2014 Peugeot RCZ check engine

1/
MONITORING
MANUAL CHECK
This function allows you to check the status of the vehicle (reminder o\
f
the active alert warnings) and the service information.
 With the engine running, to start a manual check, briefl y press the "CHECK/000" button on the instrument panel.
If no faults have been detected, "CHECK OK" appears in the
instrument panel central screen.
If a "minor" fault has been detected, the warning lamp concerned then
"CHECK OK" appear in the instrument panel central screen. Contact a
PEUGEOT or a qualifi ed workshop.
If a "major" fault has been detected, only the warning lamps concerned
appear in the instrument panel central screen. Have it checked by a
PEUGEOT dealer or a qualifi ed workshop.
DISTANCE RECORDERS
The total and trip distances are displayed for thirty seconds when the
ignition is switched off, when the driver's door is opened and when the
vehicle is locked or unlocked.
Measures the total distance travelled by the vehicle since its fi rst
registration.
Total distance recorder
 With the ignition on, press and hold this button until zeros appear.
Trip distance recorder
Measures the distance travelled since it was last reset to zero by the
driver.

54
LOST KEYS
Go to a PEUGEOT dealer with the vehicle's registration document, your personal identifi cation documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder code re\
quired to order a new key.
LOCKING THE VEHICLE
Driving with the doors locked may make access to the passenger compartment by the emergency services more diffi cult in an emergency.
As a safety precaution, never leave children alone in the vehicle, excep\
t for a very short period.
In all cases, it is essential to remove the key from the ignition switch\
when leaving the vehicle.
REMOTE CONTROL
The high frequency remote control is a sensitive system; do not operate \
it while it is in your pocket as there is a possibility that it may unlo\
ck
the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range \
and out of sight of your vehicle. You run the risk of stopping it from
working and the remote control would have to be reinitialised.
No remote control can operate when the key is in the ignition switch, ev\
en when the ignition is switched off, except for reinitialisation.
ANTI-THEFT PROTECTION
Do not make any modifi cations to the electronic engine immobiliser system; this could cause malfunctions.
Do not throw the remote control batteries away, they contain metals which are harmful to the environment.
Take them to an approved collection point.
WHEN PURCHASING A SECOND-HAND VEHICLE
Have the pairing of all of the keys in your possession checked by a PEUG\
EOT dealer, to ensure that only your keys can be used to open and
start the vehicle.

74
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
 To obtain an even air distribution, take care not to obstruct the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
 Do not cover the sunshine sensor, located on the dashboard; this is used for regulation of the air conditioning system.
 Operate the air conditioning system for at least 5 to 10 minutes, once or twice a month to keep it in good working order.
 Ensure that the passenger compartment fi lter is in good condition and have the fi lter elements replaced regularly (refer
to the "Checks" section).
We recommend the use of a combined passenger compartment fi lter. Thanks to its special active additive,
it contributes to the purifi cation of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
 To ensure correct operation of the air conditioning system, you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
 If the system does not produce cold air, switch it off and contact a PEUGEOT dealer or a qualifi ed workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very high, fi rst ventilate the cabin for a few moments.
Put the air fl ow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

104
TRAJECTORY CONTROL SYSTEMS
DYNAMIC STABILITY CONTROL (DSC) AND
ANTI-SLIP REGULATION (ASR)
The anti-slip regulation (also known as traction control) optimises
traction to prevent skidding of the wheels, by acting on the brakes of t\
he
driving wheels and on the engine.
The electronic stability control acts on the brake of one or more wheels\

and on the engine to keep the vehicle on the trajectory required by the \
driver, within the limits of the laws of physics.
Activation
These systems are activated automatically each time the vehicle is
started.
These systems act on the operation of the engine and brakes as soon
as they detect a problem of grip or trajectory. This is indicated by fl ashing of this warning lamp in the
instrument panel.
SNOW DRIVING ASSISTANCE
(INTELLIGENT TRACTION CONTROL)
Your vehicle has a system to help driving on snow: Intelligent Traction
Control.
This automatic system continuously checks for situations of diffi cult
surface adhesion that could make it diffi cult to move off or make
progress on deep fresh snow or compacted snow.
In these situations, Intelligent Traction Control limits the amount of
wheel slip to provide the best traction and trajectory control.
In extremely severe conditions (deep snow, mud…), it can be useful to
temporarily deactivate the dynamic stability control and wheel anti-
slip systems to allow a degree of wheel spin and so recover grip.
It is recommended that the system be reactivated as soon as possible.
Snow tyres are strongly recommended on surfaces offering low levels
of adhesion.

5/
SAFETY

Deactivation
In exceptional conditions (starting a vehicle which is bogged down,
stuck in snow, on soft ground...), it may be advisable to deactivate the
DSC and ASR, so that the wheels can turn freely and regain grip.
Reactivate the systems as soon as the level of grip permits.
 Press this button.
The indicator lamp in the button comes on.
The DSC and ASR systems no longer act on the operation of the engine
and on the brakes in the event of a involuntary change of trajectory.
This action also deactivates the automatic operation of hazard warning
lamps (except for the 1.6 litre THP 270 hp version).
Reactivation
The systems are reactivated automatically each time the ignition is
switched back on.
You can also reactivate them manually:
 Press this button again.
This action also reactivates the automatic operation of hazard warning
lamps (except for the 1.6 litre THP 270 hp version).
Operating fault DSC/ASR
The DSC and ASR systems offer increased safety in normal
driving, but they should not encourage the driver to take extra
risks or drive at high speed.
It is in diffi cult driving conditions (rain, snow, ice) that the risk of
loss of grip increases. It is therefore important for your safety to
keep the DSC and ASR systems activated in all conditions, and
particularly in diffi cult conditions.
The correct operation of these systems depends on observation
of the manufacturer's recommendations regarding as much the
wheels (tyres and rims), braking and electronic components as the
assembly and repair procedures used by PEUGEOT dealers.
To benefi t in full from the effectiveness of the DSC and ASR
systems in wintry conditions, the vehicle must be fi tted with four
snow tyres, allowing the the vehicle to retain neutral behaviour on
the road. Illumination of this warning lamp and the lamp in the
deactivation button, accompanied by an audible signal and a
message, indicate a fault with the system.
Contact a PEUGEOT dealer or a qualifi ed workshop to have the system
checked.
After an impact, have these systems checked by a PEUGEOT
dealer or a qualifi ed workshop.

5/
SAFETY
REAR SEAT BELTS
The rear seats are each fi tted with a three-point inertia reel seat belt
with force limiter.
Fastening
1. Pull the strap and insert the tongue F in the black buckle F , in the
centre of the bench seat.
2. Insert the tongue G in the outer red buckle G .
3. Check that each buckle is fastened correctly by pulling the strap.
Unfastening
1. Press the red button on the buckle G , then the black button on the
buckle F .
2. Guide the strap as it reels in and bring the tongue G , then the
tongue F to the corresponding securing point on the backrest.
Seat belt unfastened warning lamps display
A. Rear seat belts unfastened warning lamp.
D. Rear right seat belt warning lamp.
E. Rear left seat belt warning lamp.
The warning lamp A comes on, either on in the seat belt and
passenger's front airbag warning lamps display, when one or more rear
passengers unfasten their seat belt.
From approximately 12 mph (20 km/h), this warning lamp fl ashes for
two minutes accompanied by an audible signal of increasing volume.
Once these two minutes have elapsed, this warning lamp remains on
until the one or more rear passengers fasten their seat belt.
When the ignition is switched on, with the engine running or the vehicle\

moving at a speed below approximately 12 mph (20 km/h),
the corresponding warning lamps D and E come on in red for
approximately 30 seconds, if the seat belt is not fastened.
When the vehicle is moving at a speed of more than approximately
12 mph (20 km/h), the corresponding warning lamp D or E comes on in
red, accompanied by an audible signal and a message in the screen,
if a rear passenger has unfastened their seat belt.
Unfastening is detected on both buckles of the seat belt. The
corresponding warning lamp comes on when at least one of the
two buckles is unfastened.

6/
DRIVING
HILL START ASSIST
System which keeps your vehicle immobilised temporarily
(approximately 2 seconds) when starting on a gradient, the time it tak\
es
to move your foot from the brake pedal to the accelerator pedal.
OPERATION
This function is only active when:
- the vehicle is completely stationary, with your foot on the brake pedal,
- certain conditions of slope are met,
- with the driver’s door closed.
The hill start assist system cannot be deactivated.
Do not exit the vehicle while it is being held in the hill start assist \
phase.
OPERATING FAULT
On an ascending slope, with the vehicle stationary, the vehicle is
held for a brief moment when you release the brake pedal:
- provided you are in fi rst gear or neutral on a manual gearbox,
- provided you are in position D or M on an automatic gearbox. On a descending slope, with the vehicle stationary and reverse
gear engaged, the vehicle is held for a brief moment when you
release the brake pedal.
If you need to exit the vehicle with the engine running,
apply the parking brake and then check that the
corresponding warning lamp in the instrument panel is on.
If a malfunction of the system occurs, these warning lamps come on.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.

136
It is only possible to change from one gear to another if the vehicle
speed and engine speed permit; otherwise, the gearbox will operate
temporarily in automatic mode. M and the gears engaged manually appear in succession in
the instrument panel.
If the engine speed is too low or too high, the gear selected
fl ashes for a few seconds, then the actual gear engaged is
displayed.
It is possible to change from position D (automatic) to position M
(manual) at any time.
When the vehicle is stationary or moving very slowly, the gearbox
selects gear M1 automatically.
The sport and snow programmes do not operate in manual mode.
Invalid value during manual operation
This symbol is displayed if a gear is not engaged correctly
(selector between two positions).
STOPPING THE VEHICLE
Before switching off the engine, you can engage position P or N to
place the gearbox in neutral.
In both cases, apply the parking brake to immobilise the vehicle. If the lever is not in position
P , when the driver's door is opened or
approximately 45 seconds after the ignition is switched off, there is
an audible signal is heard accompanied by a message.
 Return the lever to position P ; the audible signal stops and the
message disappears.
OPERATING FAULT
When the ignition is on, the illumination of this warning lamp,
accompanied by an audible signal and a message in the
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to emergency mode and is locked in
3rd gear. You may feel a substantial knock when changing from P to R
and from N to R . This will not cause any damage to the gearbox.
Do not exceed a speed of 60 mph (100 km/h), local speed restrictions
permitting.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
This warning lamp may also come on if a door is opened.
There is a risk of damage to the gearbox:
- if you press the accelerator and brake pedals at the same time,
- if you force the lever from position P to another position when
the battery is fl at.
To reduce fuel consumption during a long period stationary with
the engine running (traffi c jam, etc.), place the gear lever in
position N and apply the parking brake.