2014 SKODA FABIA change time

Radio
Using the system
Change frequency range
Your device is capable of receiving a radio reception in the FM and AM analogue frequency range.
›
To change the frequency range, briefly press the RADIO button followed by the
function key FM1, FM2 , AM1 or AM2 .
or
›
Briefly press the RADIO button.
There are 6 memory slots available for each of these frequency range groups.

Searching for and storing radio stations
Manual search
›
Set the frequency of the desired radio station by turning the settings knob
2
.
Automatic station search
›
The device searches for the next radio station in the selected waveband by pressing the button  or  briefly.
Function SCAN
›
Pressing the menu button
2
or the MENU button and then pressing the func-
tion key SCN
8
briefly (for 10 seconds) enables the radio channels of current
waveband to be played.
›
This function is ended by pressing menu knob
2
, which will mean the current
station is played again.
Function AS
›
Press the MENU button and then the
AS
8
function button. An automatic sta-
tion finding is started during which the 6 stations with the strongest signal in the memory level FM1 and/or AM1 are stored.
Store station
›
After selecting the radio station, press the selection button
8
, on which the
station should be stored and hold it pressed in until the radio station briefly switches to mute and a brief signal sounds.

RDS Function
Certain radio stations transmit additional text information - designated as radio
text.
Note
■ The text information must not be available to all radio stations.■Depending on the quality of the signal, the device may need some time in order
to load all the displayed characters.

Traffic news function
Switching on/off
›
Flick the TP switch.
The traffic service are deactivated by flicking the TP
switch again. The displayed
 icon goes out.
Activating/deactivating traffic reports
Functional readiness of the traffic news service is indicated via the 
icon.
During playback in Media mode, the last selected radio station that supports traf-
fic news will continue to be received in the background. If a traffic news station
has not been set recently, then the most appropriate traffic news station is set
automatically in the background. While searching for an appropriate station, TP
SEEK is displayed on the screen.
If the set radio station does not broadcast traffic news, 

is displayed on the
screen.
An incoming traffic report automatically interrupts playback or listening to a radio
station that is not currently transmitting traffic news. INFO and station name is
displayed on the screen. Once the traffic news have ended, the device automati-
cally returns to the original playback mode.
Note
Some radio stations misleadingly identify themselves as traffic programs. It is
therefore not an error with the unit that there are no traffic news on these sta-
tions.
5Radio

CD player
Using the system
Information on how to use a CD
The internal drive can play CD-ROM, CD-R, CD-RW discs.
Insert the CD
With the labelled side facing up, only insert a CD into CD slot
10
until it is auto-
matically drawn in.
The play function will start automatically.
Taking out the CD
Press the 
button – the CD is ejected.
If the “ejected” CD is not taken out within 10 seconds, it will be drawn in again for
safety reasons.
Buttons on the unit for controlling the current audio source
The arrow buttons 
or  on the unit will always affect the audio source current-
ly being listened to, irrespective of the current menu used.

- brief pressing within 2 seconds of playback takes you to the beginning of the
previous track or chapter, or after 2 seconds to the beginning of the current title
or chapter.

- pressing this briefly changes over to the beginning of the next title or chap-
ter, repeated pressing changes over to the beginning of the subsequent title or
chapter.
Changing between the audio sources
Press the MEDIA
button to select the audio source:
CD (internal CD drive), EXT (CD
changer, if it is connected to the device) or AUX.
WARNINGThe CD-player is a laser product. On the manufacturing date, this unit was
classified as a class 1 laser product in accordance with the national/interna-
tional standards DIN EN 60825-1: 2008-05 and DHHS Rules 21 CFR,
Subchapter J classed as a class 1 laser product. The laser used in this class 1 laser product is so weak that there is no risk of danger when operated cor-
rectly. This product is designed such that the laser is restricted to the inside of
the unit. However, the installed laser could be classified in a higher class were the housing to be removed. For this reason, never remove the housing of the
unit.
CAUTION
■ Never insert CDs with the designation “ into the internal drive. Do not insert in
drives without a drawer ” or use Eco Discs.■
After pressing the button  there is a time delay of a few seconds before the
CD is ejected. During this time the lock in front of the CD-slot is open.
■
Be sure to wait until the CD has been fully ejected before you try to insert a new
CD. Otherwise you can damage the drive inside the unit.
■
A dirty, mechanically damaged, unreadable or incorrectly inserted CD can cause
playback problems. The CD may not be playable because of this or may cause it to
jump. Check the CD and insert it properly into the unit. Should problems persist ,
try using another CD and visit a specialist garage if necessary.
■
If the internal temperature of the device is too high, no CDs will be accepted.
The unit switches into the last active operating mode.
■
Never use liquids such as gasoline, paint thinner or record cleaner to clean the
surface of the CD - this may cause damage.
■
Never expose the CD to direct sunlight!
■
Only write on the CD using appropriate pens.
■
Do not stick anything to the CD.
Note
■ Poor or unsealed road surfaces and severe vibrations may cause the CD to jump.■In cold weather or after rain showers, moisture (condensate) may deposit in the
unit. This can effect the CD jump or impair the play function. In that case, wait un- til the moisture has dissipated.■
If a CD is dirty, never clean it in a circular motion, but instead work from the in-
side out. Use a soft, lint-free cloth. For heavy stains, we recommend that you
clean the CD with a commercially available CD cleaner and allow it to dry. 
6CD player

External sources
Using the system
Advice for dealing with external sources
An external audio source connected to the AUX-IN input can be played in the car through the speakers of the device.
External audio sources cannot be controlled via the device.
A different audio source can be selected on the device at any time. As long as the
external audio source is not switched off, it always remains active in the back-
ground.
See the owner's manual of the specific manufacturer for operating the external
audio source.
Conditions for a successful connection
To connect external audio sources via the AUX-IN input a 3,5 mm standard jack
plug is needed. If the external audio source does not have this jack plug, you must
use an adapter.
› Only USB devices with the specification 2.0 can be connected.
› The version of the file allocation table FAT (File Allocation Table) of the connec-
ted device must be FAT16 ( <2 GB) or FAT32 (> 2 GB).
› In order to replay from a unit with a hard disk (HDD) which includes a large data
volume, it can lead to a time delay when reading in the overview of the music
data.
› In order to replay from a unit, which includes a complicated folder structure, it
can lead to a time delay when reading in the overview of the music data.
› The folder structure in the connected unit must not exceed a depth of 8 levels.
One folder must not contain more than 1000°data.
› A USB extension cable or USB distributor (HUB) must not be used to connect
the unit.
Adapter
We recommend that you purchase an adapter for connecting the USB devices, the
devices with Mini USB output or an iPod, at an authorised ŠKODA Service Partner.
Adjust the play function volume of the external audio source
The playback volume of the external audio source can be adjusted via the volume
control on the device.
Depending on the connected audio source, the output volume on the external au-
dio source can be changed.
You can also change the input sensitivity of the external audio source » page 4,
AUX , in order to adapt the play volume of the external audio source to that of the
other audio sources or to avoid distortions .WARNING■ Never place external sources on the console panel. They could be thrown in-
to the passenger compartment during sudden driving manoeuvres, thereby in-
juring the occupants.■
Never place external sources close to the airbags. These could be thrown in-
to the passenger compartment when the airbags are deployed, injuring the
occupants.
■
Never hold external sources in your hand or on your knees while driving.
They could be thrown into the passenger compartment during sudden driving
manoeuvres, thereby injuring the occupants.
■
Always route the connection cable for the external source such that it does
not restrict you when driving.
CAUTION
The AUX-IN input must only be used for audio sources!
Note
■ See the owner's manual of the specific manufacturer for instructions on operat-
ing the external source.■
If an external audio source is connected via AUX-IN, which is equipped with an
adapter for external power supply, it can occur that the audio signal is interrup-
ted. This depends on the quality of the adapter which is used.

AUX input
The input for external audio sources AUX-IN is located below the armrest of the
front seats and is marked with the logo .
›
The AUX-IN jack is activated by pressing the MEDIA button and by pressing the
selection button AUX.
The play function starts automatically after connecting the source. 
8External sources

ŠKODA AUTO a.s. pursues a policy of constant product and model development.We trust that you will understand that changes to models in terms of shape,equipment and engineering, may be introduced at any time. Information regard-
ing appearance, services, dimensions, weight, standards and functions of the ve-
hicle is correct at the time of publication. Some equipment might only be intro- duced at a later date, or might only be offered in certain markets; information is
provided by ŠKODA Partners. It is therefore not possible for legal claims to be
made based on the data, illustrations and descriptions contained in this Owner's
Manual.Reprinting, reproduction or translation, either in whole or in part, is not permitted without the written consent of ŠKODA AUTO a.s.
ŠKODA AUTO a.s. expressly reserves all rights relating to copyright laws.
Subject to change.
Issued by: ŠKODA AUTO a.s.
© ŠKODA AUTO a.s. 2013