2014 Peugeot 208 ECO mode

Welcome
Please note the following point:
The fitting of electrical equipment or accessories which are
not recommended by P
e
uge
O
T may result in a failure of your
vehicle's electronic system. Please note this specific warning.
It is advisable to contact a P
e

uge
O
T dealer to be shown the
recommended equipment and accessories.
Thank you for choosing a 208.
Within the model range, an item of equipment may be not available,
an option or fitted as standard.
When an option, the customer has the choice of adding to the
vehicle's equipment at extra cost when ordering and before the
vehicle is produced.
Any equipment fitted after the vehicle leaves the production line
becomes an aftermarket accessory. The instructions for the user are
supplied by the manufacturer of the accessory, it is not covered in this
edition of the handbook
Key
Warning
This symbol marks warnings which it is
essential to observe for your own safety,
for the safety of others or to avoid any risk
of damaging your vehicle.
Information
This symbol draws your attention to
additional information for better use of your
vehicle.
Protection of
the

environment
This symbol accompanies advice relating
to protection of the environment.
This handbook has been designed to help you make the most
of using your vehicle in all circumstances.

.
Direction indicators 128
Hazard warning lamps 1 28
em

ergency or assistance call
1
29
H or n


129
Tyre under-inflation detection

1
30
e

SC system
1
33
Front seat belts

1
36
Airbags


139
Child seats

1
43
Deactivating the passenger's front airbag
1

45
ISOFIX child seats

1
51
Child lock

1
55
Safety
Temporary puncture repair kit 156
Changing a wheel 1 61
Snow chains

1
68
Changing a bulb
1

69
Changing a fuse
1

76
Battery
1

82
el

ectrical energy economy mode
1
85
Changing a wiper blade
1

86
Towing the vehicle

1
87
Towing a trailer

1
89
Fitting roof bars

1
91
Advice on care and maintenance
1

92
Accessories


193
Practical information
Bonnet 19 6
Petrol engines 1 97
Diesel engines
1

98
Fuel tank

1
99
Misfuel prevention (Diesel)
20

1
Running out of fuel (Diesel)

2
03
AdBlue
® additive and SCR system
(Blue HDi Diesel) 2 04
Checking levels

2
12
Checks
2

15
Checks
general information 2 17
Petrol engines / weights 2 18
Diesel engines / weights

2
19
Dimensions


220
Identification markings
2

21
Technical data
emergency or assistance 223
7-inch Touch screen 2 25
Audio system / Bluetooth

2
97
Audio system

3
23
Audio equipment and telematics
Alphabetical index
Contents

8
Maintenance - Technical data
Identification markings 221
Dimensions 220
Changing bulbs
1

69-175
-

front
-

rear Running out of fuel, Diesel

2

03
Opening the bonnet

1

96
un

der the bonnet, petrol

1

97
un

der the bonnet, Diesel

1

98
Petrol engines

2

17-218
Diesel engines

2

17, 219 12V bat ter y
18

2-18 4
Load reduction, economy mode
1
85
en

gine compartment
f u s e s
17
6 -17 7, 181
Petrol weights
2
17-218
Diesel weights
2
17, 219
AdBlue additive
2

04-211
Checking levels
21

2-214
-

oil
-

b

rake fluid
-


coolant
-

s

creenwash fluid
-

a

dditive (Diesel with particle
emissions filter)
Checking components
2

15-216
-


battery
-
a

ir / passenger compartment filter
-

o

il filter
-

p

article emissions filter (Diesel)
-

b

rake pads / discs
Over view

12
eco-driving
eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently and change up without waiting.
During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you engage the most suitable gear: as
soon as the indication is displayed in the instrument panel, follow it
straight away.
For vehicles fitted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and CO
2
emissions and also helps reduce the background traffic noise.
If your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the
temperature in the passenger compartment down (sunroof and window
blinds...).
Switch off the air conditioning, unless it has automatic regulation,
as soon as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(film, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
eco-driving

16
Indicator and warning lamps
Certain warning lamps may come on in
one of two modes. Only by relating the
type of lighting to the operating status
of the vehicle can it be ascertained
whether the situation is normal or
whether a fault has occurred.When the ignition is switched on
Certain warning lamps come on for a
few seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously
(fixed) or flash.
Visual indicators informing the driver that a system is switched on (indicator or deactivation lamp) or has a fault (warning lamp).
Monitoring

19
Warning / indicator lampStateCause Action / Observations
Foot on the
clutch* fixed.
In the STOP mode of Stop & Start,
changing to START mode is refused
because the clutch pedal is not fully
down. You must declutch fully to allow the change to engine
S TA R T m o d e .
Stop & Star t fixed. When the vehicle stops (red lights,
traffic jams,
...) the Stop & Start
system has put the engine into STOP
mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
flashes for a
few


seconds, then
goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. For more information on special cases with STOP
mode and START mode, refer to the "Stop & Start"
section.
Automatic
wiping fixed.
The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
*
e
x
cept for the active matrix instrument panel.
1
Monitoring

33
Lighting dimmer control
System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
Tw o b u t t o n s
With the headlamps on, press button B to
increase the brightness of the instruments
and controls and the interior mood lighting or
button A to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
One button
Activation
F p ress the button to adjust the brightness of
the instruments and controls,
F

r
elease the button when the desired level is
attained.
Touch screen
F Press M ENU to display the "MAIN MENU"
then select "Preferences" .
F

F
rom the secondary page, select "Screen
preferences" .
F

A
djust the brightness by moving the cursor.
You can also switch of the screen. To do this:
F
Press MENU to display the "MAIN MENU"
then select "Preferences" .
F
Press "Turn off screen" . The screen goes
off completely.
P

ress the screen again (anywhere on its
sur face) to activate it.
Switching off
When the vehicle lighting is off or in day mode
(daytime running lamps on), pressing the button
has no effect.
1
Monitoring

41
Stop & Start time
counter
(minutes / seconds or hours /
minutes)
If dashes are displayed continuously
while driving in place of the digits,
contact a P
e

uge
O

T dealer or a
qualified workshop. This function is only displayed from
20

mph (30 km/h).
This value may vary following a change
in the style of driving or the relief,
resulting in a significant change in the
current fuel consumption.
Trip computer, a few definitions
Range
(miles or km)
The distance which can still be
travelled with the fuel remaining
in the tank (related to the
average fuel consumption over
the last few miles (kilometres)
travelled).
When the range falls below 20 miles (30 km),
dashes are displayed. After filling with at least
5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (100 km).
Current fuel consumption
(mpg or l/100 km or km/l)
Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
Calculated since the last trip
computer reset.
Average speed
(mph or km/h)
Calculated since the last trip
computer reset.
Distance travelled
(miles or km)
Calculated since the last trip
computer reset.
If your vehicle is fitted with Stop & Start, a time
counter calculates the time spent in STOP
mode during a journey.
It resets to zero every time the ignition is
switched on with the key.
1
Monitoring