2014 Peugeot RCZ oil

1/
MONITORING
COOLANT TEMPERATURE INDICATOR
With the engine running, when the needle is:
- in zone A , the temperature is correct,
- in zone B , the temperature is too high; the maximum temperature warning lamp and the central STOP warning lamp come on,
accompanied by an audible signal and an alert message in the
screen.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact a PEUGEOT dealer or a qualifi ed workshop.
ENGINE OIL LEVEL INDICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The check of this level is only valid if the vehicle is on a level
surface, with the engine having been off for more than 30 minutes.
After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
 wait for the engine to cool,
 unscrew the cap by two turns to allow the pressure to drop,
 when the pressure has dropped, remove the cap,
 top up the level to the "MAX" mark.

34
Oil level correct
This is indicated by the fl ashing of "OIL" or an alert message in the
instrument panel, accompanied by illumination of the service warning
lamp and an audible signal.
If the lack of oil is confi rmed by a check using the dipstick, it is essential
that the level is topped up to prevent damage to the engine.
Refer to the "Checking levels" section. This is indicated by the fl ashing of
"OIL--" or the appearance of an alert
message in the instrument panel.
Contact a PEUGEOT dealer or a qualifi ed workshop.
In the event of a fault with the electric gauge, the oil level is no lon\
ger
monitored.
If the system is faulty, you should check the engine oil level using the
dipstick under the bonnet.
Refer to the "Checking levels" section.
Lack of oil Indicator fault

2/
ACCESS
BOOT
OPENING
 Press this button for more than two seconds to unlock the boot lid. The boot lid opens slightly.
 Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.
Using the manual control; vehicle unlocked
 Press the opening control above the number plate.
 Lift the boot lid.
CLOSING
 Lower the boot lid using one of the interior grab handles.
 If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: - when the engine is running , this warning lamp comes on, accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (fl at battery), you are advised to
disconnect the battery. - when the vehicle is moving (speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler.

5/
SAFETY
RCZ_EN_CHAP05_SECURITE_ED02-2013
ACTIVE SPOILER
System which improves the aerodynamics and stability of the vehicle
when driving. It can be controlled automatically or manually.
OPERATION
The use of the vehicle must comply with the legislation in force
in your country. This system can be used to its full potential on a
closed circuit.
Automatic mode
The spoiler rises automatically according to the speed and has two
positions.
- When the speed of the vehicle is higher than 50 mph (85 km/h), the spoiler rises automatically to the intermediate position A .
It remains in this position for as long as the speed remains above
35 mph (55 km/h).
- If the speed of the vehicle falls below 35 mph (55 km/h), the spoiler \
retracts automatically.
- When the speed of the vehicle is higher than 95 mph (155 km/h), the spoiler rises automatically to the maximum position B . It remains
in this position for as long as the speed remains above 90 mph
(142 km/h).
- If the speed of the vehicle falls below 90 mph (142 km/h), the spoiler retracts automatically to the intermediate position.
In this mode, the indicator lamp in the control button is off.
Manual mode
To control the operation of the spoiler manually, with the ignition on:
 press the control button briefl y, the spoiler rises to the maximum position B .
In this mode, the indicator lamp on the control button is on.
When stationary or moving at less than 6 mph (10 km/h), press and
hold the button until the indicator lamp goes off, the spoiler then retracts
completely.
Except 1.6 litre THP 270 hp version.

108
RCZ_EN_CHAP05_SECURITE_ED02-2013
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
 raise the spoiler to the maximum position B by pressing the
button briefl y,
 once the cleaning is complete, retract the spoiler: press and hold the button until the end of the manoeuvre.
The keep this system in good working order, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
OPERATING FAULT
If the control system fails, the indicator lamp in the control button
fl ashes, accompanied by an audible signal and a message in the
screen. As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:
 stop where it is safe to do so,
 switch off the ignition,
 switch the ignition on again.
If the indicator lamp no longer fl ashes, the failure was temporary, the
system has resumed normal operation. To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If the indicator lamp fl ashes again and the spoiler is still raised, the
system is still faulty.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
In the event of a system operating fault (e.g. jamming of the spoiler)\
, the
indicator lamp in the control button fl ashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing. Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:
 press the button briefl y: the indicator lamp on the button goes off
(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.

5/
SAFETY
RCZ_EN_CHAP05_SECURITE_ED02-2013
FIXED SPOILER
The installation of carrying accessories on the vehicles reduces
the effectiveness of the spoiler.
Only install carrying accessories that are recommended by
PEUGEOT.
When pushing the vehicle, do not press on the spoiler as there is
a risk of damaging it.
When washing your vehicle with a high pressure jet-wash, keep
the end of the lance at least 1 metre away from the spoiler.
1.6 litre THP 270 hp version only.

7/
CHECKS
QUALITY OF THE FUEL USED FOR PETROL
ENGINES
The petrol engines are perfectly compatible with E10 or E24 type petrol \
biofuels (containing 10 % or 24 % ethanol), conforming to European
standards EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol) are reserved exclusivel\
y
for vehicles marketed for the use of this type of fuel (BioFlex vehicle\
s).
The quality of the ethanol must comply with European standard
EN 15293.
For Brazil only, special vehicles are marketed to run on fuels containing
up to 100 % ethanol (E100 type).
QUALITY OF THE FUEL USED FOR DIESEL
ENGINES
The Diesel engines are perfectly compatible with biofuels which
conform to current and future European standards (Diesel fuel which
complies with standard EN 590 mixed with a biofuel which complies
with standard EN 14214) available at the pumps (containing up to
7 % Fatty Acid Methyl Ester).
The B30 biofuel can be used in certain Diesel engines; however, this
use is subject to strict application of the special servicing conditions\
.
Contact a PEUGEOT dealer or a qualifi ed workshop.
The use of any other type of (bio)fuel (vegetable or animal oils, pur\
e
or diluted, domestic fuel...) is strictly prohibited (risk of damage t\
o the
engine and fuel system).
When you have fi lled the tank:
 put the cap back in place,
 turn it to the right,
 close the fl ap.
Freezing conditions
In these conditions, the fi ller fl ap may be jammed.
Opening the boot gives access to the fl ap, allowing it to be
released by hand.

7/
CHECKS
PETROL ENGINES
The various caps and covers allow access for checking the levels of the various fl uids and for replacing certain components.
1. Power steering reservoir.
2. Screenwash and headlamp wash reservoir.
3. Coolant reservoir.
4. Brake fl uid reservoir.
5. Battery / Fuses. 6. Fusebox.
7. Air fi lter.
8. Engine oil dipstick.
9. Engine oil fi ller cap.