Page 162 of 401

160
For vehicles without a multifunction screen, the range indicator
appears in the instrument panel screen.
In the event of a fault with the the SCR emissions control systema system that prevents engine starting
i s activated automatically from
650
miles (1 100 km) after confirmation
of a fault with the SCR emissions
control system. Have the system
checked by a CITR
oËn
dealer or a
qualified workshop as soon as possible. In the event of the detection of a fault
If it is a temporary fault, the alert
disappears during the next journey,
after a self diagnosis test of the SCR
emissions control system.
The UREA, SERVICE and diagnostic warning
lamps comes on, accompanied by an audible
signal.
The alert is triggered when driving, when
the fault is detected for the first time, then
when switching on the ignition for subsequent
journeys, while the fault persists.
If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), the SERVICE and engine diagnostic
warning lamps come on and the UREA warning
lamp flashes, accompanied by an audible signal
and the temporary display in the instrument
panel of "
n
o ST
aR
T I
n" a
nd a distance,
indicating the remaining range express in
miles or kilometres before engine starting is
prevented
- (e.g.: "NO START IN 350 miles"
means "Starting will be prevented in 350 miles").
While driving, this display appears every
30
seconds while the fault with the SCR system
persists.
The alert is repeated when switching on the
ignition.
You should go to a CITR
oËn
dealer or a
qualified workshop as soon as possible.
Other wise, you will not be able to restart your
engine. During an authorised driving phase
(between 650 miles and 0 miles) (1 100 km and 0 km)
Practical information
Page 163 of 401

161
You have exceeded the authorised
driving limit: the starting prevention
system inhibits engine starting.
Every time the ignition is switched on, the
SERVICE and engine diagnostic warning
lamps come on and the UREA warning lamp
flashes, accompanied by the temporary display
of "NO START IN" and 0 miles or kilometres
-
("NO START IN 0 miles" means "Starting
prevented"). Starting prevented
To be able to start the engine, you must call on
a CITROËN dealer or a qualified workshop.
For vehicles fitted a multifunction screen, the range indicator appears
in the screen.
If it is a temporary fault, the alert
disappears during the next journey,
after self-diagnosis of the SCR system.
The UREA, SERVICE and diagnostic warning
lamps comes on, accompanied by an audible
signal and the display of a message "Emissions
fault".
The alert is triggered when driving when the
fault is detected for the first time, then when
switching on the ignition for subsequent
journeys, while the fault persists. In the event of the detection of a fault
If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), the SERVICE and engine diagnostic
warning lamps come on and the UREA warning
lamp flashes, accompanied by an audible
signal and the display of a message
(e.g.: "Emissions fault: Starting prevented
in 150 miles") indicating the remaining range
express in miles or kilometres.
While driving, the message is displayed every
30 seconds while the fault with the SCR system
persists.
The alert is repeated when switching on the
ignition.
You should go to a CITR
oËn
dealer or a
qualified workshop as soon as possible.
Other wise, you will not be able to restart your
engine. During an authorised driving phase (between
650 miles and 0 miles) (1 100 km and 0 km)
11
Practical information
Page 164 of 401
162
You have exceeded the authorised
driving limit: the starting prevention
system inhibits engine starting.
Every time the ignition is switched on, the
SERVICE and engine diagnostic warning
lamps come on and the UREA warning lamp
flashes, accompanied by an audible signal and
the display of the message "Emissions fault:
Starting prevented". Starting prevented
To be able to start the engine, you must call on
a CITROËN dealer or a qualified workshop. Freezing of the AdBlue
® additive
The
a
d
blu
e
® additive freezes at
temperatures below around -11°C.
The SCR system includes a heater
for the
a
dbl
ue
® tank, allowing you to
continue driving in very cold conditions.
Practical information
Page 219 of 401
217
7-inch touch screen tablet
GPS satellite navigation - Multimedia audio - Bluetooth® telephone
Contents
First steps
2 18
Steering mounted controls
2
20
Menus
2
21
Navigation
2
22
Navigation - Guidance
2
30
Traffic
23
4
Radio Media
2
36
Radio
2
42
DAB (Digital Audio Broadcasting) radio
2
44
Media
2
46
Settings
2
50
Internet
2
58
Internet browser
2
59
MirrorLink
® 262
Telephone
2
64
Frequently asked questions
2
72
The system is protected in such a way that it will only operate in
your vehicle.
as a s
afety measure, the driver should only carry out operations
which require prolonged attention while the vehicle is stationary.
The display of the energy economy mode message signals
that the system is about to go into standby. Refer to the Energy
economy (mode) section.
.
Audio and Telematics
Page 220 of 401
218
First steps
Use the buttons arranged below the touch
screen tablet for access to the menu carousel,
then press the virtual buttons in the touch
screen tablet.
Each menu is displayed in one or two pages
(primary page and secondary page).Secondary page
Primary page In very hot conditions, the system may
go into stand-by (screen and sound
completely off) for a minimum period of
5 minutes.
audio and Telematics
Page 221 of 401

219
Volume adjustment (each source is
independent, including traffic announcements
(TA) and navigation instructions).Press Menu
to display the menu
carousel.
Increase volume.
Reduce volume.
Selecting the audio source (depending on
version):
-
"
FM" / "
aM
" / "
d
ab
"
* stations.
-
"
US
b" m
emory stick.
-
J
ukebox*, after first copying audio files to
the internal memory of the system.
-
T
elephone connected by
b
l
uetooth* and
audio streaming Bluetooth* (streaming).
-
M
edia player connected to the auxiliary
socket ( jack, cable not supplied).
*
d
ep
ending on equipment.
Short-cuts: using the touch buttons in the upper
band of the touch screen tablet, it is possible
to go directly to the selection of audio source,
the list of stations (or titles, depending on the
s o u r c e).
The screen is of the "resistive" type, it
is necessary to press firmly, particularly
for "flick" gestures (scrolling through a
list, moving the map...). A simple wipe
will not be enough. pressing with more
than one finger is not recognised.
The screen can be used when wearing
gloves. This technology allows use at
all temperatures.
Following prolonged operation in very
high temperatures, the volume may be
limited to protect the system. The return to
normal takes place when the temperature
in the passenger compartment drops. To clean the screen, use a soft
non-abrasive cloth (spectacles cloth)
without any additional product.
do n
ot use pointed objects on the
screen.
Do not touch the screen with wet
hands.
.
audio and Telematics
Page 225 of 401
223
Level 1Level 2 Level 3 Comments
Navigation Settings
Navigation Enter destination
di
splay recent destinations.
Calculatory criteria Fastest
Choose the navigation criteria.
The map displays the route chosen according to
these criteria.
Shortest
Time/distance
Ecological
To l l s
Ferries
Tr a f f i c
Strict-Close
Show route on map
di
splay the map and start navigation.
Confirm Save the options.
Save current location Save the current address.
Stop navigation
de
lete the navigation information.
Voice synthesis Choose the volume for voice and announcement
of street names.
Diversion
de
tour from your initial route by a determined
distance.
Navigation Display in text mode
Zoom in.
Zoom out.
di
splay in full screen mode.
Use the arrows to move the map.
Switch to 2D map.
.
Audio and Telematics
Page 227 of 401
225
Level 1Level 2 Level 3 Comments
Navigation
Secondary page
Enter destination Address
Curr. location
add
ress settings.
Points of Interest
Town centre
Save Save the current address.
Add waypoint Add a waypoint to the route.
na
vigate toPress to calculate the route.
Contacts
add
ressesSelect a contact then calculate the route.
View
na
vigate to
Search for contact
Call
From map Display the map and zoom to view the roads.
Itinerary Create, add or delete a waypoint or view the
itinerary.
Stop
de
lete navigation information.
Navigate to Press to calculate the route.
.
Audio and Telematics