2014 VAUXHALL VIVARO lights

124Vehicle careBulb replacement
Switch off the ignition and turn off the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Headlights
Low beam and high beam1. Remove harness connector.
2. Remove rubber seal.
3. Release retaining clip and remove
bulb.
4. Renew bulb and install retaining clip ensuring that bulb is in correctorientation.
5. Install rubber seal and harness connector.
Sidelights1. Remove bulb holder from reflector
housing by rotating through 90°.
2. Renew bulb.
3. Install bulb holder in reflector housing.
Fog lights
Have bulbs replaced by a workshop.

Vehicle care125Front turn signal lights
1.Remove bulb holder from reflector
housing by rotating through 90°.
2. Renew bulb.
3. Install bulb holder in reflector housing.
Tail lights
Rear brake, turn signal and tail lights
1. Remove 3 screws (using the tool supplied).
2. Carefully pull lamp assembly from
retaining pins on the outer side
and remove.
3. Twist bulb holder to separate from
lamp assembly.
4. Renew bulb.
5. Push to install the bulb holder into
the lamp assembly - then twist to
secure.
6. Check that the wiring harness is located correctly.
7. Replace lamp assembly into original position, ensuring that it isseated correctly.
8. Fit lamp assembly onto retaining pins and replace 3 screws.

126Vehicle careSide turn signal lights
1. Release clips from wing using aflat blade screwdriver and lift out
lamp assembly from aperture.
2. Remove bulb holder from lamp assembly by rotating through 90°
and renew bulb.
3. Install bulb holder in lamp assembly and install lamp
assembly into aperture.
Centre high-mounted
brake light
Have bulbs replaced by a workshop.
Reversing light
1. Remove 2 screws (using the tool supplied) and remove lamp
assembly.
2. Twist bulb housing to separate from lamp assembly.
3. Renew bulb.
4. Push to install the bulb holder into
the lamp assembly - then twist to
secure.
5. Install lamp assembly with 2 screws.
Number plate light
1. Remove 2 screws (arrowed) and remove lens.
2. Renew bulb.
3. Re-install lens and replace screws.

Vehicle care127Fog tail light
1. Remove 2 screws (using the toolsupplied) and remove lamp
assembly.
2. Twist bulb housing to separate from lamp assembly.
3. Renew bulb.
4. Push to install the bulb holder into
the lamp assembly - then twist to
secure.
5. Install lamp assembly with 2 screws.
Interior lights
Front courtesy light
1. Remove lens using a flat blade screwdriver.
2. Renew bulb.
3. Reinstall lens assembly.
Load compartment light
1. Remove lamp assembly using a flat blade screwdriver.
2. Gain access to bulb by removing rear cover on lamp assembly.
3. Renew bulb and install rear cover.
4. Reinstall lamp assembly.
Rear courtesy lights
Have bulbs replaced by a workshop.
Glovebox light
Have bulbs replaced by a workshop.

130Vehicle care
SymbolApplicationZAir conditioningdHeated exterior mirrorsUHeated front seats,Power windowsLLeft-hand high beamNRight-hand high beamKWindscreen wiperZRadio, Infotainment system)Cigarette lighterBoilerRear passenger compart‐
ment heaterjHornaLeft-hand low beamWRight-hand low beameInstrument panelZHeatingdInterior lampSymbolApplicationuAntilock brake systemÜHeated rear windows+Clock, interior lights, radio,
Infotainment systemUCH
INJFuel injection systemfRear window washereRear widow wiperTLeft-hand sidelightSRight-hand sidelightUCentral locking:Electrically adjustable exte‐
rior mirrorsCStop control indicator,
daytime running lightsrRear fog lights>Front fog lightsSymbolApplication?Power outletTTachograph

Vehicle care141
far away from the discharged
vehicle battery as possible,
however at least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump start.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of
1 minute.
3. Allow both engines to idle for approx. 3 minutes with the leads
connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
The towing eye is stowed with the
vehicle tools 3 131.
Screw the towing eye fully into the
front towing point.
Attach a tow rope - or better still a tow
rod - to the towing eye, never to the
bumper or front suspension units.
Caution
Do not tow the vehicle from the
rear. The front towing eye must
only be used for towing and not
recovering a vehicle.
Caution
Activate the child locks in the rear
doors if the rear seats are
occupied. Child locks 3 23.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wipers.
Transmission in neutral.
If neutral cannot be selected on
vehicles with manual transmission automated, the vehicle must only betowed with the drive wheels raised off the ground.

Vehicle care143Appearance care
Exterior care
Locks The locks are lubricated at the factoryusing a high quality lock cylinder
grease. Use de-icing agent only when
absolutely necessary, as this has a
degreasing effect and impairs lock function. After using de-icing agent,
have the locks regreased by a
workshop.
Washing The paintwork of your vehicle is
exposed to environmental influences.
Wash and wax your vehicle regularly.
When using automatic vehicle
washes, select a programme that
includes waxing.
Bird droppings, dead insects, resin,
pollen and the like should be cleaned off immediately, as they contain
aggressive constituents which can
cause paint damage.If using a vehicle wash, comply with
the vehicle wash manufacturer's
instructions. The windscreen wipers
and rear window wiper must be
switched off. Remove antenna and
external accessories such as roof
racks etc.
If you wash your vehicle by hand,
make sure that the insides of the
wheel housings are also thoroughly
rinsed out.
Clean edges and folds on opened
doors and the bonnet as well as the
areas they cover.Caution
Always use a cleaning agent with
a pH value of 4 to 9.
Do not use cleaning agents on hot surfaces.
Have the door hinges of all doors
greased by a workshop.
Do not clean the engine compartment with a steam-jet or high-pressure jet
cleaner.
Thoroughly rinse and leather-off the vehicle. Rinse leather frequently. Use
separate leathers for painted and
glass surfaces: remnants of wax on
the windows will impair vision.
Exterior lights
Headlight and other light covers are
made of plastic. Do not use any
abrasive or caustic agents, do not use an ice scraper, and do not clean them
dry.
Polishing and waxing Wax the vehicle regularly (at the
latest when water no longer beads).
Otherwise, the paintwork will dry out.
Polishing is necessary only if the paint
has become dull or if solid deposits
have become attached to it.
Paintwork polish with silicone forms a
protective film, making waxing
unnecessary.
Plastic body parts must not be treated with wax or polishing agents.

167
Coolant and antifreeze...............147
Coolant heater .............................. 87
Coupling ball bar ........................113
Cruise control ...................... 73, 104
Cupholders .................................. 56
Curtain airbag system .................. 46
D Danger, Warnings and Cautions ...3
Dashboard .................................... 10
Daytime running light ....................79
Declaration of conformity ............164
Diesel fuel filter .......................... 122
Diesel fuel system bleeding .......123
Diesel particle filter ......................95
Doors ............................................ 24
Driver Information Centre .............74
Driving characteristics and towing tips .............................. 112
Driving hints .................................. 93
E Electric adjustment ......................28
Electrical system......................... 128
Electronic driving programmes ....99
Electronic Stability Program 72, 103
End-of-life vehicle recovery .......116
Engine air filter ........................... 119
Engine air flow indicator .............119
Engine coolant ........................... 119Engine coolant temperature ........72
Engine data ............................... 154
Engine exhaust ............................ 95
Engine identification ...................150
Engine oil ................... 117, 147, 152
Engine oil level ............................ 76
Engine oil level monitor ................67
Engine oil pressure ......................73
Event data recorders ..................164
Exhaust gases .............................. 95
Exit lighting .................................. 83
Exterior care .............................. 143
Exterior light ................................. 73
Exterior lighting ......................12, 79
Exterior mirrors ............................. 28
F
Fault ........................................... 100
First aid kit ................................... 58
Fixed air vents ............................. 91
Fog light ....................................... 73
Fog lights .............................. 81, 124
Fog tail light ............................... 127
Folding mirrors ............................. 28
Front airbag system .....................45
Front fog lights ............................. 81
Front seats.................................... 33
Front storage ............................... 56
Front turn signal lights ...............125
Fuel............................................. 109Fuel consumption - CO 2-
Emissions ............................... 111
Fuel for diesel engines ..............110
Fuel for petrol engines ...............109
Fuel gauge ................................... 66
Fuse box ..................................... 129
Fuses ......................................... 128
G Gauges ......................................... 65
General information ...................112
Glovebox ..................................... 55
H Hand brake - see Parking brake. 102
Hazard warning flashers ..............81
Headlight flash ............................. 80
Headlight range adjustment ........80
Headlights ...................... 79, 80, 124
Headlights when driving abroad ..81
Head restraint adjustment .............8
Head restraints ............................ 32
Heated mirrors ............................. 29
Heated rear window ..................... 31
Heating ........................................ 35
Heating and ventilation system ...84
High beam ............................. 73, 80
Horn ....................................... 14, 61