
 30
 
 
 
Instruments and controls  
 
 
FUEL GAUGE 
 
The fuel level is tested each time the key is 
turned to the "ignition on" position. 
  The gauge is positioned on: 
   
 
-   f 
  (full): 
 the capacity of the fuel tank is 
approximately  45 litres 
. 
   
-   e 
  (empty): 
 the reserve is now being 
used, the warning lamp comes on 
continuously.  
  The reserve when the warning first comes 
on is approximately 6 litres. 
   
COOLANT TEMPERATURE 
 
 
The needle is positioned between 
  c 
  (cold) 
and 
  h 
  (hot): 
 normal operation. 
  In arduous conditions of use or hot climatic 
conditions, the needle may move close to 
the red graduations.    
-   wait approximately 15 minutes to allow 
the engine to cool down in order to check 
the level and top it up if necessary. The 
cooling system is pressurised. In order to 
avoid any risk of scalding, unscrew the 
cap by two turns to allow the pressure to 
drop.  
  When the pressure has dropped, check the 
level and remove the cap to top up. 
  If the needle remains in the red zone, 
contact a PEUGEOT or a qualified 
workshop.   EMISSION CONTROL 
 
EOBD (European On Board Diagnosis) is a 
diagnostics system which meets the exhaust 
emissions standards for: 
   
 
-   CO (carbon monoxide), 
   
-   HC (unburnt hydrocarbons), 
   
-   NOx (nitrous oxides) or particles detected 
by oxygen sensors placed upstream and 
downstream of the catalytic converters.  
  Refer to the "Levels" section of chapter 7.   Refer to the "Levels" section of 
chapter 7.  
  The driver is warned of any 
fault with this emission control 
system by flashing of this specific 
warning lamp in the instrument 
panel.     
What you should do if the needle 
enters the red zone, or if the warning 
lamp comes on:  
   
 
-   stop immediately, switch off the ignition. 
The cooling fan may continue to operate 
for a certain time up to approximately 
10 minutes.  

 31
1
READY TO SET OFF
 
 
 
Instruments and controls  
 
 
SERVICE INDICATOR  
 
ENGINE OIL WARNING LAMP 
 
LIGHTING DIMMER 
 
The dimmer is active when the sidelamps 
are on.    Refer to the list of checks in the 
warranty and maintenance record 
which was given to you on delivery of 
the vehicle. 
  After a few seconds, the screen returns to its 
usual functions.  
  Use these controls to adjust the 
brightness of the instrument 
panel and the audio system panel 
lighting.     
The screen in the instrument panel 
informs you when the next service is due, 
in accordance with the Manufacturer's 
servicing schedule indicated in the warranty 
and maintenance record. This information 
is determined in relation to the distance 
travelled since the previous service.    
Low engine oil pressure 
   
Oil deterioration (1.3 HDi 75 hp engine only)   The warning lamp comes on 
continuously, accompanied by a 
message in the instrument panel screen, 
when the system detects that the oil 
pressure is too low. 
  The warning lamp flashes, 
accompanied by a message in the 
instrument panel screen, when the system 
detects deterioration of the engine oil. The 
flashing of this warning lamp should not be 
considered as a fault wit the vehicle, but 
rather as an indication to the driver that the 
normal use of the vehicle now requires that 
the oil be changed. 
  If the oil is not changed, when a 
second level of deterioration is 
reached, the emissions warning 
lamp comes on in the instrument panel and 
the engine speed is restricted to 3000 rpm. 
  If the oil is still not changed, when a third 
level of deterioration is reached, the engine 
speed is restricted to 1500 rpm, so as to 
avoid any damage.   To avoid damaging the engine, it is 
recommended that the oil be changed 
on flashing of the engine oil warning lamp.  
 
   
Stop as soon as it is safe to do so: park, 
switch off the ignition and contact a 
 
  PEUGEOT 
  dealer or a qualifi ed workshop. 
 
  

 32
 
 
 Access  
 
 
 
Central locking 
   
Folding/unfolding the key     
Unlocking of the vehicle 
   
Unlocking the hinged rear doors or 
the tailgate 
  Press this button to release the 
key from its housing. 
  To fold the key, press the button 
then fold the key into the housing. 
   
If you do not press the button, the 
mechanism may be damaged.  
 
 
Deadlocking 
 
The deadlocking is deactivated: 
   
 
-   by carrying out the door opening 
operation, 
   
-   by turning the ignition key to 
the  RUNNING  position.  
 
 
REMOTE CONTROL 
 
Press this button to unlock the 
front doors only (Light van) or all 
of the doors (Combi). 
  Unlocking is confirmed by two flashes of the 
direction indicators.  
  Press this button to unlock the 
load space (Light van) or the 
hinged rear doors or the tailgate 
only (Combi).    Press this button briefly to lock all 
of your vehicle's doors. Locking 
is confirmed by a flash of the 
direction indicators.  
If one of the doors is open or is not closed 
correctly, the central locking will not work. In 
this case, the failed locking is indicated by 
three flashes of the direction indicators.    Press this button twice to change 
locking to deadlocking. 
  Deadlocking renders the exterior 
and interior door opening handles 
inoperative. Do not leave anyone inside the 
vehicle when it is deadlocked. Deadlocking 
is confirmed by a flash of the direction 
indicators.  

 35
1
READY TO SET OFF
 
 
 Access 
 
 
 
ELECTRONIC IMMOBILISER 
 
All of the keys contain an electronic 
immobiliser device. 
  This device locks the engine supply system. 
It is activated automatically when the key is 
removed from the ignition. 
  After the ignition is switched on, a dialogue 
is established between the key and the 
electronic immobiliser system. 
  This warning lamp is switched off 
after the ignition is switched on 
and the key has been recognised, 
the engine can be started. 
  If the key is not recognised, the engine 
cannot be started. Use another key and 
have the faulty key checked by a PEUGEOT 
dealer. 
   
Good practice 
 
Do not make any modifications to the 
electronic immobiliser system. 
  Operating the remote control, even when it 
is in your pocket, may result in involuntary 
unlocking of the doors. 
  The simultaneous use of other high 
frequency equipment (mobile telephones, 
domestic alarms…), may interfere with the 
operation of the remote control temporarily. 
   
When purchasing a second-hand vehicle:  
   
 
-   ensure that you are given the confidential 
card, 
   
-   have the keys memorised by a  PEUGEOT 
dealer  to ensure that the keys in your 
possession are the only ones which can 
start the vehicle.  
 
CONFIDENTIAL CARD 
 
This is given to you on delivery of your 
vehicle with the duplicate keys. 
  It contains the identification code necessary 
for any work carried out by a PEUGEOT 
dealer on the electronic immobiliser system. 
This code is hidden by a film, which should 
be removed only if necessary. 
  Keep your card in a safe place, never inside 
the vehicle. 
  When undertaking a long trip or journey, 
however, it is advisable to take it with you 
along with your personal papers. 
  Driving with the doors locked may 
make access to the passenger 
compartment by the emergency services 
more difficult in an emergency. 
  As a safety precaution (with children on 
board), remove the key from the ignition when 
leaving the vehicle, even for a short time.   

 36
 
 
 Access  
 
 
ALARM 
 
This provides: 
   
 
-   exterior perimeter protection by means of 
detectors on the doors and bonnet and 
on the electrical supply, 
   
-  interior protection, 
   
-  anti-tilt protection, 
   
-   protection against the unauthorised 
insertion of a key in the starter.  
  The equipment includes a siren. 
 
 
Activation of the alarm 
 
First ensure that all of the accesses are 
closed correctly. 
  The alarm is activated by pressing 
this control, the protection is 
active after a few seconds. 
  While the alarm is monitoring, any 
intrusion triggers the siren for approximately 
30 seconds, accompanied by illumination of 
the direction indicators. 
  The alarm then returns to monitoring mode. 
  The alarm is also triggered following an 
electrical supply cut-off, when the supply is 
restored.  
 
 
Deactivation using the remote control 
   
Deactivation using the key 
 
Unlock the doors using the key and enter 
the vehicle. Switch on the ignition to the 
RUNNING position, identification of the key 
code will switch off the alarm.  
 
 
Deactivation of the volumetric and 
anti-tilt protection    
Good practice 
 
To quickly deactivate the siren following 
unwanted triggering, unlock the vehicle 
using the remote control. 
  To avoid setting the alarm, before washing 
the vehicle for example, lock the vehicle 
using the key.  
  When this button is pressed, the 
alarm is deactivated when the 
vehicle is unlocked.  
 
 
Signalling of attempted intrusion 
 
When you return to your vehicle, 
flashing of the electronic engine 
immobiliser warning lamp or 
the appearance of a warning 
message in the instrument panel display 
indicates an attempted intrusion during your 
absence.  
  To deactivate the volumetric 
and anti-tilt protection, press the 
button located in the vehicle's 
courtesy lamp. To be effective, 
this operation must be repeated every time 
the ignition is switched off.   

 40
 
 
 Access  
 
 
CLOSING FROM INSIDE 
 
 
Central locking 
 
Push the interior handle to lock the entire 
vehicle or the door concerned. However, 
if one of the doors is open or is not closed 
correctly, the central locking does not work. 
  Always remove the key from the 
ignition when leaving the vehicle, even 
for a short time.    
Closing from 180° 
  The check strap will re-attach automatically 
when the hinged doors are closed, the small 
door being closed first.  
 
 
 
Load space 
 
Press to lock the sliding side 
doors and the rear doors (Light 
van) from the driving position.  
 
 
Protection against attack 
 
When the vehicle is started, the system 
locks the driving position and load space 
doors automatically when you reach 
approximately 12 mph (20 km/h). 
  This "AUTOCLOSE" function is activated or 
deactivated via the "MENU". 
  If none of the doors are opened during the 
journey, the locking remains active. 
  This function is deactivated when the vehicle 
is delivered.   

 41
1
READY TO SET OFF
 
 
 Access 
 
 
 
 
Sliding side door (Combi) 
 
Use the grab handle to pass the point of 
resistance and start the movement. Then 
use the handle to guide the door closed. 
   
 
Child safety 
 
This prevents either of the rear doors being 
opened from inside. 
   
 
  Turn the switch on each rear door a 
quarter of a turn using the ignition key.  
 
 
 
CLOSING FROM THE OUTSIDE 
 
 
Sliding side door 
 
Pull the handle towards you then towards 
the front to pass the point of resistance 
(Light van) or to release the door retaining 
device (Combi). 
  Slide the door fully until it is closed.  
 
 
Hinged rear doors 
 
Start by closing the small hinged door, this is 
secured automatically when closed. 
  Close the large door using its handle.  
 
 
Tailgate (Combi) 
 
Lower the tailgate using the interior grab 
handle.      
If your vehicle is on a slope, guide the 
sliding door all the way until closed. 
This is because the door could open or close 
itself more quickly because of the incline 
and result in injuries.  
  

 42
 
 
 
Steering mounted controls  
 
 
LIGHTING STALK 
 
Selection is by rotation of the white mark 
on the ring, when the ignition key is in the 
  RUNNING  position .
 
 
All lamps off  
   
Sidelamps on 
 
This is indicated on the instrument panel 
by illumination of the warning lamp.  
 
 
Dipped / main beam headlamps on 
   
Dipped / main beam headlamps 
change 
  Pull the lighting stalk fully towards you.  
 
 
Headlamp flash 
   
Direction indicators    
"Motorway" function 
 
System which indicates a change of lane on 
high-speed roads. 
  Press the lighting stalk up or down once, 
without passing the point of resistance; the 
corresponding direction indicators will flash 
three times.  
  Pull the lighting stalk towards you 
gently, regardless of the position 
of the ring.  
   
 
Left: push downwards. The green 
direction arrow warning lamp 
flashes in the instrument panel. 
  Right: push upwards. The green 
direction arrow warning lamp flashes in the 
instrument panel.     Turn the ring into position.  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Parking lamps 
 
Side markers for the vehicle by illumination 
of the sidelamps on the traffic side only. 
  Ignition key in the  STOP 
 position or removed 
from the ignition switch: 
   
 
 
  turn the ring to the "Lighting off" position, 
then to the "Sidelamps" position, 
   
 
  operate the lighting control stalk up 
or down depending on the traffic side 
(for example: when parking on the left; 
lighting control stalk upwards; the right 
hand sidelamps are on).  
  This is confirmed by illumination of the 
sidelamps warning lamp in the instrument 
panel. 
  To switch off the parking lamps, return the 
lighting control stalk to the middle position 
and the ring to the "Lighting off" position.