2014 Ram ProMaster instrument panel

▫Appearance Care And Protection From
Corrosion .......................... .348
▫
Cleaning The Instrument Panel Cupholders . . . .355
 FUSES ............................. .355
▫ Underhood Fuses ..................... .356
▫ Interior Fuses ....................... .361
▫ Right Central Pillar Fuses ................364
 VEHICLE STORAGE ....................365
 REPLACEMENT BULBS .................365
 BULB REPLACEMENT ..................366
▫ Headlamps Low beam and High beam ......366
▫ Front Turn Signal/Parking Lamps .........367▫
Daytime Running Lamp (DRL)/Front Side
Marker Lamp ....................... .368
▫ Front Fog Lamps ..................... .369
▫ Front, Rear Roof Lamps .................369
▫ Rear Tail, Stop, Backup, Turn Signal And
Rear Side Marker Lamps ................370
 FLUID CAPACITIES ....................370
 FLUIDS, LUBRICANTS AND GENUINE
PARTS ............................. .371
▫ Engine ............................ .371
▫ Chassis ........................... .373
320 MAINTAINING YOUR VEHICLE

Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“Check fuel cap” message will be displayed in the
Electronic Vehicle Information Center (EVIC). Refer to
“Electronic Vehicle Information Center (EVIC)” in ”Un-
derstanding Your Instrument Panel” for further informa-
tion. Tighten the gas cap until aclickingsound is heard.
This is an indication that the gas cap is properly tight-
ened.
Press the odometer reset button to turn the message off.
If the problem persists, the message will appear the next
time the vehicle is started. This might indicate a damaged
cap. If the problem is detected twice in a row, the system
will turn on the MIL. Resolving the problem will turn the
MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
7
MAINTAINING YOUR VEHICLE 323

•For grease stains, apply MOPAR® Multi-Purpose
Cleaner to a clean, damp cloth and remove stain. Use
a fresh, damp towel to remove soap residue.
• Do not use any harsh solvents or any other form of
protectants on Stain Repel products.
Interior Care
Instrument Panel Surfaces
The instrument panel cover has a low glare surface,
which minimizes reflections in the windshield. Do not
use protectants or other products which may cause
undesirable reflections. Use soap and warm water to
restore the low glare surface.
Cleaning Interior Trim
Interior trim should be cleaned starting with a damp
cloth, a damp cloth with MOPAR® Total Clean or equiva-
lent, then MOPAR® Spot & Stain Remover or equivalent if absolutely necessary. Do not use harsh cleaners or
Armor All®. Use MOPAR® Total Clean or equivalent to
clean vinyl upholstery.
Cleaning Leather Upholstery
MOPAR® Total Clean or equivalent is specifically recom-
mended for leather upholstery.
Your leather upholstery can be best preserved by regular
cleaning with a damp soft cloth. Small particles of dirt
can act as an abrasive and damage the leather upholstery
and should be removed promptly with a damp cloth.
Stubborn soils can be removed easily with a soft cloth
and MOPAR® Total Clean or equivalent. Care should be
taken to avoid soaking your leather upholstery with any
liquid. Please do not use polishes, oils, cleaning fluids,
solvents, detergents, or ammonia-based cleaners to clean
your leather upholstery. Application of a leather condi-
tioner is not required to maintain the original condition.
352 MAINTAINING YOUR VEHICLE

Cleaning The Instrument Panel Cupholders
Removal
Pull the flexible liner from the cupholder drawer starting
at one edge to ease removal.
Cleaning
The liner is top shelf dishwasher safe, or you may follow
the cleaning procedure below.
Soak the liner in a mixture of medium hot tap water and
one teaspoon of mild liquid dish soap. Let soak for
approximately 30 minutes. After 30 minutes, pull the
liner from the water and dip it back into the water about
six times. This will loosen any remaining debris. Rinse
the liner thoroughly under warm running water. Shake
the excess water from the liner and dry the outer surfaces
with a clean soft cloth.
Installation
Place the liner into the cupholder drawer and press the
liner into place so that the retention tabs seat into the
corresponding openings in the drawer.
FUSES
WARNING!
•When replacing a blown fuse, always use an appro-
priate replacement fuse with the same amp rating as
the original fuse. Never replace a fuse with another
fuse of higher amp rating. Never replace a blown
fuse with metal wires or any other material. Failure
to use proper fuses may result in serious personal
injury, fire and/or property damage.
(Continued)
7
MAINTAINING YOUR VEHICLE 355

Cavity Mini Fuse DescriptionF61 20 Amp YellowVacuum Pump
(3.6 Gasoline Engine) —
If Equipped
F62 30 Amp GreenTransmission Power
RELE (3.6 Gasoline
Engine) — If Equipped
F64 7.5 Amp BrownUrea Pump (3.0 Diesel
Engine) — If Equipped
F65 25 Amp WhiteUrea NOX Sensor 1–2 —
PM Sensor (3.0 Diesel
Engine) — If Equipped
F66 5 Amp BeigeSTM (3.6 Gasoline
Engine) — If EquippedInterior Fuses
The interior fuse panel is part of the Body Control
Module (BCM) and is located on the driver’s side under
the instrument panel.
Fuse Panel
7
MAINTAINING YOUR VEHICLE 361

MAINTENANCE SCHEDULE
Your vehicle is equipped with an automatic oil change
indicator system. The oil change indicator system will
remind you that it is time to take your vehicle in for
scheduled maintenance.
Based on engine operation conditions, the oil change
indicator message will illuminate in the instrument clus-
ter. This means that service is required for your vehicle.
Operating conditions such as frequent short-trips, trailer
tow, and extremely hot or cold ambient temperatures
will influence when the “Oil Change Required” message
is displayed. Severe Operating Conditions can cause the
change oil message to illuminate as early as 3,500 miles
(5,600 km) since last reset. Have your vehicle serviced as
soon as possible, within the next 500 miles (805 km).
Your authorized dealer will reset the oil change indicator
message after completing the scheduled oil change. If a
scheduled oil change is performed by someone otherthan your authorized dealer, the message can be reset by
referring to the steps described under “Electronic Vehicle
Information Center (EVIC)” in “Understanding Your
Instrument Panel” for further information.
NOTE:
Under no circumstances should oil change inter-
vals exceed 10,000 miles (16,000 km) or twelve months,
whichever comes first.
Severe Duty All Models
Change Engine Oil at 4,000 miles (6,500 km) if the vehicle
is operated in a dusty and off road environment. This
type of vehicle use is considered Severe Duty.
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual
wear or damage
8
M A I
N T
E
N
A
N
C E
S
C
H E
D
U L
E
S376 MAINTENANCE SCHEDULES

Switch................................91
Head Restraints ...........................86
Heated Mirrors ............................74
Heated Seats .............................85
Heater ................................ .186
Heater, Engine Block ...................... .196
High Beam/Low Beam Select (Dimmer) Switch .....93
Hill Start Assist .......................... .223
Hitches Trailer Towing ........................ .267
Hood Release .............................88
Ignition .................................12
Key..................................12
Ignition Key Removal .......................12
Illuminated Entry ..........................18
Immobilizer (Sentry Key) ....................15
Infant Restraint ...........................52
Inside Rearview Mirror ......................72 Instrument Cluster
....................... .127
Instrument Panel and Controls ................125
Instrument Panel Cover .....................352
Instrument Panel Lens Cleaning ...............354
Interior Appearance Care ....................352
Intermittent Wipers (Delay Wipers) .............98
Introduction ..............................4
Jump Starting ........................... .308
Key-In Reminder ..........................14
Key, Replacement ..........................16
Keys ...................................12
Key, Sentry (Immobilizer) ....................15
Lane Change Assist ........................93
Lap/Shoulder Belts .........................28
Latches .................................68
Lead Free Gasoline ....................... .255
398 INDEX