2015 Hyundai Genesis start stop button

[x] Cancel search: start stop button

Page 330 of 501

Hyundai Genesis 2015  Owners Manual 5-70
Driving your vehicle
LKAS operation
To operate:
Press the LKAS button with the
Engine Start/Stop button in the ON
position. The indicator (white) illumi-
nates on the cluster.
To cancel:
Press th

Page 339 of 501

Hyundai Genesis 2015  Owners Manual 5-79
Driving your vehicle
5
BSD (Blind Spot Detection) /
LCA (Lane Change Assist)
Operating conditions
To operate:
Press the BSD switch with the
Engine Start/Stop button in the ON
position. The indica

Page 359 of 501

Hyundai Genesis 2015  Owners Manual 6-2
The hazard warning flasher serves
as a warning to other drivers to exer-
cise extreme caution when
approaching, overtaking, or passing
your vehicle.
It should be used whenever emer-
gency repairs

Page 360 of 501

Hyundai Genesis 2015  Owners Manual 6-3
What to do in an emergency
If you have a flat tire while
driving
If a tire goes flat while you are driving:
 Take your foot off the accelerator
pedal and let the vehicle slow down
while driving st

Page 361 of 501

Hyundai Genesis 2015  Owners Manual 6-4
What to do in an emergency
Jump starting can be dangerous if
done incorrectly. Follow the jump
starting procedure in this section to
avoid serious injury or damage to
your vehicle. If in doubt abo

Page 368 of 501

Hyundai Genesis 2015  Owners Manual 6-11
What to do in an emergency
6
✽ ✽
NOTICE
If any of the below happens, have
the system checked by an authorized
HYUNDAI dealer.
1. The Low Tire Pressure Telltale/
TPMS Malfunction Indicator doe

Page 373 of 501

Hyundai Genesis 2015  Owners Manual 6-16
What to do in an emergency
If it is hard to loosen the tire hold-
down wing bolt by a hand, you can
loosen it easily using the Jack handle.
1. Put the Jack handle (1) into the
inside of tire hold

Page 380 of 501

Hyundai Genesis 2015  Owners Manual 6-23
What to do in an emergency
6
When towing your vehicle in an
emergency without wheel dollies :
1.Set the Engine Start/Stop button in
the ACC position.
2.Place the shift lever in N (Neutral).
3.Rel