2014 TOYOTA DYNA 100/150 wheel

v
Table of contents
1 OPERATION OF INSTRUMENTS AND CONTROLSPage
1 Overview of instruments and controls
1 .......................
2 Keys and Doors11 ......................................
3 Seats, Seat belts, Steering wheel and Mirrors23 ...............
4 Lights and Wipers61 .....................................
5 Gauges, Meters and Service reminder indicators67 .............
6 Engine (ignition) switch, Transmission and Parking brake79 ......
7 Air conditioning system83 .................................
8 Other equipment99 ......................................
2 INFORMATION BEFORE DRIVING YOUR TOYOTA 107........
3 STARTING AND DRIVING 123...............................
4 IN CASE OF AN EMERGENCY 141..........................
5 CORROSION PREVENTION AND APPEARANCE CARE 169...
6 MAINTENANCE REQUIREMENTS 175.......................
7DO−IT−YOURSELF MAINTENANCE
1 Introduction179 .........................................
2 Engine and Chassis187 ..................................
3 Electrical components199 .................................
8 SPECIFICATIONS 211......................................
9 INDEX 221................................................
Dyna100/150_EE

SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS23
Section 1−3
OPERATION OF INSTRUMENTS AND
CONTROLS
Seats, Seat belts, Steering wheel and Mirrors
DSeats 24..............................................
DDriver’s seat 24.......................................
DFolding up rear seat 26.................................
DHead restraints 27.....................................
DSeat belts 28..........................................
DSRS driver airbag 38...................................
DChild restraint 44......................................
DTilt and telescopic steering wheel 58....................
DOutside rear view mirrors 59............................
Dyna100/150_EE

24SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS
While the vehicle is being driven, all ve-
hicle occupants should have the seatback
upright, sit well back in the seat and prop-
erly wear the seat belts provided.
CAUTION
DDo not drive the vehicle unless the
occupants are properly seated. Do
not allow any occupants to sit on
top of a folded−down seatback, or
in the luggage compartment or car-
go area. If the occupants are im-
properly seated or restrained by
seat belts, death or serious injury
could result in the event of emer-
gency braking, sudden swerving or
an accident.
DDuring driving, do not allow any
passengers to stand up or move
around between seats. Otherwise,
death or serious injuries can occur
in the event of emergency braking,
sudden swerving or an accident.
Adjust the driver ’s seat so that the foot
pedals, steering wheel and instrument
panel controls are within easy reach of
the driver.
CAUTION
DDo not adjust the seat while the
vehicle is moving as the seat may
unexpectedly move and cause the
driver to lose control of the vehicle.
DWhen adjusting the seat, be careful
that the seat does not hit a lug-
gage.
DAfter adjusting the seat position, re-
lease the lever and try sliding the
seat forward and backward to make
sure it is locked in position.
DMake sure the seatback is securely
locked by pushing forward and rear-
ward on the top of the seatback.
Failure to do so will prevent the
seat belt from operating properly.
DDo not put objects under the driv-
er ’s seat. Otherwise, the objects
may interfere with the seat−lock
mechanism or unexpectedly push
up the seat position adjusting lever
and the seat may suddenly move,
causing the driver to lose control of
the vehicle.
DWhile adjusting the seat, do not put
your hands under the seat or near
the moving parts. Otherwise, you
may catch and injure your hands or
fingers.
Dyna100/150_EE
SeatsDriver’s seat—
—Seat adjustment precautions

SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS25
1. SEAT POSITION ADJUSTING LEVER
Pull the lever up. Then slide the seat
to the desired position with slight body
pressure and release the lever.
2. SEATBACK ANGLE ADJUSTING
LEVER
Lean forward and pull the lever up.
Then lean back to the desired angle
and release the lever.
CAUTION
Avoid reclining the seatback any
more than needed. The seat belt pro-
vides maximum protection in a frontal
or rear collision when the driver is
sitting up straight and well back in
the seat. If you are reclined, the lap
belt may slide past your hips and
apply restraint forces directly to the
abdomen or your neck may contact
the shoulder belt. In the event of a
frontal collision, the more theseat is
reclined, the greater the risk of death
or serious injury.
3. SEAT LUMBAR SUPPORT
ADJUSTING LEVER
Pull the lever forward.
Repeat this until you have a comfortable
support.
Dyna100/150_EE
—Adjusting driver’s seat

26SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS
1. Swing up the bottom cushion.2. Hook the strap.
Dyna100/150_EE
Folding up rear seat

SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS27
When returning the bottom cushion to its
original position, hang the strap on the
hook.
CAUTION
DAny operations should not be made
while the vehicle is moving.
DAfter raising the bottom cushion,
make sure to secure it with the
holding strap.
DWhen returning the bottom cushion
to its original position, observe the
following precautions in order to
prevent death or serious injury in a
collision or sudden stop:
Make sure the bottom cushion is
securely locked by trying to pull up
the edge of the bottom cushion.
Failure to do so will prevent the
seat belt from operating properly.
Make sure the seat belts are not
twisted or caught under the bottom
cushion and are arranged in their
proper position and are ready to
use.
The head restraints can be removed.
For your safety, always use the head
restraints in the locked position.
To remove: Pull it up while pressing the
lock release button.
When an occupant sits on the rear seat,
always pull up the head restraint to the
lock position.
The head restraint is most effective when
it is close to your head. Therefore, using
a cushion on the seatback is not recom-
mended.
CAUTION
DUse the head restraint designed for
each respective seat.
DMake sure the head restraint is
locked in position.
DDo not drive with the head re-
straints removed.
Dyna100/150_EE
Head restraints (rear seats)

28SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS
Toyota strongly urges that the driver and
passengers in the vehicle be properly re-
strained at all times with the seat belts
provided. Failure to do so could increase
the chance of injury and/or the severity of
injury in accidents.
The seat belts provided for your vehicle
are designed for people of adult size,
large enough to properly wear them.
Child.Use a child restraint system ap-
propriate for the child until the child be-
comes large enough to properly wear the
vehicle’s seat belts. Toyota recommends
you use a child restraint system which
conforms to the regulation “ECE No.44”.
See “Child restraint” on page 44 for de-
tails.
Single cab models

:
DIf a child is too large for a child re-
straint system, the child should sit in
the seat and must be restrained using
the vehicle’s seat belt.
DWithout passengers’ seat belts—We
recommend installing thepassengers’
seat belts on your vehicle. Ask any
authorized Toyota dealer or repairer, or
another duly qualified and equipped
professional, if passengers’ seat belts
can be installed on your vehicle. If
installation is possible, put the child in
the passenger ’s seat and use the seat
belt.
Double cab models

:
DWith rear seat belts—If a child is too
large for a child restraint system, the
child should sit in the rear seat and
must be restrained using the vehicle’s
seat belt. According to accident statis-
tics, the child is safer when properly
restrained in the rear seat than in the
front seat.

: See “Model code” on page vi in the
beginning of this manual if you are not
sure of your vehicle model.
DWithout rear seat belts—We recom-
mend installing the rear seat belts on
your vehicle. Ask any authorized
Toyota dealer or repairer, or another
duly qualified and equipped profession-
al, if rear seat belts can be installed
on your vehicle. If installation is
possible, put the child in the rear seat
and use the seat belts. If installation is
not possible, let the child sit in the
front seat and use the seat belt.
If a child must sit in the front seat, the
seat belts should be worn properly.
Do not allow the child to stand up or
kneel on either rear or front seats. An
unrestrained child could suffer serious in-
jury or death during emergency braking or
a collision. Also, do not let the child sit
on your lap. It does not provide sufficient
restraint.
Pregnant woman.Toyota recommends the
use of a seat belt. Ask your doctor for
specific recommendations. The lap belt
should be worn securely and as low as
possible over the hips and not on the
waist.
Injured person.Toyota recommends the
use of a seat belt. Depending on the inju-
ry, first check with your doctor for specific
recommendations.
If seat belt regulations exist in the country
where you reside, please contact any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped pro-
fessional, for seat belt replacement or
installation.
Dyna100/150_EE
Seat belts—
—Seat belt precautions

SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS29
CAUTION
Persons should ride in their seats
properly wearing their seat belts
whenever the vehicle is moving.
Otherwise, they are much more likely
to suffer serious bodily injury or
death in the event of sudden braking
or a collision.
When using the seat belts, observe
the following:
DUse the belt for only one person at
a time. Do not use a single belt for
two or more people—even children.
DAvoid reclining the seatback any
more than needed. The seat belts
provide maximum protection in a
frontal or rear collision when the
driver and the front passenger are
sitting up straight and well back in
the seats. If you are reclined, the
lap belt may slide past your hips
and apply restraint forces directly
to the abdomen or your neck may
contact the shoulder belt. In the
event of a frontal collision, the
more the seat is reclined, the great-
er the risk of death or serious inju-
ry.
DBe careful not to damage the belt
webbing or hardware. Take care that
they do not get caught or pinched
in the seat or doors.
DInspect the belt system periodically.
Check for cuts, fraying, and loose
parts. Damaged parts should be re-
placed. Do not disassemble or
modify the system.
DKeep the belts clean and dry. If
they need cleaning, use a mild soap
solution or lukewarm water. Never
use bleach, dye, or abrasive clean-
ers, or allow them to come into
contact with the belts—they may
severely weaken the belts. (See
“Cleaning the interior” on page 173
in Section 5.)
DReplace the belt assembly (includ-
ing bolts) if it has been used in a
severe impact. The entire assembly
should be replaced even if damage
is not obvious.
Dyna100/150_EE