2015 Alfa Romeo 4C engine oil

CHECKING LEVELS.
The topping-up plug B and the dipstick A for checking the engine oil level and the reservoir C for the engine coolant can be
accessed by lifting the tailgate (see the procedure in the "Engine cover/Luggage Compartment" paragraph in the "Knowing
your car" chapter).
21)
118) 119) 120)
119A0L0152
145

ENGINE OIL
Check that the oil level is between the
MIN and MAX marks on the dipstick
A fig. 119.
For this check, take out the dipstick
from its seat, clean it with a lint-free
cloth, reinsert the dipstick; take it out
again and check the oil level.
121)
If the oil level is near or under the MIN
mark, add oil through the filler B fig.
119 until it reaches the MAX mark.
22)
Take out the engine oil dipstick A, clean
it with a lint-free cloth and reinsert it.
Extract the engine oil dipstick again and
check that the level is between the
MIN and MAX marks on the dipstick.
121)
Make sure to tighten the oil plug in
its seat thoroughly after possibly
topping the oil up.
The range between the MIN and MAX
levels corresponds to approximately
1 litre of oil.
Engine oil consumption
23)3)
The maximum engine oil consumption
is usually 400 grams every 1,000 km.When the car is new, the engine needs
to run in, therefore the engine oil
consumption can only be considered
stabilised after the first 5,000 - 6,000
km.
IMPORTANT After adding or changing
the oil, let the engine run for a few
seconds and wait a few minutes after
stopping it before you check the level.
ENGINE COOLANT
24)122)
The coolant level must be checked
when the engine is cold and must
range between the MIN and MAX
marks on the reservoir.
If the level is too low, unscrew reservoir
plug C fig. 119 and add the fluid
described in the "Fluids and lubricants"
paragraph of the "Technical
Specifications" chapter.
WINDSCREEN WASHER
FLUID
123) 124)
To check the windscreen washer fluid
level, proceed as follows:
❒to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the
"Maintenance and care" chapter;❒loosen the 4 self-tapping screws A
fig. 121 using the supplied
screwdriver. Remove the engine
cover grille;
❒release the plug from the opening;
❒leaving the plug close to the opening,
put a finger on the central hole B fig.
122 in the plug and remove it: the
level can be seen on the control pipe
C fig. 123 due to capillarity;
❒after the check, reinsert the plug B
with the control pipe C in the initial
position;
❒reposition the engine cover grille and
tighten the 4 self-tapping screws A.
WARNING Re-close the plug holding it
horizontally (not directed towards the
engine cover) to prevent the opening
tang from remaining locked in a position
difficult to reach.
121A0L0130
147

If the fluid level in the reservoir is not
sufficient, proceed as follows:
❒take the black funnel for topping up
the brake fluid and its extension
pipe from the service kit in the
luggage compartment;
❒loosen the reservoir plug and
introduce the funnel F fig. 126 with
the extension pipe in the reservoir
inlet;
❒after topping up, remove the funnel F
with the extension pipe;
❒tighten the reservoir plug;
❒reposition the protection panel and
tighten the 2 self-tapping screws E.
WARNING Be very careful while
removing the plug from the opening to
prevent the plug from falling inside
the vehicle body.
IMPORTANT
21) Be careful not to confuse the
various types of fluids while
topping up: they are not
compatible with each other!
Topping up with an unsuitable
fluid could severely damage your
vehicle.
22) The oil level should never exceed
the MAX mark.
23) Do not add oil with specifications
other than those of the oil already
in the engine.24) PARAFLU
UPanti-freeze fluid is
used in the engine cooling
system; use the same fluid type as
that already in the cooling system
when topping up. PARAFLU
UP
may not be mixed with other types
of anti-freeze fluids. If topping up
with an unsuitable product, under
no circumstances start the engine
and contact a dedicated Alfa
Romeo Dealership.
25) Avoid allowing brake fluid, which
is extremely corrosive, to come
into contact with painted areas.
Should it happen, immediately
wash with water.
26) Be very careful while topping up
the brake fluid, as it could drip
from the extension pipe inside the
vehicle under the engine cover
and on parts of the body and
windscreen, corroding and
damaging them. Adopt suitable
protection (e.g absorbing paper)
to reduce this risk as much as
possible.
125A0L0149126A0L0160
149

WARNING
118) The Alfa Romeo 4C is designed
and produced for road use, in
compliance with the current
regulations. Vehicle use in the
track must be considered as
occasional and in any case under
the responsibility of the user.
The vehicle CANNOT be modified
or tampered with for any reason,
this would alter the Manufacturer
homologation and/or safety
requirements. Using a modified or
tampered product relieves the
Manufacturer from any
responsibility on it and may
expose people to serious risks.
119) Never smoke when performing
operations in the engine
compartment. Flammable gases
and fumes may be present, with
the risk of fire.
120) Be very careful when working in
the engine compartment if the
engine is hot: risk of burns.121) If the engine oil is being topped
up, wait for the engine to cool
down before loosening the filler
plug, particularly for cars with
aluminium plug (for versions/
markets, where provided).
WARNING: risk of burns!
122) The cooling system is
pressurised. If necessary, only
replace the plug with another
original one or the operation of
the system may be adversely
affected. Do not remove the
reservoir plug when the engine is
hot: risk of burns.
123) Do not travel with the
windscreen washer reservoir
empty: the windscreen washer is
essential for improving visibility.
Repeated operation of the system
without fluid could damage or
cause rapid deterioration of some
system components.
124) Certain commercial additives
for windscreen washer fluids are
inflammable. The engine
compartment contains hot
components which may set it on
fire.125) Brake fluid is poisonous and
highly corrosive. In the event of
accidental contact, immediately
wash the affected parts with
water and mild soap. Then rinse
thoroughly. Call a doctor
immediately if swallowed.
126) Thesymbol on the container
indicates a synthetic brake fluid,
which is different from a mineral
fluid. Using a mineral fluid will
damage the special rubber seals
of the braking system beyond
repair.
IMPORTANT
3) Used engine oil and oil filters
contain substances which are
harmful to the environment. You
are advised to go to a dedicated
Alfa Romeo Dealership to have
the oil and filters changed.
150
SERVICING AND MAINTENANCE

FLUIDS AND LUBRICANTS
Your car is equipped with an engine oil that has been thoroughly developed and tested in order to meet the requirements of the
Scheduled Servicing Plan. Constant use of the prescribed lubricants guarantees the fuel consumption and emission
specifications. Lubricant quality is crucial for engine operation and duration.
PRODUCT SPECIFICATIONS
UseFluid and lubricant specifications for a correct
use of the carGenuine fluids and
lubricantsReplacement interval
Lubricant for
petrol engines
31)
SAE 5W-40 ACEA C3 grade totally synthetic
lubricant.
FIAT 9.55535-GH2 classification.SELENIA SPORT
POWER
Contractual Technical
Reference No. F052.H12According to
Scheduled Servicing
Plan
In case of emergency, if lubricants with the prescribed specifications are not available, products with the minimum indicated
ACEA performance can be used for topping up; in this case optimal performance of the engine is not guaranteed.
IMPORTANT
31) The use of products with specifications other than those indicated above could cause damage to the engine not
covered by the warranty.
179

– checking levels .......................... 145
– washing .................................... 157
Engine coolant indicator ................. 64
Engine cover
– Closing ...................................... 40
– Opening .................................... 39
Engine
– engine cooling system fluid
level........................................... 147
– identification codes ................... 164
– marking ..................................... 163
– technical data............................ 165
Engine oil
– consumption ............................. 147
– level check ................................ 147
EOBD system ................................ 49
ESC (Electronic Stability Control)
system ......................................... 42
Exterior lights ................................. 28
Extinguisher ................................... 36
Filling the tank ............................... 58
Fitting "Universal" child restraint
system ......................................... 96
Fix&Go automatic kit ...................... 119
Flashing ......................................... 28
Fluids and lubricants
(specifications) ............................. 179
Follow Me Home device ............. 29
ront airbags................................. 99
Fuel consumption .......................... 182Fuel cut-off system......................... 33
Fuel level gauge ............................. 64
Fuel supply..................................... 166
Fuses (replacement) ....................... 133
Gear Shift Indicator ....................... 64
Handbrake.................................... 105
Hazard warning lights..................... 33
HBA system ................................... 44
Headlights...................................... 41
– Adjusting the headlights
abroad ...................................... 41
– bulb replacement ...................... 129
– Light beam direction.................. 41
Heating and ventilation ................... 22
Hill Holder system .......................... 44
Identification data
– bodywork paint plate ................. 162
– chassis marking ........................ 162
– engine marking.......................... 163
Identification data
– identification data plate.............. 162
Ignition switch ................................ 14
– Steering lock ............................. 15
Installing electrical/electronic
devices ........................................ 50
Instrument panel ............................ 62
Interior fittings ................................ 34
Interiors (cleaning) .......................... 157
Jack.............................................. 122
Light clusters
– front light clusters (changing a
bulb).......................................... 129
– rear light clusters (changing a
bulb).......................................... 130
Lubricants (specifications) .............. 179
Luggage compartment / Engine
cover............................................ 39
Luggage compartment
– Opening .................................... 39
Luggage compartment roof light
– bulb replacement ...................... 132
Main beam headlights .................. 28
– bulb replacement ...................... 129
Maintenance and care
– heavy-duty use of the car .......... 144
– periodic checks ......................... 144
– scheduled servicing ................... 140
– scheduled servicing plan ........... 141
Manual climate control ................... 25
Menu options ................................. 66
Number plate lights
– bulb replacement ...................... 131
Oddments pocket......................... 35
On-board instruments
– display....................................... 62
– engine coolant temperature
indicator .................................... 64
– fuel level gauge ......................... 64
– On-board instruments ............... 62

F