1 INTERIOR LAMPS
Press and hold the top of
the control to switch on
the interior courtesy lamps.
Press the bottom of the
control to switch off the
interior lamps.
2 LIGHTING CONTROL
Switches off the
headlamps.
Switches on the
parking lamps.
Switches the
headlamps on.
Autolamps: Automatically turns the exterior lamps on
in low light situations.
Pull the control toward you
to switch the fog lamps on.
3 POWER-ADJUSTABLE
FOOT PEDALS* located
to the left of your steering
column lets you move
your brake and accelerator
pedals closer. Press the
arrow to move the pedals
closer to you or the
arrow
to move the pedals further
away from you. Adjust the
pedals only after you stop
the vehicle and place the
transmission in park (P).
4 TILT AND
TELESCOPING
STEERING COLUMN*
lets you adjust the position
of the steering column.
Use the control on the side
of the steering column.
The column automatically
moves to the full up
position when you switch
the ignition off. It returns to
the previous position when
you switch the ignition on.
You can switch this feature
off in the information
display.
For more details about
your information display
functions, please see your
Owner’s Manual.
5 WINDSHIELD WIPERS
AND WASHERS
Rotate the end of the
control away from you to
increase the wiper speed
and toward you to decrease
the wiper speed.
To use the washer feature,
push the end of the lever.
To operate the rear window
wiper, rotate the control.
For a rear wash cycle, rotate
and hold the rear wiper
control
to either the
top or bottom position.
Note: For optimal wiper
performance, clean your
blades and glass regularly.
6 LEFT VEHICLE
INFORMATION
DISPLAY
provides
important vehicle
information through a
constant monitoring of
vehicle systems. The
system notifies you of
potential vehicle problems
by displaying system
warnings followed by a
long indicator tone.
Use the left-hand, 5-way
controls located on your
steering wheel to scroll
through, highlight and make
minor adjustments within a
selected menu.
For more details about
your information display
functions, refer to your
Owner’s Manual.
7 SERVICE ENGINE
SOON LIGHT lights briefly when
you switch the ignition on.
If it remains on or blinks
after you start the engine,
the On-Board Diagnostics
(OBD-II) system detects
a problem. Drive in a
moderate fashion and
contact an authorized
dealer as soon
as possible.
8 CRUISE CONTROL
To set the speed
A. Press and release ON.
B. Accelerate to the
desired speed.
C. Press SET+ and take your
foot off the accelerator.
To set a higher or lower
speed, either press and hold
or press SET+ or SET-
repeatedly until you reach
the desired speed.
To cancel a set speed, tap
the brake pedal. The set
speed will not be erased.
To return to a previously
set speed, press RES .
To switch off, press OFF or
switch the ignition off.
page 5 page 4*if equipped
INSTRUMENT PANEL
7
2
5
6
6
8
13
4
