYUNDAI dealer. iNOTICE
NOTICE
#
!'%$&%" '&$
OIB044036OIB045191OIB047193
■ Type B■Type A■Type C

##!'%$&%" '&$
(( Continued)
• In case of product malfunction, please contact your place of pur-
chase or After Service ce nter.
• Placing the audio system within an electromagnetic environment may
result in noise interference.
• Prevent caustic solutions such as perfume and cosmetic oil from
contacting the dashboard because
they ma y cause damage or discol-
oration.
RadioRadio ModeChange Mode:
[RADIO
]button
• You can toggle between the radio modes using
[RADIO]
button.
• If
[SETUP/CLOCK]
 [Display] 
[Mode Popup] is turned [Off], then
each time you press the
[RADIO]
button, you can toggle between
radio modes (FM1 ➟ FM2 ➟AM ➟
DRM ➟FM1).
• The radio mode popup will not be displayed when
[SETUP/CLOCK]
button [Display] [Mode popup]
is turned [Off].
Search Frequency:
[SEEK/TRACK]
button• Searches the previous/next broad- cast frequencies.
- Short press of button: searchesthe previous/next available
broadcast frequency.
- Long press of button: Frequency is controlled by 1 step quickly.
When the button is released after
pressing and holding, searches
the previous/next available
broadcast frequency.Change Frequency:
TUNE
knob
Changes frequency by turning the
knob left/right. You can seek avail-
able frequencies manually.Saved Frequency:
[1] ~ [6]
(Preset)
buttons
• Pressing the button: Plays the fre-
quency saved in the corresponding
button.
• Pressing and holding the button (more than 1.0 second): Saves the
currently playing broadcast to the
selected button and sound a BEEP.

#
!'%$&%" '&$
(Continued)
• Charging through the USB may notwork for some mobile devices.
• The device may not support normal operation when using an atypical
USB memory device (miniature,
keychain, etc.). For best results, use
a typical USB device that has a
metal case.
• The device may not support normal operation when using formats such
as HDD Type, CF, or SD Memory.
• The device will not support files locked by DRM (Digital Rights
Management.).
• USB memory sticks used by con- necting an Adaptor (SD Type or CF
Type) may not be properly recog-
nized.
• The device may not operate proper- ly when using USB HDDs or USBs
subject to connection failures
caused by vehicle vibrations. (e.g. i-
stick type)
(Continued)(Continued)
• Avoid use of USB
memory products that
can also be used as key
chains or mobile phone
accessories. Use of such
products may cause damage to the
USB jack.
• Connecting an MP3 device or phone through various channels, such as
AUX/BT or Audio/USB mode may
result in pop noises or abnormal
operation.
• Use USB 2.0 devices for better com- patibility. Maximum device size
supported is 32 GB.
II nformation- Using the iPod
®
• iPod
®
is a registered trademark of
Apple Inc.
• In order to use the iPod
®
with your
vehicle’s audio system, you must use
a dedicated iPod
®
cable. (the cable
that is supplied when purchasing
iPod
®/iPhone
®
products)
• If the iPod
®is connected to the vehi-
cle while it is playing, a high pitch
sound could occur for approximate-
ly 1-2 seconds immediately after
connecting. If possible, connect the
iPod
®
to the vehicle with the iPod
®
stopped/paused.
• When the vehicle ignition is set to ACC or ON, connecting the iPod
®
through the iPod
®
cable will charge
the iPod
®through the car audio sys-
tem.
• When connecting with the iPod
®
cable, make sure to fully insert the
jack to prevent communication
interference. (Continued)i

#
!'%$&%" '&$
IInformation- Using Bluetooth
®
(BT) Audio
(if equipped)
• Bluetooth
®Audio Mode can be used
only when a Bluetooth
®
phone has
been connected.
• Bluetooth
®
Audio Mode will not be
available when connecting mobile
phones that do not support this fea-
ture.
• If a Bluetooth
®
Phone is being used
to play music and receives an
incoming or outgoing phone call,
then the music will stop.
• Moving the Track up/down while playing Bluetooth®audio mode may
result in pop noises with some
mobile phones.
• Bluetooth
®
streaming audio may
not be supported in some mobile
phones.
• When returning to Bluetooth
®
Audio mode after ending a call, the
mode may not automatically restart
in some mobile phones.
• Receiving an incoming call or mak- ing an outgoing call while playing
Bluetooth
®
Audio may result in
audio interference.
Media ModeChange Mode:
[MEDIA]
button
• Each time the button is pressed, the media mode popup will be dis-
played or closed.
• The media mode popup will not be displayed when
[SETUP/CLOCK]
button [Display] [Mode popup]
is turned [Off].
You can select a menu in the mode
popup by using the
[1]
~
[6]
(Preset) buttons or
TUNE
knob.
• If media device(USB, AUX) is con- nected, then it will automatically
operate. Once it is disconnected,
the previous mode will be restored.
• The Audio/Bluetooth
®(BT) Audio*/
AUX volume can also be con-
trolled.
* if equipped
Information
When you connect an Apple device,
playback does not start automatically.
Repeat:
[1 RPT]
button
• Repeats the current song or repeats all songs within the current
folder.
•iPod
®
mode: Repeat Song ➟
Repeat Off
• USB mode: Repeat Song ➟
Repeat Folder ➟ Off
Shuffle:
[2 SHFL]
button
• Plays all songs within the current
folder(category) or play all songs in
random order.
•iPod
®
mode: Shuffle All ➟ Shuffle
Off
• USB mode: Shuffle Folder ➟
Shuffle All ➟ Off
i
i