2014 Peugeot 508 Hybrid oil filter

11
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof
bars, roof rack, bicycle carrier, trailer...). u
s
e a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations on
maintenance
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
-

b
efore a long journey,
-

a
t each change of season,
-

a
fter a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil filter, air filter,
passenger compartment filter...) and observe the schedule of
operations recommended in the warranty and maintenance record.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any over flow.
At the wheel of your new vehicle, it is only after the first 1 800 miles
(3 000 kilometres) that you will see the fuel consumption settle down to
a consistent average.
.
Eco-driving

19
Warning lamps
When the engine is running or the vehicle is being driven, illumination of one of the following warning lamps indicates a fault which requires action on
the part of the driver.
Any fault resulting in the illumination of a warning lamp must be investigated further by reading the associated message in the instrument panel screen.
If you encounter any problems, contact a P
e
uge
Ot
dealer or a qualified workshop.
Warning / indicator lamp StateCause Action / Observations
STOP fixed, associated
with another warning
lamp, accompanied
by an audible signal
and a message in the
screen. Illumination of this warning lamp is
related to a serious fault with the
braking system, power steering, the
engine oil pressure or engine coolant
temperature or a major electrical
fault. Stop as soon as it is safe to do so as the engine may
cut out.
Park, switch off the ignition and call a P
e

uge
Ot

dealer or a qualified workshop.
Service on temporarily. Minor faults have occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in the
screen, such as, for example:
-

t
he engine oil level,
-

s
aturation of the particle emissions filter (Diesel).
-
t

he power steering,
-

a m
inor electrical fault.
-


...
For any other faults, contact a P
e

uge
Ot
dealer or a
qualified workshop.
fixed. Major faults have occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen and then contact a P
e

uge
Ot
dealer or
qualified workshop.
1
Monitoring

236
508_en_Chap09_verifications_ed02-2014
BlueHDi Diesel engines
the various caps and covers allow access for
checking the levels of the various fluids, for
replacing certain components and for priming
the fuel system.
1.
P
ower steering reservoir.
2.
S

creenwash and headlamp wash reservoir.
3.
C

oolant header tank.
4.
B

rake fluid reservoir.
5.
B

attery / Fuses.
6.


Fusebox.
7.
A

ir filter .
8.


e
n
gine oil dipstick.
9.


e
n
gine oil filler cap. 2.0 litre Blue HDi 150 hp
2.0 litre Blue HDi 180 hp
Checks

239
508_en_Chap09_verifications_ed02-2014
Coolant level
the coolant level should be close
to the "MA X" mark but should never
exceed it.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off the engine
before carrying out any work.
to a

void any risk of scalding, unscrew the cap by
two turns to allow the pressure to drop. When the
pressure has dropped, remove the cap and top up
the level.
Changing the coolant
the coolant does not have to be replaced at routine services.
Fluid specification
the coolant must conform to the
manufacturer's recommendations.
Fluid specification
For optimum cleaning and to avoid freezing,
this fluid must not be topped up with or
replaced with plain water.
Screenwash and headlamp
wash fluid
In the case of vehicles fitted with
headlamp washers, the low fluid level
is indicated by an audible signal and
a message in the instrument panel
screen.
Avoid prolonged contact of used oil or
fluids with the skin.
Most of these fluids are harmful to
health or indeed very corrosive.
Do not discard used oil or fluids into
sewers or onto the ground.
ta

ke used oil to a P
e
uge
Ot
dealer or
a qualified workshop (France) or to an
authorised waste disposal site.
Used products
To p p i n g u p
this additive must be topped up by a
Pe ugeOt dealer or a qualified workshop
without delay.
Diesel additive level (Diesel
engine with particle filter)
A low additive level is indicated by illumination
of the service warning lamp, accompanied
by an audible warning and a message in the
instrument panel screen.
When the engine is warm, the temperature of
the coolant is regulated by the fan.
to

p up the reservoir when you next stop the
vehicle.
In wintry conditions, the use of an
ethyl alcohol or methanol base fluid is
recommended.
The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades.
9
Checks

240
508_en_Chap09_verifications_ed02-2014
Checks
12 V battery
the battery does not require any
maintenance.
However, check that the terminals
are clean and correctly tightened,
particularly in summer and winter.Refer to the warranty and maintenance
record for details of the replacement
intervals for these components.
Air filter and passenger compartment filter
Replace the oil filter each time the
engine oil is changed.
Refer to the warranty and
maintenance record for details of
the replacement interval for this
component.
Oil filterthe presence of this label, in particular with
the Stop & Start system, indicates the use of
a specific 12 V lead-acid battery with special
technology and specification. t
h
e involvement
of a P
e

uge
Ot
dealer or a qualified workshop
is essential when replacing or disconnecting
the battery.
Particle filter (Diesel)
the start of saturation of the
particle filter is indicated by
the temporary illumination of
this warning lamp accompanied by a message
in the multifunction screen.
As soon as the traffic conditions permit,
regenerate the filter by driving at a
speed of at least 40 mph (60 km/h) until
the warning lamp goes off.
If the warning lamp stays on, this
indicates a low additive level.
On a new vehicle, the first particle
filter regeneration operations may be
accompanied by a "burning" smell,
which is per fectly normal.
Following prolonged operation of the
vehicle at very low speed or at idle,
you may, in exceptional circumstances,
notice the emission of water vapour at
the exhaust on acceleration.
t
h
is does
not affect the behaviour of the vehicle
or the environment.
un

less other wise indicated, check these components in accordance with the warranty and maintenance record and according to your engine.
Other wise, have them checked by a P
e

uge
Ot

dealer or a qualified workshop.
When carrying out work on the battery, refer
to the "12 V battery" section for details of the
precautions to be taken before disconnecting
the battery and following its reconnection. Depending on the environment (e.g. dusty
atmosphere) and the use of the vehicle (e.g.
city driving), replace them twice as often if
necessary
.
A clogged passenger compartment filter may
have an adverse effect on the per formance
of the air conditioning system and generate
undesirable odours.
Checks

250
508_en_Chap10_caracteristiques-techniques_ed02-2014
technical data
Petrol engine1.6 litre VTi
120 hp 1.6 litre THP
155 hp
Gearbox
ele
ctronic
(6-speed) Manual
(6-speed) Automatic
(6-speed)
Model code 8D5FH8/P - 8
e5

FH8/P
8D5FS8/P - 8
e5F

S8/P8D5FV8 - 8
e5

FV88D5FNA - 8
e5

FNA
8 D5 F VA - 8
e5

F VA
em

issions standard
e
uro 5
e
uro 5
Cubic capacity (cc) 1 5981 598
Bore x stroke (mm) 77 x 85.877 x 85.8
Max power:
eu standard (kW)* 85
88 11 0
115
Max power engine speed (rpm) 6 0006 000
Max torque:
eu standard (Nm) 160 240
Max torque engine speed (rpm) 4 2501 400
Fuel
u

nleaded
u
nleaded
Catalytic converter yesyes
Oil capacities (in litres)
eng

ine (with filter replacement) 4.254.25
Petrol engines and gearboxes
* the maximum power corresponds to the value type approved on a test bed, under conditions defined by eu ropean legislation (Directive 1999/99/eC ).

251
508_en_Chap10_caracteristiques-techniques_ed02-2014
* the maximum power corresponds to the value type approved on a test bed, under conditions defined by eu ropean legislation (Directive 1999/99/eC ).
Petrol engine
1.6 litre e-THP
165 hp
Gearbox Manual
(6-speed) Automatic
(6-speed)
Model code 8D5GZ-M / S - 8E5GZ-M / S8D5GZ-T / S - 8E5GZ-T / S
em
issions standard
--
Cubic capacity (cc) 1 598
Bore x stroke (mm) 77 x 85.8
Max power: eu standard (kW)*
121
Max power engine speed (rpm) 6 000
Max torque: eu standard (Nm)
240
Max torque engine speed (rpm) 1 400
Fuel
u
nleaded
Catalytic converter yes
Oil capacities (in litres)
eng
ine (with filter replacement)
4.25
10
technical data

254
508_en_Chap10_caracteristiques-techniques_ed02-2014
Diesel engine1.6 litre HDi
115 h p
Gearbox Manual
(6-speed)
ele

ctronic
(6-speed)
Model code 8D9HL0 - 8
e
9
HL08D9HR8/PS - 8
e9

HR8/PS
Body SaloonSWSaloon SW
em

issions standard
e
uro 5
e
uro 5
Cubic capacity (cc) 1 5601 560
Bore x stroke (mm) 75 x 88.375 x 88,3
Max power:
eu standard (kW)* 8484
Max power engine speed (rpm) 3 6003 600
Max torque:
eu standard (Nm) 240270
Max torque engine speed (rpm) 1 7501 750
Fuel Diesel
Catalytic converter yes
Particle filter yes
Oil capacity (in litres)
eng

ine (with filter replacement) 3.25
Diesel engines and gearboxes
* the maximum power corresponds to the value type approved on a test bed, under conditions defined by eu ropean legislation (Directive 1999/99/eC ).
technical data