2014 NISSAN VERSA SEDAN headlights

5
NiSSaN iNTelliGeNT KeY® SYSTeM (if so equipped)

The NISSAN Intelligent k ey® system allows you to
lock or unlock your vehicle, open your trunk and start
the engine.


It is important to make sure the Intelligent k ey is with
you (that is, in your pocket or purse).


The operating range of the Intelligent k ey is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle
request switch
01 once or press the
button
02
on the key fob.

To unlock the vehicle, perform one of the
following procedures:
• Push either door handle request switch

01 once;

the corresponding door will unlock. Push the door handle request switch 01 again within 5
seconds; all other doors will unlock, or
• Press the

button
03 on the key fob to unlock the driver’s side door. Press the
button
again; all other doors will unlock.

To open the trunk, press the button
04 for more than 1 second.


The Intelligent k ey can also be used to activate the panic alarm by pressing and holding \
the

button 05 for more than 1 second. Once activated, the panic alarm and headlights w\
ill stay

on for a period of time.
INTELLIGENT k EY BATTERY DIS cHARGE


If the battery of the Intelligent k ey is discharged, or
environmental conditions interfere with the Intelligent
k ey operation, start the engine according to the
following procedure:
1. Move the shift lever to the P (ParK) position.
2. Firmly apply the foot brake.
3.
Touch the ignition switch with the Intelligent k ey
and a chime will sound.
4.
Within 10 seconds after the chime sounds, push the ignition switch while depressing the
brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, “Starting and driving (section\
5)”
and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
0203
04
05
01
first drive features
1598305_14c_Versa_Sedan_QRG_091013.indd 59/10/13 12:18 PM
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi

7
heaDliGhT CoNTrol SwiTCh
HEADLIGHT c ONTROL

Turn the headlight control switch to the
position
01 to turn on the front parking, tail, license plate and
instrument panel lights. Turn the switch to the
position 02 to turn on the headlights.
01
02
ST
arTi NG/ST oPPiNG The e NGiN e
STARTING THE ENGINE

It is important to make sure the Intelligent k ey is
with you (that is, in your pocket or purse).
cONTINUOUSLY VARIABLE TRANSMISSION
(NISSAN Intelligent k ey
® models only - if so equipped)

Depress the brake pedal.
• If the brake pedal is not depressed, pushing the
ignition switch once enters the A cc mode.
• If the ignition is pushed a second time, the vehicle
will enter the ON mode.

Move the shift lever to P (P arK).

Push the ignition switch to start or stop the engine.
AUTOMATI c/MANUAL TRANSMISSION (if so equipped)

Depress the brake pedal.

Move the shift lever to N (N euTral)
(manual transmission only).

Depress the clutch (manual transmission only) pedal
to the floor.

Turn the ignition switch to ST arT.
TURNING THE ENGINE OFF

For a continuously Variable Transmission (NISSAN Intelligent k ey® models only - if so
equipped), apply the brake pedal, move the shift lever to the P (P arK) position, apply the
parking brake and push the ignition ST arT/SToP switch to turn the engine off.

For a manual transmission, apply the brake pedal, place the vehicle in 1s\
t gear, apply the
parking brake and turn the ignition switch to the loCK position.

For automatic transmission, apply brake pedal, move shift lever to P (P arK) position, apply
the parking brake, and turn the ignition switch to the loCK position.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1598305_14c_Versa_Sedan_QRG_091013.indd 79/10/13 12:18 PM
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi

8
first drive features
wiNDShiel D wiPer
aND waS her SwiTCh
Move the lever to the following positions to operate
the windshield wipers:

01 Mist (MiST) - One sweep operation of
the wipers.

02
Intermittent (iNT) - Move the lever down to the
intermittent position and then rotate the time
control ring
03 to increase or decrease wiper
speeds (if so equipped).

04 Low (lo) - Wipers operate at a continuous
low-speed.

05 High (hi) - Wipers operate at a continuous
high-speed.

06 Washer - Pull the lever toward you to

activate the washer. The wipers will operate several times.
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
0301
02
04
05
MiST
oFF
i NT
lo
hi
06
HIGH BEAM SELE cT

Push the headlight control switch forward
03
to select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.

Pull and release the headlight control switch
04 to
flash the headlight high beams on and off.
FOG LIGHT SWIT cH (if so equipped)

The headlights must be on and the low beams

selected for the fog lights to operate.

Turn the switch (inside collar) to the position
05
to turn the fog lights on.

Turn the switch (inside collar)
to the oFF position to
turn the fog lights off.
LANE c HANGE SIGNAL

To signal a lane change, move the lever up or down
to the point where the indicator light begins to flash,
but the lever does not latch.

The turn signal will flash three times automatically.
For more information, refer to the “instruments and controls (section 2)”
of your Owner’s Manual.
03
04
05
1598305_14c_Versa_Sedan_QRG_091013.indd 89/10/13 12:18 PM
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi