Page 187 of 249
Vehicle care185
Sidelight/daytime running light (1)
Low beam (2)
High beam (3)
Front turn signal lights 3 188.
Low beam
1. Rotate the cap (2) anticlockwise
and remove it.
2. Press the clip to disengage bulbholder. Withdraw the bulb holder
from the reflector.
3. Detach the bulb from the bulb holder and replace the bulb.
4. Insert the bulb holder with the clip
downwards and engage into the
reflector until it clicks.
5. Install cap.
Page 189 of 249
Vehicle care187
2. Press both clips together andwithdraw the bulb socket from theheadlamp housing.
3. Remove the bulb from the socket by pulling.
4. Replace and insert new bulb into socket.
5. Insert the bulb socket into the headlamp housing and turn
clockwise.
Sidelight/daytime running light
with LEDs Sidelights and daytime running lights
are designed as LEDs and cannot be
changed. Consult a workshop in case
of a defective LED.
Xenon headlights9 Danger
Xenon headlights work under
extremely high electrical voltage.
Do not touch. Have bulbs replaced by a workshop.
Sidelight/daytime running lights are
designed as LEDs and cannot be
changed.
Bulbs for corner lighting can be
changed.
Front turn signal lights 3 188.
Corner lighting
1. Rotate the cap (3) anticlockwise
and remove it.
Page 190 of 249
188Vehicle care
2. Rotate the bulb holderanticlockwise to disengage.
Withdraw the bulb holder from the
reflector.
3. Remove the bulb from the plug connector by disengaging and
pulling.
4. Replace the bulb. Connect and engage bulb holder with the plug
connector.
5. Insert the bulb holder into the reflector and rotate clockwise to
secure.
6. Fit the cap and rotate clockwise.
Fog lights
The bulbs are accessible from the
underside of the vehicle.
1. Turn the bulb holder anti- clockwise and remove it from the
reflector.
2. Disengage the bulb socket from the plug connector by pressing
the retaining lug.
3. Remove and replace the bulb socket with bulb and attach the
plug connector.
4. Insert the bulb socket into the reflector by turning clockwise and
engage.
Front turn signal lights
Front turn signal lights consist of long- life bulbs which cannot be changed.
Consult a workshop in case of a
defective long-life bulb.
Page 192 of 249
190Vehicle care
5. Remove and replace the bulb bypushing the bulb slightly into thesocket and rotating anticlockwise:
Tail light/Brake light 1
Turn signal light 2
6. Insert and turn bulb clockwise into
the tail light assembly. Fit light
assembly with the retaining pins
into the recesses of the vehicle
body and tighten the plastic
securing nuts from inside the load
compartment.
Close cover and engage.
Reversing light/rear fog light The description of bulb replacement
is the same for both lights.
1. Remove screw in the tailgate.
2. Move light assembly slightly to the
outside, then withdraw from the
tailgate.
3. Remove the bulb holder by turning.
Page 193 of 249
Vehicle care191
4. Remove the bulb by pushingslightly into the socket and
rotating anticlockwise. Replace
the bulb.
5. Insert the bulb socket into the assembly and turn to secure.
6. Attach light assembly into the tailgate and secure with the
screw.
Side turn signal lights
To replace bulb, remove lamp
housing:
1. Slide lamp to its left side and remove with its right end.
2. Turn bulb holder anticlockwiseand remove from housing.
3. Pull bulb from bulb holder and replace it.
Page 203 of 249
Vehicle care201
The menu can be selected by
pressing the buttons on the turn
signal lever.
Press the MENU button to select the
Vehicle Menu .
Turn the adjuster wheel to select the
tyre pressure monitoring system.
Baselevel display and Midlevel
display:
The tyre pressure for each tyre is
displayed on its own page.
Uplevel display:
The tyre pressures for all tyres are
displayed on one page.
System status and pressure warnings
are displayed by a message
indicating the corresponding tyre in the DIC.
A detected low tyre pressure
condition is indicated by the control
indicator w 3 91.
If w illuminates, stop as soon as
possible and inflate the tyres as
recommended 3 237.
If w flashes for 60-90 seconds and
then illuminates continuously, there is
a fault in the system. Consult a
workshop.
After inflating, some driving may be
required to update the tyre pressure
values in the DIC. During this time w
may illuminate.
Page 205 of 249

Vehicle care203
Select■ Light for comfort pressure up to
three people
■ Eco for Eco pressure up to
three people
■ Max for full loading
TPMS Sensor Matching
Process
Each TPMS sensor has a unique
identification code. The identification
code must be matched to a new
wheel position after rotating the
wheels or exchanging the complete
wheel set and if one or more TPMS sensors were replaced. The TPMS
sensor matching process should also
be performed after replacing a spare
wheel with a road wheel containing
the TPMS sensor.
The malfunction light w and the
warning message or code should go
off at the next ignition cycle. The
sensors are matched to the wheel
positions, using a TPMS relearn tool,
in the following order: left side front
wheel, right side front wheel, right
side rear wheel and left side rear
wheel. The turn signal light at the
current active position is illuminated
until sensor is matched.
Consult your workshop for service or
to purchase a relearn tool. There are
2 minutes to match the first wheel
position, and 5 minutes overall to
match all four wheel positions. If it
takes longer, the matching process stops and must be restarted.
The TPMS sensor matching process
is:
1. Apply the parking brake.
2. Turn the ignition on.3. On vehicles with automatic transmission: set the selector
lever to P.
On vehicles with manual
transmission automated: Press
and hold brake pedal. Move and
hold the selector lever for
5 seconds in position N until P is
displayed in the DIC. P indicates
that the sensor matching process
of the TPMS can be started.
On vehicles with manual
transmission: select neutral.
4. Use the MENU button on the turn
signal lever to select the Vehicle
Menu in the DIC.
5. Turn the adjuster wheel to scroll to
the tyre pressure menu.
Baselevel display and Midlevel
display:
Page 245 of 249

243
Control indicators.......................... 85
Control of the vehicle .................128
Controls ........................................ 74
Convex shape .............................. 28
Coolant and antifreeze ...............223
Corner lighting ............................ 111
Cruise control ...................... 92, 147
Cupholders .................................. 56
Curtain airbag system .................. 46
D Danger, Warnings and Cautions ...3
Daytime running lights ...............110
Declaration of conformity ............239
Diesel fuel system bleeding .......184
Diesel particle filter ...............91, 134
Door open .................................... 93
Doors ............................................ 25
Driver assistance systems ..........147
Driver Information Centre .............93
Driving characteristics and towing tips .............................. 171
Driving hints ................................ 128
E Easy entry..................................... 37
Electric adjustment ......................28
Electrical system......................... 193
Electronic climate control system 121Electronic driving programmes .
........................................ 138, 142
Electronic Stability Control.......... 145
Electronic Stability Control and Traction Control system ............90
End-of-life vehicle recovery .......177
Engine compartment fuse box ...194
Engine coolant ........................... 180
Engine coolant temperature gauge ....................................... 84
Engine data ............................... 230
Engine exhaust .......................... 134
Engine identification ...................226
Engine oil ................... 178, 223, 227
Engine oil pressure ......................91
Entry lighting .............................. 116
Event data recorders ..................240
Exit lighting ................................ 116
Exterior care .............................. 219
Exterior light ................................. 92
Exterior lighting ....................12, 108
Exterior mirrors ............................. 28
F
Fault ................................... 138, 143
First aid ......................................... 71
First aid kit ................................... 71
Fixed air vents ........................... 126
Flex-Fix system ............................ 58
Fog light ....................................... 92Fog lights ................................... 188
Folding mirrors ............................. 28
Following distance indication ......152
Forward collision alert................. 150
Front airbag system .....................44
Front fog lights ........................... 113
Front seats.................................... 35
Front storage ................................ 57
Front turn signal lights ...............188
Fuel............................................. 168
Fuel consumption - CO 2-
Emissions ............................... 170
Fuel for diesel engines ..............169
Fuel for petrol engines ...............168
Fuel gauge ................................... 83
Fuses ......................................... 193
G Gauges ......................................... 82
Gear shifting ................................. 89
General information ...................171
Glovebox ..................................... 56
Graphic-Info-Display .....................99
H
Halogen headlights ....................184
Hand brake ......................... 143, 144
Hazard warning flashers ............112
Headlight flash ........................... 109
Headlight range adjustment ......110