2015 Citroen C4 ESP

85
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
See "Front demisting - defrosting".
4. Automatic visibility programmeIf you wish, you can make a different choice f
rom   that   offered   by   the   system   by   changing  
a

  setting.   The   the   "AUTO"
 
indicator   lamps   go  
o

ff;   the   other   functions   will   still   be   controlled  
au

tomatically.
F
 
P
ressing   the   "AUTO" button returns the
system
  to   completely   automatic   operation.2. Driver's side adjustment
The driver and front passenger can each   adjust   the   temperature   to   their  
r

equirements.
F

T

urn control 2 or 3   to   the   left   or   to   the   right  
r

espectively to decrease or increase this
value.
A
 
setting
 
around   the   value   21   provides  
o

ptimum
 
comfort.   However,   depending   on   your  
r

equirements,   a   setting   between   18   and   24   is  
n

ormal.
You
 
are
 
advised   to   avoid   a   left   /   right   setting  
d

ifference
 
of   more   than   3.
3. Passenger's side adjustment
The value indicated on the display corresponds
to  a   level   of   comfort   and   not   to   a   temperature   in  
d

egrees   Celsius   or   Fahrenheit. With
  Stop   &   Start,   when   demisting   has  
b

een   activated,   the   STOP   mode   is   not  
a

vailable.For
  maximum   cooling   or   heating   of   the  
p

assenger   compartment,   it   is   possible  
t

o   exceed   the   minimum   value   14   or   the  
m

aximum   value   28.
F

T
urn control 2 or 3 to the left until
"LO"
  is   displayed   or   to   the   right  
u

ntil "HI"
 
is   displayed.
Manual operation
4
Comfort

95
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Storing driving positions
Storing a position
Using buttons M / 1 / 2
F Switch  on   the   ignition.
F  A djust   your   seat   and   the   door   mirrors.
F

P
ress button M , then press button 1 or 2
within
  four   seconds.
 A

n   audible   signal   indicates   that   the   position  
h

as   been   stored.
Recalling a stored position
Ignition on or engine running
F Press button 1 or 2 to recall the corresponding p osition.
 A

n   audible   signal   confirms   that   adjustment  
i

s   complete.
System
 
which
 
registers
 
the
 
electrical
 
settings
 
o

f
 
the
 
driver's
 
seat
 
and
 
door
 
mirrors.
 
It
 
enables
 
y

ou
 
to
 
store
 
and
 
recall
 
two
 
positions
 
using
 
the
 b
uttons
 
on
 
the
 
side
 
of
 
the
 
driver's
 
seat.
Storing
 
a
 
new
 
position
 
cancels
 
the
 
p

revious
 p

osition. You
  can   interrupt   the   current   movement  
b

y   pressing   button M, 1 or 2
  or   by   using  
o

ne   of   the   seat   controls.
a

stored position cannot be recalled
while
  driving.
Recalling
  stored   positions   is  
d

eactivated   45   seconds   after   switching  
o

ff   the   ignition.
4
Comfort

96
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Rear seats
Rear head restraints
These have one position for use (up) and a stowed   position   (down).
They
  can   also   be   removed.
To
  remove   a   head   restraint:
F
 
r
elease   the   backrest   using   control   1,
F
 
t
ilt   the   backrest   2   slightly   for wards,
F

p
ull the head restraint upwards to the stop,
F
 
t
hen,   press   the   lug   A. F
 
M
ove   the   corresponding   front   seat   for ward  
i

f   necessary.
F

P
osition the seat belt between the outer
and centre head restraints to avoid
trapping
  the   belt   when   repositioning   the  
s

eat   backrest.
F

P
lace the head restraints in the low
position. F

P
ull control 1 for wards to release the seat
back
  2.
F
 
F
old   the   seat   back   2   on   to   the   cushion.
ne

ver drive with the head restraints
removed;
  they   must   be   in   place   and  
c

orrectly
 adj
usted.
Folding the backrest
Bench seat with fixed one-piece cushion and split backrest (left hand 2/3, right hand 1/3) which can be   folded   individually   to   adapt   the   load   space   in   the   boot.
Comfort

98
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Mirrors
Each fitted with an adjustable mirror glass permitting t he la teral r earward v ision n ecessary f

or   overtaking   or   parking.   They   can   also   be  
f

olded   for   parking   in   confined   spaces.
Demisting - Defrosting Adjustment
F Move control A
  to   the   right   or   to   the   left   to  s
elect   the   corresponding   mirror.
F

M
ove control B in all four directions to
adjust.
F

R
eturn control A   to   the   central   position.
Folding
F From  outside:   lock   the   vehicle   using   the  r
emote   control   or   the   key.
F
 
F
rom   inside:   with   the   ignition   on,   pull   the  
c

ontrol A   in   the   central   position   rear wards.
If your vehicle is fitted with heated
mirrors,
 
the
 
demisting-defrosting
 
o

perates
 
by
 
switching
 
on
 
the
 
h

eated
 
rear
 
screen.
Refer
 
to
 
the
 
"Rear
 
screen
 
demist-
defrost"
 s

ection. As
 
a
 
safety
 
measure,
 
the
 
mirrors
 
should
 
b

e
 
adjusted
 
to
 
reduce
 
the
 
blind
 
spots.
The
 
objects
 
observed
 
are,
 
in
 
reality,
 
c

loser
 
than
 
they
 
appear.
Take
 
this
 
into
 
account
 
in
 
order
 
to
 
c

orrectly
 
judge
 
the
 
distance
 
of
 
vehicles
 
a

pproaching
 
from
 
behind. If
  the   mirrors   are   folded   using   control   A,
they will not unfold when the vehicle is
unlocked.
  Pull   again   on   control   A.
Door mirrors
Comfort

99
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Automatic tilting in reverse gear
System which provides a view of the ground during   parking   manoeuvres   in   reverse   gear.
Programming
F With  the   engine   running,   engage   reverse  g
e a r.
F
 
S
elect   and   adjust   the   left-hand   and   right-
hand
  mirrors   in   succession.
The
  adjustment   is   stored   immediately.
Switching on
F With  the   engine   running,   engage   reverse  g
e a r.
F

M
ove control A   to   the   right   or   to   the   left   to  
s

elect   the   corresponding   mirror.
The
  glass   of   the   mirror   selected   tilts  
d

ownwards, in accordance with its
programming.
Switching off
F Exit   reverse   gear   and   wait   ten   seconds.
or
F

R
eturn control A   to   the   central   position.
The
  mirror   glass   returns   to   its   initial   position.
The
  mirror   glass   also   returns   to   its   initial  
p

osition:
-
 
i
f   the   speed   exceeds   6   mph   (10   km/h),
-
 
i
f   the   engine   is   switched   off.
Unfolding
F From  outside:   unlock   the   vehicle   using   the  r
emote   control   or   the   key.
F
 
F
rom   inside:   with   the   ignition   on,   pull   the  
c

ontrol A   in   the   central   position   rear wards.
If
  necessary   the   mirrors   can   be   folded  
m

anually.
The
  folding   and   unfolding   of   the   door  
m

irrors   using   the   remote   control   can   be  
d

eactivated by a CITR
oËn
dealer or a
qualified
 w

orkshop.
4
Comfort

119
C4-2_en_Chap06_visibilite_ed01-2015
C4-2_en_Chap06_visibilite_ed01-2015
Model without AUTO lighting
Model with AUTO lightingA. Main  lighting   mode   selection   ring:   turn   it  t
o   position   the   symbol   required   facing   the  
ma

rk.
Manual controls
The lighting is controlled directly by the driver by   means   of   the   ring   A   and   the   stalk   B.
Lighting off / daytime running lamps.
Automatic illumination of headlamps.
B.
 S

talk
 
for   switching   headlamps:   pull  
t

he
 
stalk   towards   you   to   switch   the  
l

ighting   between   dipped   and   main   beam  
h

eadlamps.
In
 
the
 
lamps   off   and   sidelamps   modes,   the  
d

river
 
can
  switch   on   the   main   beam   headlamps  
t

emporarily   ("headlamp   flash")   by   maintaining   a  
p

ull
 
on
 
the   stalk.
Sidelamps.
Dipped
  headlamps   or   main   beam  
h

eadlamps.
Displays
Illumination of the corresponding indicator lamp   in   the   instrument   panel   confirms   that   the  
l

ighting   selected   is   on.
Daytime running lamps
Daytime lighting which comes on automatically when   the   engine   is   started   making   the   vehicle  
m

ore   visible   to   other   users.
This
  function   is   assured   by   dedicated   lamps.
6
Visibility

122
C4-2_en_Chap06_visibilite_ed01-2015
C4-2_en_Chap06_visibilite_ed01-2015
Parking lamps
Side markers for the vehicle by illumination of the   sidelamps   on   the   traffic   side   only.
F
 
W
ithin   one   minute   of   switching   off   the  
i

gnition,   operate   the   lighting   control   stalk  
u

p   or   down   depending   on   the   traffic   side  
(

for   example:   when   parking   on   the   left;  
l

ighting   control   stalk   upwards;   the   right  
h

and   sidelamps   are   on).
This
  is   confirmed   by   an   audible   signal   and  
i

llumination   of   the   corresponding   direction  
i

ndicator   warning   lamp   in   the   instrument   panel.
To
  switch   off   the   parking   lamps,   return   the  
l

ighting   control   stalk   to   the   central   position.
Manual guide-me-home
lighting
The temporary illumination of the dipped beam headlamps   after   the   vehicle's   ignition   has   been  
s

witched   off   makes   the   driver's   exit   easier  
w

hen   the   light   is   poor.
Switching on
F With  the   ignition   off,   "flash"   the   headlamps  u
sing   the   lighting   stalk.
F
 
A
  further   "headlamp   flash"   switches   the  
f

unction   off.
Switching off
The manual guide-me-home lighting switches off   automatically   after   a   set   time.
Visibility

127
C4-2_en_Chap06_visibilite_ed01-2015
C4-2_en_Chap06_visibilite_ed01-2015
Cornering lighting
With dipped or main beams, this function makes   use   of   the   beam   from   a   front   foglamp  
t

o   illuminate   the   inside   of   a   bend,   when   the  
v

ehicle   speed   is   below   25   mph   (approximately  
4

0   km/h)   (urban   driving,   winding   road,  
in

tersections,
 par
king
 m
anoeuvres...). with cornering lighting
without cornering lighting
Switching on
The system operates:
-  w hen   the   corresponding   direction   indicator  
i

s switched on,


or
-
 
f
rom   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel.
Switching off
The system does not operate:
-  b elow   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel,
-
 
a
bove   25   mph   (40   km/h),
-
 
w
hen   reverse   gear   is   engaged.
Programming
The system is activated or 
d eactivated in the vehicle
configuration
 m

enu.
The
  system   is   activated   by   default.
6
Visibility