Downloaded from www.Manualslib.com manuals search engine Inflating the Tire
Protective capA
Pressure relief valveB
HoseC
Orange capD
Bottle holderE
Pressure gaugeF
Power plug with cableG
Compressor switchH
LabelI
Bottle lidJ
Sealant bottleK
1.Open the lid of the kit.
2.Peel off the label I showing themaximum permissible speed of 50 mph(80 km/h) from the casing and attachit to the instrument panel in the driver’sfield of view. Make sure the label doesnot obscure anything important.
3.Take the hose C and the power plugwith cable G out of the kit.
4.Unscrew the orange cap D and thebottle lid J.
5.Screw the sealant bottle K clockwiseinto the bottle holder E fully tight.
6.Remove the valve cap from thedamaged tire.
7.Detach the protective cap A from thehose C and screw the hose C firmly ontothe valve of the damaged tire.
8.Make sure that the compressor switchH is in position 0.
9.Insert the power plug G into the cigarlighter socket or auxiliary power point.
10.Start the engine.
11.Move the compressor switch H toposition 1.
12.Inflate the tire for no longer than 10minutes to an inflation pressure ofminimum 1.8 bar (26 psi) and amaximum of 3.5 bar (51 psi). Move thecompressor switch H to position 0 andcheck the current tire pressure withpressure gauge F.
13.Remove the power plug G from thecigar lighter socket or auxiliary powerpoint.
14.Quickly unscrew the hose C from thetire valve and replace the protectivecap A. Fasten the valve cap again.
15.Leave the sealant bottle K in thebottle holder E.
16.Make sure the kit, the bottle lid andthe orange cap are stored safely, butstill easily accessible in your vehicle.The kit will be required again when youcheck the tire pressure.
17.Immediately drive approximatelytwo miles (three kilometers) so thatthe sealant can seal the damagedarea.
TIRE PRESSURE MONITORING
SYSTEM
13Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3586en enGBR, Edition date: 09/2014, Second Printing
