2015 AUDI Q3 change time

M N M N
0 ::i co
rl I.O
"' rl
"' rl
Brake fluid
Checking brake fluid level
The brake fluid level can be checked with a
quick glance.
N
N
;:;;
" 03
"'
Fi g. 149 Eng ine compartment: Cover on the brake flu ­
id reservoir
Before you check anything in the engine com­
partment,
a lwa ys read and heed all WARN­
ING S c:> .&.. in Working in the engine compart­
ment on page 179 .
~ Read the brake fluid level from the brake
fluid reservoir
c:> fig. 149, <=> page 181,
fig . 145.
The brake flu id level must be be­
tween the "MIN" and "MAX" markings.
The brake fluid reservoir is located at the rear
partition of the engine compartment on the
left side <::;>
page 181 .
The fluid level may drop slightly after some
time due to the automatic adjustment of the
brake pads . This is not cause for alarm .
If the brake fluid level falls
considerably be­
low the "MIN" mark, the brake warning/indi­
cator light (USA models: ., Canada models:
• will come on
<::;> page 13. Do not continue
to operate the vehicle . The complete brake
system should be thorough ly checked by an
author ized Audi dealer or qua lified workshop
and the cause corrected.
If the brake fluid lev­
e l is too low, the brake warning/indicator ligh t
will illuminate . Contact an authorized A ud i
dealer
immediately.
@ Tips
The brake f luid reservoir is located under­
neath the cover .
Checking and fillin g 189
Changing brake fluid
Have the brake fluid changed by on experi­
enced technician.
Brake fluid absorbs moisture from the air. If
the water content in the brake fluid is too
high, corrosion in the brake system may result
after a period of time . The boiling point of the
brake flu id will also dec rease considerably and
decrease braking pe rformance.
Therefore, the brake fluid must be changed
ev ery two years. Always use new brake flu id
which conforms to Federal Motor Vehicle
Standard "F MVSS 116 DOT 4".
The brake fluid reservo ir can be d iff icult to
reach, the refore, we recommend that you
have the brake fluid changed by your author­
i zed
Audi d ealer. Your dealer has t he correct
tools, the right brake fl uid and t he know-how
to do this for you .
A WARNING -.
-Brake fluid is poisonous . It must be stor­
ed only in the closed original container
out of the reach of children!
- Brake failure can resu lt from o ld or inap­
propriate brake f luid. Observe these pre­
cautions:
- Use only brake fluid that meets SAE
spe cificat ion
J 1 7 03 and conforms to
Federa l Moto r Ve hicl e Standard 116.
Always check with yo ur authorized Audi
dealer to make sure yo u are using the
correct bra ke fluid. The correct type of
brake f luid is also indicated on the
brake f luid reservoir.
- The brake fluid must be new. Heavy use
of the brakes can cause a vapor lock if
the brake fluid is left in the system too
l ong . This can seriously affect the effi­
c iency of the brakes as well as your
safety. This cou ld resu lt in an accident.
(D Note
Brake fluid will damage the paint of your
vehicle .

M N
M N
0 ::i co ,...., \!) 1.1"1 ,...., 1.1"1 ,....,
Tires and wheels 197
Gross Vehicle Weight Rating ("GVWR") Ply
means the maximum total loaded weight of
the vehicle .
Groove
means the space between two adjacent tread
ri bs.
Load rating (code)
means the maximum load that a tire is rated
to carry for a given inflat ion pressure . You
may not find this informat ion on all tires be­
cause it is not requ ired by law.
Maximum load rating
means the load rating for a t ire at the max i­
mum permissible inflation pressure for that
tire .
Maximum loaded vehicle weight
means the sum of:
(a) Curb weight
(b) Accesso ry weight
(c) Vehicle capacity weight, and
(d) Production opt ions we ight
Maximum (permissible) inflation pressure
means the maximum co ld inf lation pressure
to which a tire may be inflated . Also called
"maximum inflation pressure."
Normal occupant weight
means 150 lbs . (68 kilograms) times the
number of occupants seated in the vehicle up
to the tota l seating capacity of your vehicle.
Occupant distribution
means distribution of occupants in a veh icle.
Outer diameter
means the overall diameter of an inflated new
tire .
Overall width
means the linear distance between the exteri­
ors of the sidewalls of an inflated tire, includ­
ing e levations due to labeling, decorations, or
protective bands or ribs. means a layer of
rubber-coated parallel cords.
Production options weight
means the combined weight of those installed
regular production opt ions we ighing over 5
lbs. (2.3 kg) in excess of those standa rd items
which they replace, not previously considered
in curb weight or accessory weight, including
heavy duty brakes, ride levelers, roof rack,
heavy duty battery, and spec ial trim.
Radial ply tire
means a pneumatic tire in which the ply cords
that extend to the beads are laid at substan­
tially 90 degrees to the centerline of the
tread.
Recommended inflation pressure
see r::!;> page 196, Cold tire inflation pressure .
Reinforced tire
means a tire design to operate at higher loads
and at higher inflation pressures than the cor­
responding standard tire. Reinforced tires
may be identified as "XL", "xl", "EXTRA LOAD",
or "RF" on the sidewal l.
Rim
means a metal support for a tire or a t ire and
tube assembly upo n which the tire beads are
seated .
Rim diamete r
means nominal diameter of the bead seat. If
you change your wheel s ize, you wi ll have to
purchase new tires to match the new r im di­
ameter .
Rim size designation
means rim diameter and width.
Rim width
means nominal distance between rim flanges.
Sidewall
means that portion of a t ire between the
tread and bead .
•
•

200 Tires and wheels
you have stored. The system does not recog­
nize the load condition of your vehicle.
The effectiveness of the tire pressure monito r­
ing system* will be impaired if you store nor­
mal load pressures but then operate the vehi ­
cle at its maximum load¢.&. .
See the illustration¢
fig. 152 for the location
of the label on driver's side 8-pillar (color of
the actua l label and exact location on the ve­
hicle wi ll vary slightly).
Note that the following table is accurate at
the time of going to press and is subject to
Model Tire designation
Engine
Q3: 235/50
Rl8 97H
2.0 liter All Season
4 -cylinder
235/50 Rl8 97V
All Season
255/40 Rl9 96Y
High Performan ce
255/35 R20 97Y xl
High performance
change. In the event of discrepancies, the tir e
pressure label is located on the driver's side 8-
pillar always takes precedence.
T he table below lists the recommended cold
ti re inflation pressures for the Audi mode l
covered by your Owner's Literature at the vehi­
cle's capacity weight and the t ire sizes instal­
l ed on the respective models as original
equipment, or as a factory option.
Tire pressure
normal load condition full load condition (up to 3 occupants)
front rear front rear
PSI kPA PSI kPA PSI kPA PSI kPA
33 220 33 220 34 230 36 250
33 220 33 220 34 230 36 250
34 230 34
230 44
300 47
320
34 230 34 230 44 300 47 320
xl= reinforced or extra load tire. It may also appear as XL, EXTRA LOAD, or RF on the tire side-
wall.
The correct tire pressure for the spare wheel is
located on a label on the driver's side 8 -pillar.
Because technical changes may be made to
vehi cle equipment dur ing the model year, al­
ways compare the tire size designation on the
tire pressure labe l on your vehicle with the
tires on your vehicle . Make sure that the tire
size information on the veh icle label is the
same as the size of the t ires on the vehicle.
This is especially important if the vehicle be­
longs to someone else or you bought the vehi­
cle with different rims/tires or you bought the
vehicle as a previously owned vehicle.
Remember, your safety and that of your pas­
sengers also depends on mak ing sure that
load limits are not exceeded . Vehicle load in- eludes
everybody and everything in and on the
vehicle. These load limits are technically refer­
red to as the vehicle's Gross Vehicle Weight
Rat ing ("GVWR"). The Gross Axle We ight Rat­
ing ("GAWR") is the maximum load that can
be applied at each of the vehicle's two axles.
The Gross Vehicle Weight Rating and the
Gross Axle Weight Rating are listed on the
safety compliance sticker label located on the
dr ive r's side 8-pillar. The tire pressure labe l on
you r Audi lists the max imum combined
weight of all of the occupants and luggage or
other cargo that the ve hicle can carry. For the
location of the tire pressure label
~fig . 152. .,..

248 Index
l
Jack . . . . . . . . . . . . . . . . . . . . . . . . . 216, 221
Jump-starting ... ... ... .... .. .. .. .. . 228
Jumper cables ............. .. .. .. ... 229
K
Key ..... .... ................ ..... .. 29
Battery replacement . . . . . . . . . . . . . . . . 30
Ignition/engine on/off . . . . . . . . . . . . . . . 66
Ignition key . . . . . . . . . . . . . . . . . . . . . . . 29
Key replacemen t . . . . . . . . . . . . . . . . . . . 29
removing .. ..... ........... ... .. .. 67
unlocking/locking ........ .. . 30, 31, 33
Keys No key identified . . . . . . . . . . . . . . . . . . . 69
Kick-down tiptronic . . . . . . . . . . . . . . . . . . . . . . . . . . 85
L
La ne Change Assistant
refer to Side assist .......... .. .... .. 75
LATCH .. .. .. ................ ... ... 146
Description ........... .... ... .. .. . 147
I nstall ing a chi ld restraint .. .. .. .... . 148
L ocat ion ..... ........... .. .. .. .. . 147
Mounting and releasing the anchorage
hook .... ................. .. .... . 148
Leather cleaning/protection ... .. .. .. . 173
Leaving home ............. .. .. .. .. .. 42
Lifting vehicle ... .......... .. .. .. .. . 232
Light adaptive light ............. ... .. .... 40
Adjusting exterior lighting . .. .. .. .. .. 42
ambience lighting . ... .. .. .. .. .. .. .. 44
Com ing/ Leaving home ....... .. .. .. . . 42
Daytime running lights ........ .... . . 40
Emergency flashers . . . . . . . . . . . . . . . . . 43
Exterior lighting .................... 40
Fog lights/rear fog lights .. .. .. .... .. 40
Headlight range control system ....... 40
High beam assist .... .... ... .. .. ... . 41
Interior/reading lights ..... .. .. .. .. . . 43
L ow beam .. ..... ........... ... .. .. 40
Side marker lights ........ .. .. .. .. .. 40 Light/rain
sensor
Headlights . ..... ................ .. 40
Intermittent (windshield w ipers) ...... 46
Sen sor defective .. ......... .... .... . 19
Lights High beam .... .. ................ .. 41
Turn signals ..... .................. 41
Loading the luggage compartment . .. .. 100
Locking Rear lid . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Locking/unlocking at the lock cylinder ................ .. 33
by remote control ............... .. . 30
with the central locking switch . .. .... . 32
wi th the convenience key ........ .. .. . 31
Low beams ..... .. ................ .. 40
Lower universal anchorages (Canada) ... 146
Luggage compa rtment . . . . . . . . . . . . . . . . 59
Cargo net . . . . . . . . . . . . . . . . . . . . . . . . . 60
Cover ...... ... .. .. ... ........... .. 59
Enlarging . . . . . . . . . . . . . . . . . . . . . . . . . 60
Floor ........ ... .. .............. .. 62
Lid ..... .. .. .. .. .. ........... .. .. . 34
Pass-through .. .. ............. .. .. . 61
Ski sack ... .. .. . ............ ...... . 61
Stowing .. .... .. .. .............. . 100
Tie-downs . . . . . . . . . . . . . . . . . . . . . . . . . 60
also r efe r to Loading the luggage com­
partment . . . . . . . . . . . . . . . . . . . . . . . . 100
Lumbar support ... ............. .... . 51
M
Maintenance .. .. .. ... ... ... .... .... 237
Malfunc tion Indicator Lamp (MIL) . . 17, 26
Manual shift program ................. 84
Master key
Battery replacement . . . . . . . . . . . . . . . . 30
Matte finish paint cleaning ....... .. .. 170
Mileage Average ........................... 22
Instantaneous ... ................ .. 22
Mirrors Adjusting the exterior mirrors .. .. .... . 44
Compass .. .. .. .. ... .......... .... . 48
dimming . ..... .. ............. ..... 45
Vanity mirrors ... .................. 46

It has always been Audi's policy to continu­
ously improve its products . Audi, therefore,
reserves the right to make changes in design
and specifications, and to make additions or improvements in its products, without incur­
r ing any obligation to install them on prod­
ucts previous ly manufactured .
Text, illustrat ions and specifications in th is
manual are based on the most up-to-date in­
formation available at the time of printing.
All rights reserved. May not be reproduced or
translated in whole or in part without the written consent of AUDI AG
. Specifications are
subject to change witho ut notice .
Editorial deadline: 01/31/2014
@ For the sake of the environment
Printed on environmentally friendly paper
(bleached without chlorine, recyclable).
Printed in Germany
© 2014 AUDI AG