2014 Peugeot RCZ maintenance

156
CHECKING LEVELS
ENGINE OIL LEVEL
The check is carried out either when the ignition is switched
on using the oil level indicator in the instrument panel, or using
the dipstick.
Take care when working under the bonnet, as certain areas of the engine m\
ay be extremely hot (risk of burns) and the cooling fan could start
at any time (even with the ignition off).
Check all of these levels regularly, in line with the warranty and maintenance record. Top them up if necessary, unless otherwise indicated.
If a level drops signifi cantly, have the corresponding system checked by a PEUGEOT dealer or a qualifi ed workshop.
To ensure that the reading is correct, your vehicle must be on
level ground and the engine must have been off for more than
30 minutes.
It is normal to top up the oil level between two services (or oil chang\
es).
PEUGEOT recommends that you check the level, and top up if
necessary, every 3 000 miles (5 000 kms).
Checking using the dipstick
Refer to the "Petrol engine" or "Diesel engine" section for the location\
of
the dipstick in the engine compartment of your vehicle.
- Take the dipstick by its coloured grip and remove it completely.
- Wipe the end of the dipstick using a clean non-fl uffy cloth.
- Refi t the dipstick and push fully down, then pull it out again to make the visual check: the correct level is between the marks A and B . A = MAX
B = MIN
If you fi nd that the level is above the A mark or below the B mark, do
not start the engine .
- If the level is above the MAX mark (risk of damage to the engine),
contact a PEUGEOT dealer or a qualifi ed workshop.
- If the level is below the MIN mark, you must top up the engine oil.

7/
CHECKS
BRAKE FLUID LEVEL
The brake fl uid level should be close to the "MAX" mark. If it is
not, check the brake pad wear.
Changing the fluid
Refer to the warranty and maintenance record for details of the interval\

for this operation.
Fluid specification
The brake fl uid must conform to the manufacturer's recommendations.
POWER STEERING FLUID LEVEL
The power steering fl uid level should be close to the "MAX"
mark. With the engine cold, unscrew the cap to check the level.
Topping up the engine oil level
Oil grade
The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.
Refer to the "Petrol engine" or "Diesel engine" section to identify the \
location of the oil fi ller cap in the engine compartment of your vehicle.
- Unscrew the oil fi ller cap to reveal the fi ller aperture.
- Add oil in small quantities, avoiding any spills on engine components (risk of fi re).
- Wait a few minutes before checking the level again using the dipstick.
- Add more oil if necessary.
- After checking the level, carefully refi t the oil fi ller cap and the dipstick in its tube.
After topping up the oil, the check when switching on the ignition with \
the oil level indicator in the instrument panel is not valid during the \
30 minutes after topping up.
Engine oil change
Refer to the warranty and maintenance record for details of the interval\

for this operation.
In order to maintain the reliability of the engine and emission control \
system, the use of additives in the engine oil is prohibited.

7/
CHECKS
CHECKS
BATTERY PARTICLE EMISSION FILTER (DIESEL)
On a new vehicle, the fi rst particle fi lter regeneration operations
may be accompanied by a "burning" smell, which is perfectly
normal.
Following prolonged operation of the vehicle at very low speed or
at idle, you may, in exceptional circumstances, notice the emission
of water vapour at the exhaust on acceleration. This does not
affect the behaviour of the vehicle or the environment.
The battery does not require any maintenance.
However, check that the terminals are clean and correctly
tightened, particularly in summer and winter.
When carrying out work on the battery, refer to the "Battery"
section for details of the precautions to be taken before disconnecting \
the battery and following its reconnection.
The start of saturation of the particle emissions fi lter is
indicated by the temporary illumination of this warning lamp,
accompanied by an audible signal and a message on the risk
of blockage of the particle emissions fi lter.
As soon as the traffi c conditions permit, regenerate the fi lter by driving
at a speed of at least 40 mph (60 km/h) until the warning lamp goes of\
f.
If the warning lamp stays on, refer to the "Additive level" section.
Unless otherwise indicated, check these components in accordance with
the warranty and maintenance record and according to your engine.
Otherwise, have them checked by a PEUGEOT dealer or a qualifi ed
workshop.
AIR FILTER AND PASSENGER COMPARTMENT FILTER
Refer to the warranty and maintenance record for details of
the replacement intervals for these components.
Depending on the environment (e.g. dusty atmosphere) and
the use of the vehicle (e.g. city driving),
replace them twice
as often if necessary .
A clogged passenger compartment fi lter may have an adverse effect
on the performance of the air conditioning system and generate
undesirable odours. Replace the oil fi lter each time the engine oil is changed.
Refer to the warranty and maintenance record for details of
the replacement interval for this component.
OIL FILTER

160
MANUAL GEARBOX
AUTOMATIC GEARBOX
BRAKE PADS BRAKE DISC WEAR
The gearbox does not require any maintenance (no oil
change).
Refer to the warranty and maintenance record for the details
of the level checking interval for this component.
The gearbox does not require any maintenance (no oil
change).
Refer to the warranty and maintenance record for details of
the level checking interval for this component.
Brake wear depends on the style of driving, particularly in
the case of vehicles used in town, over short distances.
It may be necessary to have the condition of the brakes
checked, even between vehicle services.
Unless there is a leak in the circuit, a drop in the brake fl uid level
indicates that the brake pads are worn. For information on checking brake disc wear, contact a
PEUGEOT dealer or a qualifi ed workshop.
Only use products recommended by PEUGEOT or products of
equivalent quality and specifi cation.
In order to optimise the operation of units as important as those
in the braking system, PEUGEOT selects and offers very specifi c
products.
After washing the vehicle, dampness, or in wintry conditions, ice
can form on the brake discs and pads: braking effi ciency may
be reduced. Make light brake applications to dry and defrost the
brakes.
PARKING BRAKE
If excessive travel or a loss of effectiveness of this system
is noticed, the parking brake must be checked, even
between two services.
Checking this system must be done by a PEUGEOT dealer
or a qualifi ed workshop.

8/
PRACTICAL INFORMATION
CLEANING AND MAINTENANCE
The general recommendations on cleaning and maintaining your vehicle
are given in the servicing and warranty booklet.
ALUMINIUM ARCHES
To clean these arches, do not use a dry cloth with an abrasive product. \

Use a sponge and soapy water.
PEUGEOT TECHNO TEP
To clean this trim, do not use solvents or detergents with a dry cloth.
First remove dust, then use a soft cloth and soapy water. Dry with
another soft cloth.
HEADLAMPS AND LAMPS
The headlamps have polycarbonate lenses, fi nished with a protective
lacquer.
Do not clean them with a dry or abrasive cloth, nor with detergent or
solvent products.
Use a sponge and soapy water.
CUSTOMISING STICKERS
These customising parts are self-adhesive stickers, treated to give good\

resistance to ageing and tearing.
They are intended for customising the body.
Available also as accessories, we recommend that you have them fi tted
by a PEUGEOT dealer or a qualifi ed workshop. The use of a high pressure jet wash for cleaning the headlamps,
lamps and their surrounds may damage the lacquer and seals.
Observe the recommendations on pressure and distance for jet
washing.
First clean persistent stains with a sponge and warm soapy water.
When washing your vehicle, keep the end of a high-pressure
lance at least 30 centimetres from the stickers.

198
MATT PAINT
If you vehicle is fi nished with a clear matt lacquer, please observe the
following recommendations to avoid damaging the paintwork by the use
of an inappropriate cleaning procedures.
These recommendations are also valid for alloy road wheels fi nished
with clear matt lacquer. Never clean the vehicle without water.
Never wash your vehicle in an automatic roller brush car wash.
Never polish the vehicle body, nor the alloy wheels. Doing this will
make the paintwork shiny.
Do not use paint cleaners, abrasive products or paint polishing or
preserving products (such as wax, for example) on the paintwork.
These products are only suitable for bright fi nishes. Application of
these products on vehicles with a matt fi nish will seriously damage
the paint surface of the vehicle, giving rise to irreversible shiny or
stained areas.
Never use a high pressure jet wash with a lance fi tted with a
brush, this may scratch the paintwork.
Never select a wash programme that fi nishes with a hot wax
cycle. From the range of cleaning and maintenance products in the
"TECHNATURE" range recommended and approved by PEUGEOT,
use only the insect remover and car shampoo, which are the only
products to be used on the bodywork.
The insect remover can also be used to remove minor marks
(for example: fi nger marks...).
Always have paint repairs done by a PEUGEOT dealer or a qualifi ed
workshop.
We recommend the use of a high pressure jet wash, or at least a
water hose with a high output.
We recommend that the vehicle be rinsed using de-ionised water.
Use only a microfi bre cloth to dry the vehicle. It must be clean and
used without heavy pressure.
Lightly wipe off any fuel stains present on the bodywork using a
soft cloth, then leave to dry.

200
Installation of radio communication transmitters
Before installing any after-market radio communication transmitter,
you can contact a PEUGEOT dealer for the specifi cation of
transmitters which can be fi tted (frequency, maximum power,
aerial position, specifi c installation requirements), in line with the
Vehicle Electromagnetic Compatibility Directive (2004/104/EC). Depending on the legislation in force in the country, certain
safety equipment may be compulsory: high visibility safety vests,
warning triangles, breathalyzers, spare bulbs, spare fuses, a fi re
extinguisher, a fi rst aid kit, mud fl aps at the rear of the vehicle.
The fi tting of electrical equipment or accessories which are not
recommended by PEUGEOT may result in a failure of your
vehicle's electronic system and excessive electrical consumption.
Please note this precaution. You are advised to contact a
PEUGEOT representative to be shown the range of recommended
equipment and accessories.
"Multimedia":
portable navigation systems, Wi-Fi on Board... By going to a PEUGEOT dealer you can also obtain products for
cleaning and maintenance (exterior and interior) - including ecologica\
l
products from the "TECHNATURE" range, topping up products
(screenwash, ...), touch-up pens and aerosols for the exact colour of \
your vehicle, refi lls (cartridge for temporary tyre repair kit...), ...

03
SETUP
TRAFFIC
MEDIA
217
GENERAL OPERATION
For a detailed global view of the menus available, refer to the "Screen menu map" section of this handbook.
Press the MODE button several times in succession to gain access to the \
following displays:
Long press: access to the GPS coverage and to the demonstration mode.
For maintenance of the screen, the use of a soft, non-abrasive cloth (spectacles cloth) is recommended, without any additional product.
RADIO / / / /MUSIC MEDIA / VIDEO
TELEPHONE
(If a conversation is in progress)
FULL SCREEN MAP
NAVIGATION (If guidance is in progress)
SETUP:
access to the "SETUP" Menu: system language * and voice functions * , voice initialisation (section 09), date and time * , display, unit and system parameters.
TRAFFIC:
access to the Traffi c Menu: display of the current traffi c alerts.
Contextual display
MEDIA:
"DVD-audio" menu
"DVD-Video" menu
* Available according to model.