2015 CHRYSLER TOWN AND COUNTRY bulb

Exterior Bulbs
Bulb Number
Headlamp – (Low and High Beam Halogen)H11LL
Headlamp (HID – If Equipped) Low BeamD1S
Fog Lamp – If EquippedH11LL
Front Side MarkerW5W
Front Park/Turn SignalPY27/7W or 3757A
Rear Turn Signal Lamp3757A
Rear Tail, Stop, and Side Marker LampLED (Serviced at Authorized Dealer)
Center High-Mounted Stop LampLED (Serviced at Authorized Dealer)
Backup Lamp3157
License168
672 MAINTAINING YOUR VEHICLE

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
High Intensity Discharge Headlamps (HID) — If
Equipped
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off and the key removed.Because of
this, you should not attempt to service a headlamp bulb
yourself. If a headlamp bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high voltage occurs at the bulb sockets of
High Intensity Discharge (HID) headlamps when the
headlamp switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE:On vehicles equipped with High Intensity Dis-
charge (HID) headlamps, when the headlamps are
turned on, there is a blue hue to the lamps. This dimin-
ishes and becomes more white after approximately 10
seconds, as the system charges.
7
MAINTAINING YOUR VEHICLE 673

Quad Headlamps
1. Raise the hood to access the high or low beam bulbs at
the rear of the headlamp housing.
2. Release the two tabs on the side of the connector and
remove the connector from the bulb.
3. Twist the headlamp bulb and pull the bulb from the
headlamp housing.
4. Install the new headlamp bulb and twist until locked
into the headlamp housing.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
5. Reconnect the wiring connector to the bulb.
Front Park/Turn Signal Lamps
1. Raise the hood to access the rear of the headlamp
housing.
2. Twist the turn signal socket and remove from the
headlamp housing, then pull the bulb out.
3. Push the new bulb into the socket and reinstall the
socket by twisting until locked into the headlamp
housing.
674 MAINTAINING YOUR VEHICLE

Front Side Marker Lamp
1. Raise the hood to access the rear of the headlamp
housing.
NOTE:Access is somewhat limited. You may have to
remove the inner fender well or remove the headlamp
housing for bulb replacement.
2. Twist the socket and remove from the headlamp
housing, then pull the bulb out.
3. Push the new bulb into the socket and reinstall the
socket by twisting until locked into the headlamp
housing.
Front Fog Lamp
NOTE:Access to the fog lamp bulb is from the rear of
the fascia. On the left rear side of the fascia, remove the
push pin and lower the hinged access door on the air
dam.
1. From behind the bumper fascia, or the access panel on
the air dam, twist the bulb counterclockwise, and
remove bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
7
MAINTAINING YOUR VEHICLE 675

2. Disconnect wire harness from the bulb.
3. Reconnect the wiring harness to the new bulb and
reinstall the bulb by twisting clockwise.
Rear Turn Signal And Backup Lamp
1. Raise the liftgate.
2. Remove the tail lamp assembly by removing the two
screws from the inboard side. Use a fiber stick or
similar tool to gently pry the light on the outboard side
to disengage the two ball studs.
Tail Lamp Mounting Screws
676 MAINTAINING YOUR VEHICLE

NOTE:
•If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
•The PRY location is best closest to the studs while
dislodging them separately.
3. Twist the socket and remove it from the lamp assem-
bly.
4. Pull the bulb to remove it from the socket.
5. Replace the bulb, reinstall the socket, and reattach the
lamp assembly.
Center High-Mounted Stop Lamp (CHMSL)
The CHMSL uses LED lamps that are not serviceable
separately. The CHMSL must be replaced as an assembly,
see your authorized dealer.
License Lamp
The license plate lamp is located under the tailgate light
bar and above the license plate.
1. Using a small screwdriver, press inward the locking
tab on the outboard side of the lamp assembly and
pull down on the lamp assembly for removal.
2. Twist and remove the socket from the lamp assembly
and pull the bulb out to remove.
3. Push the bulb into the socket, twist the socket into the
lamp assembly and reinstall the lamp assembly into
place ensuring the locking tab is secure.
7
MAINTAINING YOUR VEHICLE 677

Parking..............................501
Warning Light.........................331
Brake/Transmission Interlock.................486
Bulb Replacement.........................673
Bulbs, Light.............................131
Calibration, Compass......................352
Camera, Rear............................262
Capacities, Fluid..........................678
Caps, Filler
Fuel.................................560
Power Steering.........................500
Radiator (Coolant Pressure)................648
Carbon Monoxide Warning..................127
Cargo Compartment
Luggage Carrier........................307
Cargo (Vehicle Loading)....................298
Car Washes.............................655
Cellular Phone...........................155
Center High Mounted Stop Light..............677
Certification Label.........................562
Chains, Tire.............................539
Changing A Flat Tire.......................595
Chart, Tire Sizing.........................518
Check Engine Light (Malfunction Indicator Light) . .328
Checking Your Vehicle For Safety..............127
Checks, Safety...........................127
Child Restraint...........................102
Child Restraints
Booster Seats..........................107
Center Seat LATCH......................116
Child Restraints........................102
Child Seat Installation....................119
How To Stow An Unused ALR Seat Belt.......117
Infants And Child Restraints...............105
Install A LATCH-compatible Child Restraint....116
Installing Child Restraints Using The Vehicle Seat
Belt.................................118
704 INDEX

iPod®/USB/MP3 Control
Bluetooth® Streaming Audio...............190
Jack Location............................596
Jack Operation...........................595
Jump Starting............................614
Key Fob
Arm The Alarm.........................18
Disarm The Alarm.......................19
Programming Additional Key Fobs...........17
Programming Additional Transmitters.........17
Key-In Reminder..........................15
Keyless Enter-N-Go........................40
Keyless Entry System.......................21
Key, Replacement..........................16
Key, Sentry (Immobilizer)....................15
Lane Change Assist........................237
Lap/Shoulder Belts.........................65
Latches................................131
Hood................................229
Lead Free Gasoline........................551
Leaks, Fluid.............................131
Life of Tires.............................537
Liftgate.................................58
Light Bulbs..............................131
Lights.................................131
Airbag................................98
Alarm...............................331
Anti-Lock.............................326
Automatic Headlights....................231
Back-Up..............................676
Battery Saver..........................239
Brake Assist Warning....................511
Brake Warning.........................331
Bulb Replacement.......................671
Center Mounted Stop....................67710
INDEX 711