2014 VAUXHALL VIVARO warning

Keys, doors and windows25Load compartment
Tailgate
Opening
After unlocking with the remote
control, press tailgate button and lift tailgate to the fully open position.
The tailgate can be also opened from inside the vehicle by pushing down
the tailgate interior release.
Notice
In very cold climates, the opening
assistance provided by the tailgate
hydraulic struts may be reduced.
Central locking system 3 20.
Closing
Close tailgate using the interior strap. Ensure tailgate is fully closed.
Central locking system 3 20.
General hints for operating tailgate9 Danger
Do not drive with the tailgate open
or ajar, e.g. when transporting
bulky objects, since toxic exhaust
gases, which can not be seen or
smelled, could enter the vehicle.
This can cause unconsciousness
and even death.
Caution
Ensure there is adequate
clearance both above (at least
2.15 m) and behind when opening
tailgate.
Vehicle security
Anti-theft locking system9 Warning
Do not use the system if there are
people in the vehicle! The doorscannot be unlocked from the
inside.
The system deadlocks all doors and
the tailgate.
All doors and the tailgate must be
closed or the system cannot be
activated.
Notice
The anti-theft locking system cannot be activated when the hazard
warning lights or sidelights are
switched on.
Activation and deactivation are not possible with the central locking
switch.

26Keys, doors and windows
Activation
Press button e twice.
- or -
Turn key in driver's door lock towards
rear of vehicle twice.
Deactivation
Unlock the doors with the key or
button c on the remote control.
Anti-theft alarm system
The anti-theft alarm system is
operated in conjunction with the
central locking system.
It monitors:
■ Doors, tailgate, bonnet
■ Passenger compartment,
■ Load compartment,
■ Vehicle inclination, e.g. if it is raised
■ Ignition
■ Interruption of alarm siren power supply.
Activation All doors and the bonnet must be
closed.Press button e to activate anti-theft
alarm system. Hazard warning lights flash twice to confirm activation.
If the hazard warning lights do not flash upon activation, a door or the
bonnet is not fully closed.
Deactivation
Unlocking the vehicle or switching on the ignition deactivates the anti-theft
alarm system. Hazard warning lights
flash once to confirm deactivation.
Notice
If the alarm has been triggered,
unlocking the vehicle with the key
will not stop the alarm siren. To stop
the siren, switch on the ignition. The hazard warning lights will not flash
upon deactivation if the alarm has
been triggered.
Activation without monitoring of
passenger compartment
Disable monitoring of the passenger
compartment e.g. when animals are
being left in the vehicle, or if the
auxiliary heater 3 87 has been set
for a timed or remote controlled start.

Keys, doors and windows27
Press and hold button e; an audible
signal will sound as confirmation.
The status will remain until the doors
are unlocked.
Alarm
When triggered, the alarm sounds via a separate battery-backed power
sounder, and the hazard warning
lights flash simultaneously. The
number and duration of alarm signals
are stipulated by legislation.
If the vehicle battery is disconnected
or its power supply is interrupted, the
alarm siren will be triggered. First
deactivate the anti-theft alarm system if the vehicle battery must be
disconnected.
To silence the alarm siren (if
triggered) and therefore deactivate
the anti-theft alarm system, reconnect vehicle battery and unlock vehicle
with remote control button c (or
switch on the ignition).
Immobiliser
The system is part of the ignition
switch and checks whether the
vehicle is allowed to be started with
the key being used.
The immobiliser is activated
automatically after the key has been
removed from the ignition switch and
also if the key is left in the ignition
switch when the engine is turned off.
If the engine cannot be started, switch off the ignition and remove key, wait
approx. 2 seconds and then repeat
the start attempt. If start attempt is
unsuccessful, attempt to start the
engine using the spare key and seek
the assistance of a workshop.Notice
The immobiliser does not lock the doors. You should always lock the
vehicle after leaving it and switch on the anti-theft alarm system 3 20,
3 26.

30Keys, doors and windows
Windscreen stickers
Do not attach stickers such as toll
road stickers or similar on the
windscreen in the area of the interior
mirror.
Manual windows
The door windows can be opened or
closed with the window winders.
Power windows9 Warning
Take care when operating the
power windows. Risk of injury,
particularly to children.
Keep a close watch on the
windows when closing them.
Ensure that nothing becomes
trapped in them as they move.
Power windows can be operated with
the ignition on.
Operate the switch for the respective
window by pushing to open or pulling to close.
For vehicles with automatic feature pull or press the switch again to stop
window movement.
In the event of closing difficulties due
to frost or the like, operate the switch
several times to close the window in
stages.
Rear windows
Sliding side windows
To open, pull up catch and slide open. To close, pull up catch and slide
window until catch engages.
Notice
During window opening or closing,
keep the catch raised to allow the
glass sufficient clearance.

32Seats, restraintsSeats, restraintsHead restraints............................ 32
Front seats ................................... 33
Rear seats ................................... 36
Seat belts ..................................... 39
Airbag system .............................. 42
Child restraints ............................. 48Head restraints
Position9 Warning
Only drive with the head restraint
set to the proper position.
The upper edge of the head restraint
should be at upper head level. If this
is not possible for extremely tall
people, set to highest position, and
set to lowest position for small people.
Adjustment
Pull the head restraint upwards or
push the head restraint downwards.
Notice
Approved accessories may only be
attached to the front passenger seat head restraint if the seat is not in use.

Seats, restraints33
Head restraint removal
To remove the head restraints, pull
lock tab and pull the restraint
upwards.
Stow head restraints securely in load
compartment. Do not drive with head
restraints removed if the seat is
occupied.
Front seats
Seat position9 Warning
Only drive with the seat correctly
adjusted.
■ Sit with buttocks as far back against
the backrest as possible. Adjust the distance between the seat and the
pedals so that legs are slightly
angled when pressing the pedals.
Slide the front passenger seat as
far back as possible.
■ Sit with shoulders as far back against the backrest as possible.
Set the backrest rake so that it is possible to reach the steering
wheel with arms slightly bent.
Maintain contact between
shoulders and the backrest when
turning the steering wheel. Do not
angle the backrest too far back. We recommend a maximum rake of
approx. 25°.
■ Adjust the steering wheel 3 60.
■ Set seat height high enough to have a clear field of vision on allsides and of all display instruments.
There should be at least one hand
of clearance between head and the
roof frame. Thighs should rest
lightly on the seat without pressing
into it.
■ Adjust the head restraint 3 32.
■ Adjust the height of the seat belt 3 40.
■ Adjust the lumbar support so that it
supports the natural shape of the
spine 3 34.

34Seats, restraintsSeat adjustment9Danger
Do not sit nearer than 25 cm from
the steering wheel, to permit safe
airbag deployment.
9 Warning
Never adjust seats while driving as
they could move uncontrollably.
Seat positioning
Pull handle, slide seat, release
handle.
Seat backrests
Pull lever, adjust inclination and
release lever. Allow the backrest to
engage audibly.
Do not lean on seat when adjusting.
Seat height
Lift lever and adjust body weight on
seat to adjust height.

Seats, restraints37
Rear seat access
To facilitate access to the rear seats,
fold the seat backrest forwards. If necessary release the two-latch seatbelt from its buckles.
9 Warning
Ensure that the backrest returns to
its correct position and the seat
belt buckles engage securely.
Fitting seat belt 3 40.
Folding seats
On some variants, the cargo area can
be increased by folding up the rear
seats.
Remove the head restraints 3 32.
Push the seat backrest rearwards 1,
then pull the side handle to release 2.
Fold the backrest forward onto the
seat base 3, if necessary release the
two-latch seat belts from their
buckles.
Release both locking bars at the rear
base of the seat by pulling rearwards
4 .
Lift and fold the seat assembly, until
the seat frame rests in place.9 Warning
When folding the seat use caution
- beware of moving parts. Ensure
the seat is secure when
completely folded.
To return the folding seat to the
upright position, support the seat
assembly and release the bar by
pulling the bar directly towards you.