Page 78 of 573

77
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage
Lane Departure 
Warning (LDW) 
Indicator
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on if there is a problem with 
the LDW system.
●Stays on constantly  - Have the vehicle 
checked by a dealer.
●Blinks when your ve hicle is too close 
to the lane lines.  The beeper sounds.●Blinks while driving  - Take 
appropriate action to keep your vehicle 
within the lane lines.
—
●Comes on when the LDW system 
shuts itself off.●Stays on  - The temperature inside the 
LDW camera is too high.
The system acti vates when the 
temperature inside the camera cools 
down.
2 LDW Camera  P. 440
●Stays on - The area around the camera 
is blocked by dirt, mud, etc. Stop your 
vehicle in a safe place, and wipe it off 
with a soft cloth.
●Have your vehicle checked by a dealer if 
the indicator and message come back 
on after you cleaned  the area around 
the camera.
2 LDW Camera  P. 440
* Not available on all models
15 CROSSTOUR-31TP66500.book  77 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 79 of 573

78
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanation
Smart Entry 
System Indicator*
●Comes on for a few seconds when you 
change the power mode to ON, then goes 
off.
●Comes on as soon as a problem is detected 
in the smart entry system or push button 
starting system.
●Have your vehicle checked by a dealer.
Starter System 
Indicator*
●Comes on for a few seconds when you set 
the power mode to ON, then goes off.
●Comes on if the starter system has a 
problem.
●As a temporary measure, press and hold the  ENGINE 
START/STOP button for 15 seconds while pressing 
the brake pedal and manually start the engine. Have 
the vehicle checked by a dealer.
Turn Signal and 
Hazard Warning 
Indicators●Blinks when you operate the turn signal 
lever.
●Blink if you press the  hazard warning button.
●Does not blink or blinks rapidly - A turn signal 
light bulb has blown. Change the bulb immediately.
2Replacing Light Bulbs  P. 489, 490
U.S.
Canada
* Not available on all models
15 CROSSTOUR-31TP66500.book  78 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 80 of 573

79
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanation
High Beam 
Indicator●Comes on when the high beam headlights 
are on.—
Lights On 
Indicator
●Comes on whenever the light switch is on, or 
in AUTO  when the exterior lights are on.●If you remove the key from  the ignition switch or set 
the power mode to ACCESSORY or VEHICLE OFF 
(LOCK) while the exterior  lights are on, a chime 
sounds when the driv er’s door is opened.
Fog Light 
Indicator●Comes on when the fog lights are on.—
Daytime Running 
Lights Indicator
●Comes on for a few seconds when you turn 
the ignition switch to ON 
(w*1, then goes 
off.
●Comes on if there is a problem with the DRL 
system.
●Have your vehicle checked by a dealer.
2 Daytime Running Lights P. 122
Side Airbag Off 
Indicator
●Comes on for a few seconds when you turn 
the ignition switch to ON 
(w*1, then goes 
off.
●Comes on when the passenger side airbag 
system is automatically shut off.
●It does not mean there is  a problem with your side 
airbags.
●Comes on when nobody  is sitting in the 
passenger seat  - Have the vehicle checked by a 
dealer.
●Comes on when someone  is sitting in the seat - 
Have the passenger sit properly.
U.S.
Canada
15 CROSSTOUR-31TP66500.book  79 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 81 of 573
80
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanation
Immobilizer 
System Indicator
●Comes on briefly when  you turn the ignition 
switch to ON 
(w*1, then goes off.●Comes on if the immobilizer system cannot 
recognize the key information.
●Blinks  - You cannot start the engine. Turn the ignition 
switch to LOCK 
(0*1, pull the key out, and then insert 
the key and turn it to ON 
(w*1 again.●Repeatedly blinks  - The system may be 
malfunctioning. Have the ve hicle checked by a dealer.
●Do not attempt to alter this system or add other 
devices to it. Electrical problems can occur.
Security System 
Alarm Indicator
●Blinks when the security system alarm has 
been set.
2Security System Alarm P. 107
Indicator
15 CROSSTOUR-31TP66500.book  80 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 82 of 573
81
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanation
CRUISE MAIN 
Indicator●Comes on when you press the  CRUISE 
button.2 Cruise Control P. 432
CRUISE 
CONTROL  
Indicator●Comes on if you have set a speed for cruise 
control.
2 Cruise Control P. 432
Washer Level 
Indicator*
●Comes on when washer fluid gets low.●Refill washer fluid.
2Refilling Window Washer Fluid  P. 483
Maintenance 
Minder Indicator
●Comes on when you turn the ignition switch 
to ON 
(w*1, then goes off.●Comes on when the scheduled maintenance 
is due soon.2 Maintenance MinderTM P. 465
* Not available on all models
15 CROSSTOUR-31TP66500.book  81 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 83 of 573

82
uuIndicators uInformation Display Warning and Information Messages
Instrument Panel
Information Display Warning and Information Messages
The following messages appear on ly on the information display.
MessageConditionExplanation
●Appears when the fuel fill cap is loose or is not installed.
2Check Fuel Cap Message  P. 535
MessageConditionExplanation
●Appears if you push the ENGINE START/STOP button 
to turn the engine off wi thout the shift lever in 
(P.
●Push the ENGINE START/STOP  button twice after 
moving the shift lever to 
(P.
●Appears when the power mode is in ACCESSORY.—
●Appears when the steer ing wheel is locked.●Move the steering wheel left and right while pressing 
the ENGINE START/STOP  button at the same time.
●Appears when you close the door with the power mode 
in ON without the smart entry remote inside the vehicle.●Disappears when you bring the smart entry remote back 
inside the vehicle and close the door.
●Appears when the smart entry remote’s battery 
becomes weak.●Replace the battery as soon as possible.
2Replacing the Button Battery  P. 507
Models with smart entry system
15 CROSSTOUR-31TP66500.book  82 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 84 of 573

83
Instrument Panel
Gauges and Displays
Gauges
Gauges include the speedometer, tachometer, fuel gauge, and related indicators. 
They are displayed when the ignition switch is in ON 
(w*1.
Displays your driving speed in mph or km/h.
Shows the number of engine revolutions per minute.
Displays the amount of fuel left in the fuel tank.
Displays the temperature of the engine coolant.
*1: Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
■Speedometer
■Tachometer
■Fuel Gauge
■Temperature Gauge
1 Fuel Gauge
NOTICE
You should refuel when the reading approaches  .
Running out of fuel can cause  the engine to misfire, 
damaging the cata lytic converter.
The actual amount of remain ing fuel may differ from 
the fuel gauge reading.E
1 Temperature Gauge
NOTICE
Driving with the temperat ure gauge pointer in the 
upper zone can cause serious  engine damage. Pull 
safely to the side of th e road and allow engine 
temperature to return to normal. 2 Overheating  P. 532
15 CROSSTOUR-31TP66500.book  83 ページ  2014年7月31日 木曜日 午後3時23分 
     
        
        Page 87 of 573

uuGauges and Displays uInformation Display
86
Instrument Panel
Shows the outside temperature in Fahr enheit (U.S.) or Celsius (Canada).
■Adjusting the outside temperature display
Adjust the temperature reading up to ±5°F  or ±3°C if the temperature reading 
seems incorrect.
1. Turn the ignition  switch to ON 
(w*1.
2. Press and hold the   (Select/Reset) k nob for 10 seconds or more while the 
outside temperature is shown on the information display.
u The information display goes into temp erature adjustment mode. The display 
starts showing from -5°F  to +5°F (U.S.) or -3°C to +3°C (Canada).
3. Release the   knob when the ri ght adjustment amount is shown.
u The adjustment is complete.
*1: Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
■Outside Temperature*1 Outside Temperature*
The temperature sensor is  in the front bumper. Road 
heat and exhaust from anothe r vehicle can affect the 
temperature reading when your vehicle speed is less 
than 19 mph (30 km/h).
It may take several minutes for the display to be 
updated after the temperature reading has stabilized.
Use the audio/information screen’s customized 
features to correct the temperature. 2 Customized Features
* P. 280
Models with audio touch screen
* Not available on all models
15 CROSSTOUR-31TP66500.book  86 ページ  2014年7月31日 木曜日 午後3時23分