35
Low fuel levelfixed, accompanied by a
n audible signal and
a
message. When
it first comes on there remains a
pproximately 6 litres of fuel in the
tank.
You
are then using the fuel reserve.You
must refuel as soon as possible to avoid running o
ut of fuel.
Until
sufficient fuel is added, this warning lamp will
c
ome on every time the ignition is switched on,
a
ccompanied by an audible signal and a message.
This
audible signal and message are repeated with
i
ncreasing frequency as the drops towards "0".
Fuel
tank capacity: approximately 57 litres (petrol) or
5
5 litres (Diesel).
Never
continue to drive until you run out of fuel as
t
his could damage the emission control and injection
s
ystems.
Warning / indicator lamp
StateCause Action / Observations
Seat belt(s)
not fastened /
unfastened fixed
or
flashing
a
ccompanied by an
a
udible
s
ignal.A
seat belt has not been fastened or
h
as been unfastened.Pull
the strap then insert the tongue in the buckle.
Airbags on
temporarily. This lamp comes on for a few
s
econds when you turn on the
i
gnition, then goes off.This
lamp should go off when the engine is started.
If
it does not go off, contact a CITROËN dealer or a
q
ualified
w
orkshop.
fixed. One
of the airbag or seat belt
p
retensioner systems has a fault.Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
Passenger
airbag system flashing.
The
passenger airbag system has a
f
ault.Do
not have a passenger seated in the front
p
assenger
sea
t.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
1
Monitoring
46
System allowing certain displays in the instrument panel to be switched off for night
d
riving.
The
instrument panel remains on with the
v
ehicle speed, the gear selected in an
e
lectronic or automatic gearbox, cruise control
o
r speed limiter information, if in use, and the
l
ow fuel alerts as appropriate.
If
there is an alert or a change in a function
o
r to a setting, the black panel mode is
i
nterrupted. Using the steering mounted control:
F
W
ith the vehicle lighting on, press this
b
utton again to activate the black panel.
F
P
ress this button again to deactivate it.
Black screen (touch screen tablet)Black screen (black panel)
F Press on the "Configuration" menu.
F P ress the " Turn off screen "
button. The
s
creen in the touch screen tablet goes off.
P
ress the screen again (anywhere on its
s
ur face) to switch it on again.
Monitoring
48
Trip computer
T ype 1 instrument panel
System that gives you information on the journey in progress (range, fuel consumption…).
Information display in the touch screen tablet
Permanent display:
F Sel ect the " Driving assistance "
menu.
The
trip computer information is displayed in
t
he primary page of the menu.
F
P
ress one of the buttons to display the
de
sired
t
ab. The current instantaneous fuel
consumption
tab with:
-
t
he range,
-
t
he current fuel consumption,
-
t
he Stop & Start time counter.
The trip "1"
tab with:
-
t
he distance travelled.
-
t
he average fuel consumption,
- t he average speed,
f or the first trip.
The trip "2"
tab with:
-
t
he distance travelled.
-
t
he average fuel consumption,
-
t
he average speed,
f
or the second trip.
Trip reset
F When the desired trip is displayed, press t
he reset button or on the end of the wiper
c
ontrol stalk.
Tr i p s "1"
and "2"
are independent but their use
i
s identical.
For
example, trip "1"
can be used for daily
f
igures, and trip "2"
for monthly figures.
The
information
is
accessible
in
the
"
Driving assistance "
menu.
Temporary
display
in
a
new
window:
F
P
ress
the
end
of
the
wiper
control
stalk
for
a
ccess
to
the
information
and
display
the
d
ifferent
tabs.
Monitoring
49
Trip computer
T ype 2 instrument panel
Information display in the instrument panel
F Press the button on the end of the wiper
control stalk to display the various tabs in
s
uccession. -
T
he current information tab with:
●
t
he range,
●
t
he current fuel consumption,
●
t
he Stop & Start time counter.
-
T
rip "1"
w
ith:
●
t
he average speed.
●
t
he average fuel consumption,
● t he distance travelled, f
or the first trip.
-
T
rip "2"
w
ith:
●
t
he average speed,
●
t
he average fuel consumption,
●
t
he distance travelled,
f
or the second trip.
Trip reset
F When the trip required is displayed, press t
he control for more than two seconds
o
r use the left hand thumb wheel of the
s
teering mounted controls.
Tr i p s "1"
and "2"
are independent but their use
i
s identical.
For
example, trip "1"
can be used for daily
f
igures, and trip "2"
for monthly figures.
For
all
other
display
modes,
pressing
the
end
o
f
the
wiper
stalk
displays
this
information
in
a
n
ew
window.
The
display
of
trip
computer
information
is
p
ermanent
when
you
select
the
"DIALS"
d
isplay
mode.
1
Monitoring
50
Trip computer, a few definitions
Range
(miles or km)
T he distance which can still be
t
ravelled with the fuel remaining
i
n the tank (related to the
a
verage fuel consumption over
t
he last few miles (kilometres)
t
ravelled).
This
value may vary following a change
i
n
the
style of driving or the relief,
r
esulting in a significant change in the
c
urrent
fuel consumption.
When
the
range falls below 20 miles (30 km),
d
ashes
are
displayed. After filling with at least
5
litres
of
fuel,
the range is recalculated and is
d
isplayed
when it exceeds 60 miles (100 km).
If
dashes are displayed continuously
w
hile
driving in place of the digits,
c
ontact
a CITROËN dealer or a
q
ualified
w
orkshop. This
function is only displayed from
2
0 mph (30 km/h).
Current fuel consumption
(mpg or l/100 km or km/l)
C alculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip
c
omputer
re
set.
Average speed
(mph or km/h)
C alculated since the last trip
c
omputer
re
set.
Distance travelled
(miles or km)
C alculated since the last trip
c
omputer
re
set.
Stop & Start time
counter
(minutes / seconds or hours / minutes)
If
your
vehicle
is fitted with Stop & Start, a time
c
ounter
calculates the time spent in STOP
m
ode
during
a journey.
I
t
resets
to
zero every time the ignition is
s
witched
on
with the START/STOP button.
Monitoring
105
Rear screen demist - defrost
Switching onSwitching off
F Press
this button to demist /defrost t
he rear screen and (depending o
n version) the door mirrors. The
i
ndicator lamp associated with the
b
utton comes on.
The demisting/defrosting switches off automatically to prevent an excessive consumption of current.
The rear screen demist - defrost can only operate when the engine is
r
unning.
Switch
off the heating of the rear screen
a
nd door mirrors as soon as you judge it
p
ossible, as reducing the consumption
o
f electrical current reduces fuel
c
onsumption.
F
I
t
is
possible
to
stop
the
demisting/
defrosting
operation
before
it
is
s
witched
off
automatically
by
p
ressing
the
button
again.
The
i
ndicator
lamp
associated
with
the
b
utton
switches
off.
3
Comfort
143
never select neutral N w hen d riving.
Automated mode
F Select position A.
AUTO or A
and the gear engaged is
d
isplayed in the instrument panel.
The
gearbox operates in auto-active mode,
w
ithout any action on the part of the driver. It
c
ontinuously selects the most suitable gear for:
-
o
ptimisation of fuel consumption,
-
t
he style of driving,
-
t
he profile of the road.
-
t
he vehicle load.
For
optimum acceleration, for example
w
hen overtaking another vehicle, press
t
he accelerator pedal firmly past the
p
oint of resistance.
Temporary control of gear
changing
F Select position M .
The gears engaged are displayed in
s
uccession in the instrument panel.
The
gear change requests are only acted on if
t
he engine speed permits.
It is not necessary to release the accelerator
during
gear changes.
When
braking or slowing down, the gearbox
c
hanges down automatically to allow the
v
ehicle to accelerate in the correct gear.
On
sharp acceleration, the gearbox will not
c
hange up unless the driver acts on the
s
teering mounted paddles.
Manual mode
You can change mode at any time by moving the selector lever from A to M or the other way
round.
ne
ver select neutral N while the vehicle is
moving.
You
can
temporarily
take
over
control
of
g
ear
changing
using
the
"+"
and
"-"
steering
m
ounted
paddles.
If
the
engine
speed
allows,
t
he
instruction
to
change
gear
is
acted
on.
This function allows you to anticipate certain
situations
such
as
overtaking
a
vehicle
or
the
a
pproach
to
a
corner.
After
a
few
moments
without
any
action
on
t
he
control
paddles,
the
gearbox
resumes
a
utomatic
control
of
the
gears.
4
driving
148
Invalid value in manual operationThis symbol is displayed if a gear is
n
ot engaged correctly (gear selector
b
etween two positions).
You
can
temporarily
take
control
of
gear
c
hanges
using
the
"
+"
and
"
- "
steering
m
ounted
control
paddles.
If
the
engine
speed
a
llows,
the
instruction
to
change
gear
is
acted
o
n.
This function allows you to anticipate certain
situations
s
uch
a
s
ov
ertaking
a
nother
v
ehicle
o
r
a
pproaching
a
bend.
After
a
few
moments
with
no
action
on
the
c
ontrol
paddles,
the
gearbox
manages
the
g
ears
automatically
again.
Temporary manual control of the
gears
Manual mode
D and the gear engaged are displayed in the in strument pan el.
The
gearbox operates in auto-active
m
ode, without any action from the driver. It
c
ontinuously selects the most appropriate gear
a
ccording to the following conditions:
-
o
ptimisation of fuel consumption,
-
d
riving style,
-
r
elief of the road,
-
v
ehicle load.
Automated mode
F Select position D .
For
maximum acceleration, without touching
t
he
gear
selector, press the accelerator fully
d
own
(kick down). The gearbox changes down
a
utomatically and maintains the gear selected
u
ntil
the
maximum engine speed is reached.
When
braking, the gearbox changes down
a
utomatically for more effective engine braking.
When
you take your foot of the accelerator
p
edal
suddenly, the gearbox does not change
u
p,
so
as
to improve safety. F
Sel ect position M.
F
U
se the "+"
and "- "
steering mounted
c
ontrol paddles to change gear.
The
gears engaged are displayed successively
i
n the instrument panel.
When
stationary or at very low speed, the
g
earbox automatically engages 1st
g
e a r.
In
manual mode, it is not necessary to release
t
he accelerator pedal when changing gear.
The
change from one gear to another is only
e
ffected if the conditions of vehicle speed and
e
ngine speed allow; other wise the automatic
l
aws of operation are imposed temporarily.
If
the engine speed is too high or too low,
t
he display of the gear selected flashes for a
f
ew seconds, then the new gear engaged is
d
isplayed.It
is possible to change mode at any
t
ime, by moving the gear selector
f
rom D to M or the other way round.
Driving