||
09 Wheels and tyres
09
326* Option/accessory, for more information, see Introduction.
5. Screw together the towing eye with the
wheel wrench* until the stop position in accordance with the following figure.
IMPORTANT
The towing eye must be screwed into all threads in the wheel bolt wrench.
6. Loosen the wheel bolts ½-1 turn anti-clockwise with the wheel wrench.
WARNING
Never position anything between the ground and the jack, nor between the jackand the car's jacking point.
7. There are two jacking points on each sideof the car. There is a recess in the plastic cover at each point. Crank the foot of thejack down so it is pressed squarely on theground.
IMPORTANT
The ground must be firm, smooth and level.
8. Lift the car so that the wheel is free.Remove the wheel bolts and lift off the wheel.
Related information
• Changing wheels - fitting (p. 327)
• Jack* (p. 321)
• Warning triangle (p. 329)
• Wheel bolts (p. 320)
ProCarManuals.co’
||
10 Maintenance and service
10
342
Jacking points (arrows) for the jack that belongs to the car and lifting points (marked in red).
If the car is raised with a front workshop jack then it must be positioned under one of thefour lifting points furthest in under the car. Ifthe car is raised with a rear workshop jackthen it must be positioned under one of thelifting points. Ensure that the workshop jackis positioned so that the car cannot slide offthe jack. Always use axle stands or similar. If the car is raised with a two-pillar workshop lift then the front and rear lifting arms can bepositioned under the outer lifting points (jack-ing points). Alternatively, the inner liftingpoints can be used at the front.
Related information
• Changing wheels - removing wheels (p. 324)
ProCarManuals.co’
