2014 Peugeot 508 RXH start stop button

15
508RXH_en_Chap00c_systeme-hybride_ed01-2014
Starting - stopping the engine
Before startingStarting the HYbrid4
system
- Press the brake pedal.
-
M ake a single short press (about
one
second) on the START/STOP button
or turn the key fully towards the dashboard
to position 3 (Starting).
-
t
h
e steering column unlocks (noise and
noticeable movement).
-
P
lace the gear selector in position N
.
-
I
f the vehicle has Keyless
en
try and
Starting, simply having the key inside the
vehicle is sufficient.
-

O

ther wise, it is necessary to place the key
in the ignition switch.
-

I

f the Diesel preheater indicator lamp is on
(ambient temperature below zero) wait until
it goes off before starting. -

K
eep your foot on the brake pedal until the
HYbrid4 system starts up (the instrument
panel and the Ready lamp come on,
confirmed by an audible signal).
th
e hybrid system determines whether it is
necessary to start the Diesel engine.
.
Hybrid system

16
508RXH_en_Chap00c_systeme-hybride_ed01-2014
- Before switching off the HYbrid4 system, place the gear selector in position N .
-

M
ake a short press on the START/STOP
button or turn the key fully off to
position


1 (Stop) then remove the key from
the ignition switch.
-
t
h
e system shuts down and the steering
column locks.
Switching the HYbrid4 system off
For more information, refer to the
"un derbonnet precautions / warnings"
section.
When stationary, ensure that the ignition is
switched off and check that the Ready lamp
is off when you want to leave the vehicle,
other wise the hybrid system will still be active.When your vehicle moves off in
electric mode, it makes no noise. Be
ver y careful of pedestrians as they
will not hear you coming.
Switching off the engine leads to a loss
of braking assistance.
Hybrid system

18
508RXH_en_Chap00c_systeme-hybride_ed01-2014
Emergency starting with the
electronic key
When the electronic key is in the recognition
zone and your vehicle does not start after
pressing the "S
tA
R
t/
S
tO
P" button:
F

O
pen the housing below the "S
tA
R
t/
St

OP " button.
F

I
nsert the electronic key in the location A .
F

P
ress the "S
tA
R
t/
S
tO
P" button.
Emergency switch-off using the
electronic key
In the event of an emergency only, the engine
can be switched of without conditions. to d o
this, press and hold the "S
tA

R
t/
S
tO
P" button
for about 3 seconds.
In this case the steering column locks as soon
as the vehicle stops.
If the electronic key is no longer in the
recognition zone when you request switching
off the engine, a message appears in the
instrument panel.
F

P
ress and hold the "S
tA
R
t/
S
tO
P" button
for about 3 seconds if you want to force
switching off the engine (note that restarting
will not be possible without the key).
Electronic key not recognised by
the "Keyless Entry and Starting"
system
If the electronic key is no longer in the
recognition zone when driving or when you
(later) request switching off of the hybrid
system, a message appears in the instrument
panel.
Once the engine has started, you can
remove the electronic key and close the
housing. F

P
ress and hold the "S
tA
R
t/
S
tO
P" button
for about 3 seconds if you want to force
switching off of the hybrid system (note that
restarting will not be possible without the
electronic key in the recognition zone).
th

e electronic key must always remain
inside the vehicle while in use.
Hybrid system

28
508RXH_en_Chap00c_systeme-hybride_ed01-2014
Air conditioning
QuestionAnswer
It seems to me that the vehicle runs less on electric
when the heating or air conditioning is operating, is
that right?
the
demand for heating or air conditioning may require the starting of the Diesel engine
until the desired level of comfort is attained.
Normal hybrid operation is simply put back.
t
h
e period can be longer under low or very high
ambient temperatures.
It seems to me that when it is very hot and the air
conditioning is working, the vehicle runs on electric for
shorter periods. Is that right? When it is hot, the periods when the Diesel engine is put on standby and the vehicle runs on
electric are necessarily restricted in order to limit the difference between the temperature in
the vehicle and the level of comfort selected.
In very hot weather, it is always possible to press the
e
c
o OFF button (which brings the
vehicle out of Z
eV m

ode and prevents electric running or the stopping of the engine) to give
preference to temperature control (keeps the air conditioning running).
Special HYbrid4 features
Question Answer
Can I tow with my hybrid vehicle and how much? A HYbrid4 vehicle can tow between 500 kg and 800 kg (see the "
to
wing" section).
th

is allows a jet ski or two-wheeler on a trailer to be towed, for example.
th

e "technical" reason for the limit is related to maintaining adequate cooling capacity for
the internal combustion engine as well as the hybrid components that are also cooled by the
engine's cooling system.
Why does engine braking seem so strong? When you take your foot off the accelerator, the engine braking results mainly from the
energy recovery by the electric motor.
th

is leads to a higher level of deceleration than a conventional vehicle and so allows the
recovery of free energy.
Hybrid system

59
508RXH_en_Chap01_controle-de-marche_ed01-2014
Information display
the information is accessible in the "Driving" menu.
Permanent display:
F

Sel

ect the " Driving" menu.
th

e trip computer information is displayed in
the primary page of the menu.
F

P

ress one of the buttons to display the
desired tab.
te

mporary display in a new window:
F

P

ress the end of the wiper control stalk for
access to the information and display the
different tabs.
th

e current instantaneous fuel
consumption tab with:
-

t
he range,
-

t
he current fuel consumption,
-

t
he Stop & Start time counter.
th

e trip "1" tab with:
-

t
he distance travelled.
-
t

he average fuel consumption,
-

t
he average speed,
f

or the first trip.
th

e trip "2" tab with:
-

t
he distance travelled.
-
t

he average fuel consumption,
-

t
he average speed,
f

or the second trip.
Trip reset
F When the desired trip is displayed, press the reset button or on the end of the wiper
control stalk.
t

r i p s "1" and "2" are independent but their use
is identical.
For example, trip "1" can be used for daily
figures, and trip "2" for monthly figures.
1
Monitoring

74
508RXH_en_Chap02_ouvertures_ed01-2014
Lost keys, remote control, electronic key
Visit a PeugeOt dealer with the vehicle's V5 registration document and your personal identification documents.th
e Pe ugeOt dealer will be able to retrieve the key code and the transponder code required to order a replacement.
Remote control
the high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the
vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from
working and the remote control would have to be reinitialised.
th

e remote control does not operate when the key is in the ignition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition or take the electronic key when you leave the vehicle, even for
a short time.
Electrical interference
the Keyless en try and Starting electronic key may not operate if close to certain electronic devices: telephone, laptop computer, strong
magnetic fields, ...
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
Don't forget to turn the steering to engage the steering lock.
When purchasing a second-hand vehicle
Have the key codes memorised by a Pe ugeOt dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Access

76
508RXH_en_Chap02_ouvertures_ed01-2014
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric and anti-lift
monitoring to avoid unwanted triggering of the
alarm in certain cases such as:
-
l
eaving a window partially open,
-
w

ashing your vehicle,
-
c

hanging a wheel,
-

h
aving your vehicle towed,
-

t
ransportation by sea.
Deactivation of the interior
volumetric and anti-tilt monitoring
F Switch of the ignition and within ten seconds, press this button until the
indicator lamp is on continuously.
F
g
e
t out of the vehicle.
F

P
ress the locking button on the
remote control immediately or
lock the vehicle using the Keyless
en

try and Starting system.
th

e exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
to b

e effective, this deactivation must be
carried out each time the ignition is switched
of f.
Reactivation of the interior
volumetric and anti-tilt monitoring
Triggering of the alarm
this is indicated by sounding of the siren and
flashing of the direction indicators for thirty seconds.
th

e monitoring functions remain active until
the alarm has been triggered eleven times in
succession.
F Press the unlocking button on the remote control or unlock the
vehicle using the Keyless
e
n
try
and Starting system to deactivate
the exterior perimeter monitoring.
F

P
ress the locking button on the
remote control or lock the vehicle
using the Keyless
e
n
try and
Starting system to activate all the
monitoring functions.
th

e indicator lamp in the button
again flashes once per second.
When the vehicle is unlocked using
the remote control or unlocked
using the Keyless
e
n
try and Starting
system, rapid flashing of the indicator
lamp in the button informs you that the alarm
was triggered during your absence. When
the ignition is switched on, this flashing stops
immediately.
Failure of the remote control
to deactivate the monitoring functions:
F
u
n
lock the vehicle using the key in the
driver's door lock.
F

O
pen the door; the alarm is triggered.
F

S
witch on the ignition; the alarm stops. t
h
e
indicator lamp in the button switches off.
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key in the driver's door lock.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a P
e

uge
Ot
dealer or a
qualified workshop.
* According to country.
Automatic activation*
2 minutes after the last door or the boot is
closed, the system is activated automatically.
F
t
o a
void triggering the alarm on entering
the vehicle, first press the unlocking button
on the remote control or unlock the vehicle
using the Keyless
e
n
try and Starting
system.
Access

90
508RXH_en_Chap03_confort_ed01-2014
Massage function
this function provides the driver with a back
massage. It only operates when the engine is
running as well as in S
tO
P mode of the Stop &
Start system.
Activation
F Press this button.
th

e warning lamp comes on and the massage
function is activated for a period of 1 hour.
During this time, massage is per formed in
cycles of 6 minutes (4 minutes of massage
followed by 2 minutes break). In total, the
system will per form 10 cycles.
After one hour, the function is deactivated, the
warning lamp goes off.
Deactivation
You can deactivate the massage
function at any time by pressing this
button.
Comfort