2015 AUDI RS7 SPORTBACK oil capacity

Bead
means the part of the tire that
is made of steel wires, wrapped
or reinforced by ply cords and
that is shaped to fit the rim .
Bead separation
means a breakdown of the bond
between components in the
bead.
Cord
means the strands forming the
plies in the tire.
Cold tire inflation pressure
means the tire pressure recom­
mended by the vehicle manu­
facturer for a tire of a designat­
ed size that has not been driven
for more than a couple of miles (kilometers) at low speeds in
the three hour period before
the tire pressure is measured or
adjusted.
Curb weight
means the weight of a motor
vehicle with standard equip­
ment including the maximum
capacity of fuel, oil, and cool­
ant, air conditioning and addi­
tional weight of optional equip­
ment.
Tires and wheels 229
Extra load tire
means a tire design to operate
at higher loads and at higher inflation pressures than the
corresponding standard tire. Extra load tires may be identi­
fied as "XL", "xl", "EXTRA
LOAD", or "RF" on the sidewall.
Gross Axle Weight Rating ("GAWR")
means the load-carrying capaci­
ty of a single axle system,
measured at the tire-ground in­
terfaces.
Gross Vehicle Weight Rating ("GVWR")
means the maximum total
loaded weight of the vehicle.
Groove
means the space between two
adjacent tread ribs.
Load rating (code)
means the maximum load that
a tire is rated to carry for a giv­
en inflation pressure. You may
not find this information on all
tires because it is not required by law.
•
•
'

Tires and wheels 241
not exceeded. Vehicle load in- rear for total seating capacity •
eludes everybody and every- of 4. Each seating position has • '
thing in and on the vehicle. a safety belt¢ page 130, Safe-
These load limits are technical-ty belts.
ly referred to as the vehicle's
The fact that there is an upper
Gross Vehicle Weight Rating limit to your vehicle's Gross Ve-
("GVWR"). hicle Weight Rating means that
The "GVWR" includes the the total weight of whatever is
weight of the basic vehicle, all being carried in the vehicle is
factory installed accessories, a limited. The more passengers
full tank of fuel, oil, coolant in the vehicle or passengers and other fluids plus maximum who are heavier than the stand-
load . The maximum load in- ard weights assumed mean
eludes the number of passen- that less weight can be carried
gers that the vehicle is intend-as luggage.
ed to carry ("seating capacity") The tire pressure label on your
with an assumed weight of
Audi also lists the maximum
150 lbs (68 kg) for each pas- combined weight of all of the
senger at a designated seating occupants and luggage or other
position and the total weight of cargo that the vehicle can carry.
any luggage in the vehicle. For the location of the label
The
Gross Axle Weight Rating ¢ page 233, fig. 195.
("GAWR") is the maximum load
_& WARNING
that can be applied at each of ~ -
Overloading a vehicle can
the vehicle's two axles.
cause loss of vehicle control,
The Gross Vehicle Weight Rat- a crash or other accident, se-
ing and the Gross Axle Weight rious personal injury, and
Rating are listed on the safety even death.
compliance sticker label locat-
-Carrying more weight than
ed on the driver's side B-pillar. your vehicle was designed
M N
Your Audi has 4 seating posi- to carry will prevent the ve-0:: <.J 'SI:
tions, 2 in the front and 2 in the hicle from handling properly ~ .... \!) 1.1'1
.... 1.1'1 ....

2 78 Emergency situations
heavy components such as the engine
b lock or transmiss io n are removed.
- W he n removing heavy components like
these, ancho r vehicle to ho ist o r add cor­
responding weig hts to ma inta in the cen ­
ter of g ravity . Othe rwise, the vehicle
might tilt or s lip off t he hoist, causing
ser ious p erson al injury.
(D Note
-Be awa re of the follow ing points befo re
li fting the vehicle:
- The vehicle should never be lifted or
jacked up from underneath the engine oil pan, the transmission housing, the
front or rear axle or the body side
membe rs. This could lead to ser ious
damage.
- To avoid damage to the underbody or
chassis frame , a rubber pad must be
i nserted between the floor jack and
the l ift points.
- Before driving over a workshop hoist,
check that the veh icle weight does not
exceed the permissible lifting capacity
of the hoist .
- Before driving over a workshop hoist,
ensure that there is sufficient clear­
ance between the hoist and low parts
of the vehicle.

28 0 Techni cal data
designated s eating position) and luggage
w eight ¢.&, .
Gross Axle W eight Rating
The Gross Axle Weight Rating is the maximum
l oad that can be applied at each axle of the
vehicle ¢Lr!, .
Vehicle cap acit y weight
The vehicle capac ity we ight (max . load) is list­
ed either on the dr iver's side B-pilla r or inside
the fuel filler flap.
_& WARNING
- T he actual Gross Axle Weight Rat ing at
the front and rear axles shou ld not ex­
ceed the permissible weights, and their
combination must not exceed the Gross
Vehicle Weight Rating .
Dimensions
Length
Width
Width (across mirror s)
Height (unloaded) al
-
-Exceeding permissible weight ratings can
result in veh icle damage, acc idents and
personal injury.
(D Note
- The vehicle capacity weight figures apply
when the load is distributed evenly in the
vehicle (passengers and luggage). When
transport ing a heavy load in the luggage
compartment, carry the load as near to
the rear axle as poss ible so that the vehi­
cle's handling is not impaired .
- Do not exceed the maximum permissible axle loads or the maximum gross veh icle
we ight. Always remember that the vehi­
cle's handling w il l be affected by the ex­
tra load. Therefo re, adj ust your speed ac­
cordingly.
- Always observe local regulat ions .
in (mm )
197.3 (5012)
i n (mm) 75.2 (1911)
in (mm) 84.2 (2139)
in (mm) 55.9 (1419)
al The he igh t of the veh icle depen ds on the t ire s and th e su spen sion .
When driving up steep ramps, on rough roads,
over curbs, etc . it is important to remember
that som e parts of your veh icle, such as spoil-
Capacities
Fuel tank: total capacity
W indsh ield flu id conta iner
Winds hield and headlight washe r fluid containe ir* ers or exhaust system components, may be
close to
the ground . Be carefu l not to damage
them .
gal (liters) approx. 19 .8 (75.0)
quarts (liters) approx. 3. 7 (3.5)
quarts (liters) approx. 5.2 (4.9)