2015 DODGE CHARGER jump cable

[x] Cancel search: jump cable

Page 399 of 638

DODGE CHARGER 2015 7.G Owners Manual WARNING!(Continued)
•Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the cataly

Page 519 of 638

DODGE CHARGER 2015 7.G Owners Manual 6. Verify that the cap is installed on the fitting at the end
of the Sealant Hose (6) and return the hose to its
storage area (located on the bottom of the air pump).
7. Return the Tire Service Kit to

Page 521 of 638

DODGE CHARGER 2015 7.G Owners Manual WARNING!
•Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is ON. You can be injured by
moving fan blades.
•Remove any metal jewe

Page 522 of 638

DODGE CHARGER 2015 7.G Owners Manual CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive(+)end o

Page 523 of 638

DODGE CHARGER 2015 7.G Owners Manual 6. Once the engine is started, remove the jumper cables
in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative(-)end of the jumper cable
from the remote negative(-)post of

Page 546 of 638

DODGE CHARGER 2015 7.G Owners Manual NOTE: The battery is stored under an access cover in
the trunk. Remote battery terminals are located in the
engine compartment for jump starting. Refer to “Jump-
Starting Procedures” in “What To