DS3_en_Chap04_confort_ed01-2014
Recommendations for ventilation and air conditioning
If after an extended stop in sunshine, the interior temperature is very
h
igh, first ventilate the passenger
c
ompartment for a few moments.
Put
the air flow control at a setting high
e
nough to quickly change the air in the
p
assenger
c
ompartment.
The
air conditioning system does not
c
ontain chlorine and does not present
any
danger to the ozone layer.
In
order
for
these
systems
to
be
fully
effective,
follow
the
operation
and
maintenance
g
uidelines belo
w:
F
T
o
obtain
an
even
air
distribution,
take
care
not
to
obstruct
the
exterior
air
intake
grilles
l
ocated at the base of the windscreen, the nozzles, the vents and the air outlets, as well
as
the
air
extractor
located
in
the
boot.
F
D
o
not
cover
the
sunshine
sensor,
located
on
the
dashboard;
this
is
used
for
regulation
o
f
the
air
conditioning
system.
F
O
perate
the
air
conditioning
system
for
at
least
5
to
10
minutes,
once
or
twice
a
month
t
o
keep
it
in
per fect
working
order.
F
E
nsure
that
the
passenger
compartment
filter
is
in
good
condition
and
have
the
filter
e
lements
replaced
regularly.
W
e
recommend
the
use
of
a
combined
passenger
compartment
filter.
Thanks
to
its
s
pecial active additive, it contributes to the purification of the air breathed by the
occupants
and
the
cleanliness
of
the
passenger
compartment
(reduction
of
allergic
s
ymptoms,
bad
odours
and
greasy
deposits).
F
T
o
ensure
correct
operation
of
the
air
conditioning
system,
you
are
also
advised
to
have
i
t
checked
regularly
as
recommended
in
the
maintenance
and
warranty
guide.
F
I
f
the
system
does
not
produce
cold
air,
switch
it
off
and
contact
a
CITROËN
dealer
or
a
qualified
workshop.
When
towing
the
maximum
load
on
a
steep
gradient
in
high
temperatures,
switching
off
the
a
ir
conditioning
increases
the
available
engine
power
and
so
improves
the
towing
ability. The condensation created by the air
conditioning
results in a discharge
o
f water under the vehicle which is
per fectly
normal.
DS3_en_Chap06_conduite_ed01-2014
Driving
This section describes the use of the parking brake, the manual, electronic or automatic gearbox, the gear shift indicator and Stop & Start t
o help reduce fuel consumption, hill start assist, the speed limiter to
a
void exceeding a programmed speed, cruise control to maintain a
p
rogrammed speed, the rear parking sensors to detect obstacles.
DS3_en_Chap06_conduite_ed01-2014
Rear parking sensors
System consisting of four proximity sensors, located in the rear bumper.
This detects any obstacle (person, vehicle,
tree,
gate, etc.) behind the vehicle, except
o
bstacles located just below the bumper.
An object, such as a stake, a roadworks cone or any other similar object may b
e detected at the beginning of the
m
anoeuvre, but may no longer be detected
w
hen the vehicle comes close to it.
The parking sensor system cannot in any circumstances take the place of
v
igilance on the part of the driver.
The
system is activated as soon as reverse
g
ear
is engaged, accompanied by an audible
s
ignal. The proximity information is given by:
-
a
n audible signal, which becomes more
r
apid as the vehicle approaches the
obstacle.
-
a
graphic (according to version) in the
m
ultifunction screen, with blocks which
b
ecome increasingly closer to the vehicle.
Activation
When the distance between the rear of the vehicle
and
the obstacle is less than thirty centimetres, the a
udible signal becomes continuous and the "Danger"
s
ymbol appears in the multifunction screen.
On
completion of the manoeuvre, when you exit
r
everse gear, the system becomes inactive.
127
DS3_en_Chap06_conduite_ed01-2014
ProgrammingOperating faults
If there is an operating fault, when r
everse gear is engaged this w
arning
lamp comes on in the instrument panel,
a
ccompanied by an audible signal (short beep)
a
nd
a
message in the multifunction screen.
You
can
activate
or
deactivate
the
system
by
m
eans
of
the
multifunction
screen
configuration
m
enu.
The
system
state
is
memorised
when
s
witching
off
the
ignition.
For
more
information
on
access
to
the
parking
s
ensors
menu,
refer
to
" Vehicle
configuration"
o
r
" Vehicle
parameters"
section
for
your
m
ultifunction
s
creen.
The
system
will
be
deactivated
a
utomatically
when
towing
a
trailer
or
w
hen a bicycle carrier is fitted (vehicle
fitted with a towbar or bicycle carrier
recommended
by
CITROËN). In bad or wintry weather, ensure that
the
sensors are not covered with mud,
f
rost
or snow.
driving
DS3_en_Chap07_visibilite_ed01-2014
The sidelamps and dipped beam headlamps are switched on automatically, without any
a
ction on the part of the driver, when a low level
of
external light is detected or in certain cases
o
f activation of the windscreen wipers.
As
soon as the brightness returns to a
s
ufficient level or after the windscreen wipers
are
switched off, the lamps are switched off
au
tomatically.
Automatic illumination of headlamps
Activation
F Turn ring to the "AUTO" position. The a
utomatic illumination of headlamps is
a
ccompanied by a message in the screen.
deactivation
F Turn ring to a position other than "AUTO". D
eactivation is accompanied by a message
i
n the screen.
Association with the automatic
"Guide-me-home" lighting
Association with the automatic illumination of headlamps provides "guide-me-home" lighting
w
ith the following additional options:
-
s
election of the lighting duration to 15,
30 or 60 seconds in the functions that can
be
set in the vehicle configuration menu
(
except in the case of the monochrome
s
creen A, for which the duration is set:
60 seconds),
-
a
utomatic activation of "guide-me-home"
l
ighting when automatic illumination of
h
eadlamps is in operation.
Operating fault
In the event of a fault with the
sunshine sensor, the lighting
c
ome
on,
this warning lamp is displayed in the
i
nstrument
panel and/or a message appears in
t
he
screen,
accompanied by an audible signal.
Contact a CITR
oË
N dealer or a qualified
workshop.
In
fog or snow, the sunshine sensor
m
ay
detect sufficient light. Therefore,
t
he
lighting will not come on
au
tomatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind
the rear view mirror; the
a
ssociated functions would no longer
be c
ontrolled.
141
DS3_en_Chap07_visibilite_ed01-2014
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically, without any action on the part of the driver, if
rain is detected (sensor behind the rear view
mirror),
adapting their speed to the intensity of
t
he rainfall.
Activation
This is controlled manually by the driver by pushing s talk A to the "AUTO" p osition.
It
is accompanied by the illumination
o
f this indicator lamp in the
i
nstrument panel and a message in
t
he multifunction screen.
Switching off
This is controlled manually by the driver by moving stalk A upwards, returning it to
p
osition
"0".
It
is accompanied by the indicator lamp
i
n the instrument panel going off and a
m
essage in the multifunction screen.The
automatic wiping must be r
eactivated if the ignition has been off
f
or more than one minute, by pushing
s
talk A downwards.
Visibility
DS3_en_Chap07_visibilite_ed01-2014
Operating fault
If an automatic wiping fault occurs, the wipers will operate in intermittent mode.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop. To retain the effectiveness of the flat
wiper
blades, it is advisable to:
-
h
andle them with care,
-
c
lean them regularly using soapy
w
ater,
-
n
ot use them to hold a sheet of
c
ardboard against the windscreen,
-
r
eplace them at the first signs of
w
e a r.
Do
not cover the rain sensor, linked
w
ith the sunshine sensor and located in
the centre of the windscreen behind the
rear
view mirror.
Switch
off the automatic wiping when
u
sing an automatic car wash.
In winter, it is advisable to wait until the
windscreen
is completely clear of ice
b
efore activating the automatic wiping.This position allows the wiper blades to
be
lifted for winter parking, cleaning or
r
eplacement without damaging the bonnet.
In
the minute following switching off of the
i
gnition, any action on the wiper stalk positions
t
he wipers vertically.
To
park the wipers after this has been done,
s
witch on the ignition and operate the wiper stalk.
Vertical windscreen wiper
position
Under-inflation detection
System which automatically checks the pressures of the tyres while driving.
T he under-inflation detection system
d
oes not replace the vigilance or the
r
esponsibility of the driver.
This
system does not avoid the need to
c
heck the tyre pressures (including the
s
pare wheel) every month as well as
b
efore a long journey.
Driving
with under-inflated tyres
i
mpairs road holding, extends braking
d
istances and causes premature
t
yre wear, particularly under arduous
condition
(high loading, high speed,
lon
g
jo
urney).The inflation pressures defined for
your vehicle can be found on the tyre
pressure
label.
See
the "Identification markings"
s
ection.
Tyre
pressures should be checked
w
hen the tyres are "cold" (vehicle
stopped
for 1 hour or after a journey of
l
ess than 6 miles (10 km) at moderate
s
peeds).
Other wise
(when hot), add 0.3 bar to
t
he pressures shown on the label.
Driving
with under-inflated tyres
i
ncreases fuel consumption.
The
system monitors the pressures in the four
t
yres, once the vehicle is moving.
It
compares the information given by the four
w
heel speed sensors with reference values,
which must be reinitialised ever y time the
tyre pressures are adjusted or a wheel
changed .
The
system triggers an alert as soon as it
d
etects a drop in the inflation pressure of one
or
more tyres.