2015 Citroen NEMO change lamp

149
CHECKS
Bleeding water from the Diesel
filter
If this warning lamp comes
on, you must bleed the filter;
otherwise bleed the filter
regularly, every time the engine
oil is changed.
To remove the water, unscrew the bleed
screw or the water in
d iesel sensor, located
at the base of the filter.
o perate until all of
the water has flowed out. Then tighten the
bleed screw or the water sensor.
Battery
at the start of winter, have your battery
checked by a CITROËN dealer or a qualified
workshop.
Air filter and passenger compartment filter
A blocked passenger compartment filter
may reduce the performance of the
air conditioning system and generate
undesirable odours. The replacement
intervals for these components are indicated
in the maintenance and warranty guide.
Depending on the environment (dusty
atmosphere...) and the use of the vehicle
(urban driving...), change them twice as
often if necessary.
Brake pads
Brake pad wear depends on the type of
driving, in particular for vehicles which are
used in town, over short distances. It may
be necessary to check the brake pad wear,
even between services.
Unless there is a leak on the system, a drop
in the brake fluid level indicates that the
brake pads are worn.
Brake disc / drum wear
For all information on checking the brake
disc / drum wear, contact a CITROËN dealer
or a qualified workshop.
Parking brake
Where the parking brake travel is too great
or there is a reduction in the performance
of the system, the parking brake should be
adjusted, even between services.
Have the system checked by a CITROËN
dealer or a qualified workshop.
Oil filter
Change the filter regularly, in accordance
with the manufacturer's servicing schedule.
The presence of this label, in particular
with the Stop & Start system, indicates the
use of a specific 12 V lead-acid battery
with special technology and specification.
The involvement of a CITR
o
Ë
n
dealer
or a qualified workshop is essential when
replacing or disconnecting the battery.
Refer to the "Checks - Under the
bonnet" section.
HDi engines use advanced
technology. All work requires
specialist knowledge, which all CITROËN
dealers have.
8
CHECKS
Checks

162
1 - Dipped beam headlamps
Type D, H4 - 55 W
-
Remove the cover by turning it

anticlockwise.
-

Disconnect the electrical connector
.
-

Release the retaining spring by pressing

on the two clips.
-

Change the bulb taking care to align the

metal part with the grooves on the lamp.
2 - Sidelamps
Type A, W 5 W - 5 W
-

Remove the cover by turning it

anticlockwise.
-

Pull the bulb holder to gain access to the

bulb.
-

Change the bulb. 3 - Main beam headlamps
T

ype D, H4 - 55 W
-

Remove the cover by turning it

anticlockwise.
-

Disconnect the electrical connector
.
-

Release the retaining spring by pressing

on the two clips.
-

Remove the bulb holder
.
-

Change the bulb taking care to align the

metal part with the groove on the lamp. 4 - Direction indicators
Type B, PY 21 W - 21 W amber
-

T
urn the bulb holder a quarter turn
anticlockwise.
-
Remove the bulb by pressing it lightly

while turning it anticlockwise.
-
Change the bulb.
If you encounter any dif
ficulty, consult a
CITROËN dealer or a qualified workshop.
When each operation has been completed,
check the operation of the lamps.
5 - Foglamps
Type E, H1 - 55 W
Contact a CITR
o Ë n dealer or a qualified
workshop.
Changing a bulb

163
Front / rear courtesy lamps
Type C, 12 V 10 W - 10 W
-
Release the courtesy lamp using a

screwdriver.
-

Remove the cover to gain access to the

bulb.
-

Change the bulb moving aside the two

contacts.
-

Ensure that the new bulbs are secured

correctly between the two contacts.
-

Close the protective flap.
-


Fix the courtesy lamp in its housing and

ensure that it is secured correctly.
Direction indicator side repeaters
Type A, WY 5 W - 5 W amber
-
Push the repeater rearwards and
release it.
-

Support the connector and turn the bulb

holder a quarter of a turn to the left.
-

T
urn the bulb a quarter of a turn to the
left.
-

Pull the bulb then change it.
-


When refitting, engage the repeater

rearwards then move it forwards.
9
QUICK HELP
Changing a bulb

164
Rear lamps
- Identify the faulty bulb then open the rear
doors.
-

Unscrew the two screws using the

screwdriver supplied in the tool kit
(behind the driver's seat) and extract the
bulb holder.
-

Release the lamp unit.
-


Disconnect the electrical connector
.
-

Remove the support by moving aside the

tabs.
-

Change the bulb.
Number plate lamps
Type A, C 5 W - 5 W
-
Unclip the transparent cover using

the screwdriver supplied in the tool kit
(behind the driver's seat) and extract the
bulb holder.
-

Change the bulb by moving aside the two

contacts.
-

Ensure that the new bulbs are secured

correctly between the two contacts.
-

Replace the plastic lens and press on it.
For further information concerning the bulbs,


refer to the table "Types of bulb".
1.

Brake lamps



T

ype B, P 21 W - 21 W
2.

Direction indicators



T

ype B, PY 21 W - 21 W amber
3.

Reversing lamps



T

ype B, P 21 W - 21 W
4.

Sidelamps / Foglamps
T

ype B, P4/21W - 4W/21W On the hinged rear doors On the tailgate
Changing a bulb

165
Third brake lamp
On the hinged rear doors
Type B, W 5 W - 5 W (4 bulbs)
-
Unclip the transparent cover using the

screwdriver located in the tool kit.
-

Disconnect the electrical connector
.
-

Remove the bulb holder by squeezing the

two tabs.
-

Remove the faulty bulb.
-


Change the bulb. On the tailgate
T

ype B, W5W - 5W (5 bulbs)
-

Open the tailgate.
-


Remove the two cover retaining screws,

then the cover.
-

Remove the bulb holder by squeezing the

two tabs.
-

Remove the faulty bulb.
-


Change the bulb.
If you encounter any dif

ficulty, consult a
CITROËN dealer or a qualified workshop.
9
QUICK HELP
Changing a bulb