
517Handling the Unexpected
Shift Lever Does Not MoveFollow the procedure below if you cannot move the shift lever out of the
(P
position.
1.Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove the built-in key from the smart
entry remote.
3. Wrap a cloth around the tip of a small flat-
tip screwdriver. Put it into the shift lock
release slot as shown in the image, and
remove the cover.
4. Insert the key into the shift lock release slot.
5. While pushing the key down, press the shift
lever release button and place the shift lever
into
(N
.
u The lock is now released. Have the shift
lever checked by a dealer as soon as
possible.
■
Releasing the LockAutomatic transmission/CVT models
Slot
Cover
Models without smart entry systemModels with smart entry systemAll models
Release Button
Shift Lock
Release Slot

524Handling the Unexpected
FusesFuse LocationsIf any electrical devices are not working,
turn the ignition switch to LOCK
(0
*1 and
check to see if any applicable fuse is blown.
Located near the brake fluid reservoir. Push
the tabs to open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
■Circuit protected and fuse rating■
Engine Compartment Fuse Box
Circuit Protected
Amps
1
Battery
125 A
2
EPS
70 A
Fuse Box Main 1 (60 A)
Fuse Box Option 1
(40 A)
−−
−
−
ABS/VSA FSR 40 A
ABS/VSA Motor 30 A
3
−
−
−
−
−
−
−
−
4 Front Fog Light
*
(15 A)
5
Horn
10 A
6 Stop Light 10 A
7
FI Sub
15 A
8 DRL (7.5 A)
9
IG Coil
15 A
10 Injector
*2
20 A
11
Hazard
15 A
12 Fuse Box Main 2 60 A
Fuse Box Option 2 (40 A)
IG Main 1 50 A
30 A
*4
IG Main 2
*4
30 A
Sub Fan Motor 20 A
*2
30 A
*3
Headlight Low Beam Main 30 A
Fuse Box 30 A
Wiper Motor 30 A
Main Fan Motor 30 A Starter Motor
*4
30 A
13
Rear Defogger
40 A
14 Heater Motor 40 A
15
FI Main
15 A
Circuit Protected
Amps
*1:
Models with the smart entry system have an
ENGINE START/STOP button instead of an
ignition switch.
*2:4-cylinder models
*3:6-cylinder models
*4:Models with smart entry system 16 Heated Door Mirror
*
(10 A)
17
MG Clutch
7.5 A
18 DBW 15 A
19
Small Light
20 A
20 Interior Light 7.5 A
21
Back Up
10 A
22 Audio 10 A
23
Fan Timer
7.5 A
24 Right Headlight Low Beam 10 A
25
Left Headlight Low Beam
10 A
26 − −
Circuit Protected
Amps
* Not available on all models

526
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
(0
*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of
an ignition switch.
1 Inspecting and Changing FusesNOTICEReplacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 524 to 525.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown FuseFuse Puller

537
Continued
Information
Emissions TestingTesting of Readiness CodesYour vehicle has “Readiness Codes,” as part of the onboard self diagnostic system.
Some States use these codes as a test to see if your vehicle's emissions components
are working properly.
The codes may not be read properly if testing is performed just after the battery has
gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
(w
*1, without starting the
engine. The malfunction indicator lamp will come on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle tested before the readiness codes are ready,
prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for six hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the accelerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P
(automatic transmission/CVT) or
(N
(manual
transmission). Increase the engine speed to 2,000 rpm, and hold it there for about
three minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again only after several days of
driving under a variety of conditions.
If a testing facility dete rmines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing faci lity determines the readiness codes
are still not set, see a dealer.

549Index
Fuel..................................................... 20, 447
Economy................................................. 449
Gauge ...................................................... 81
Instant Fuel Economy ................................ 83
Low Fuel Indicator..................................... 71
Range ....................................................... 84
Recommendation.................................... 447
Refueling ................................................ 447
Fuel Economy ........................................... 449
Fuel Fill Cap ........................................ 20, 448
Message ................................................. 521
Fuel Fill Door ...................................... 20, 448
Fuses ......................................................... 524
Inspecting and Changing ........................ 526
Locations ........................................ 524, 525GGasoline (Fuel) Economy................................................. 449
Gauge ...................................................... 81
Information............................................. 447
Instant Fuel Economy ................................ 83
Low Fuel Indicator..................................... 71
Refueling ................................................ 447
Gauges ........................................................ 81
Gear Shift Lever Positions
Automatic Transmission .......................... 413
Continuously Variable Transmission (CVT) .................................................... 409
Manual Transmission .............................. 418 Glass (care)
................................................ 501
Glove Box .................................................. 137
HHalogen Bulbs ................................... 475, 478
Handling the Unexpected ........................ 503
HandsFreeLink ® (HFL) ....................... 314, 351
Auto Answer ................................... 330, 366
Automatic Import of Cellular Phonebook and
Call History .................................... 332, 368
Automatic Transferring .................... 330, 366
Displaying Messages ........................ 346, 385
Editing User Name ................................... 365
HFL Buttons ..................................... 314, 351
HFL Menus ...................................... 317, 353
HFL Status Display ........................... 316, 352
Limitations for Manual Operation .... 316, 352
Making a Call .................................. 336, 377
Options During a Call ...................... 343, 382
Phone Setup .................................... 322, 357
Phonebook Phonetic Modification ........... 372
Receiving a Call ............................... 342, 381
Receiving a Text/E-Mail Message ...... 344, 383
Ring Tone ........................................ 331, 367
Selecting a Mail Account ................. 345, 384
Speed Dial ....................................... 333, 369
To Create a Security PIN .................. 329, 364
To Set Up a Text/E-Mail Message Options ......................................... 327, 362
Use Contact Photo .......................... 331, 367 Hard Disk Drive (HDD) Audio
.................. 238
Hazard Warning Button .............................. 4
Head Restraints ........................................ 130
Headlights ................................................. 115
Aiming .................................................... 475
Automatic Operation............................... 116
Dimming ......................................... 115, 118
Operating................................................ 115
Heaters (Seat) ........................................... 143
High Beam Indicator .................................. 74
Hill Start Assist System ..................... 402, 406
HomeLink ® Universal Transceiver ............ 312
IIdentification Numbers
Engine and Transmission ......................... 534
Vehicle Identification ............................... 534
Ignition Switch ......................................... 110
Illumination Control Knob ....................................................... 120
Immobilizer System .................................. 103
Indicator.................................................... 74
Indicators .................................................... 68
Anti-lock Brake System (ABS)..................... 71
Brake System (Amber) ............................... 68
Brake System (Red) .................................... 68
Charging System ............................... 69, 520
CRUISE CONTROL ............................. 77, 422
CRUISE MAIN .................................... 77, 421