2014 MERCEDES-BENZ GL Keyless

[x] Cancel search: Keyless

Page 84 of 462

MERCEDES-BENZ GL 2014  Owners Manual seconds until the battery check lamp
flashes twice (Ypage 83).
iIf the setting of the locking system is
changed within the signal range of the
vehicle, pressing the�7or�6button:
Rlocks or
Runlocks the

Page 87 of 462

MERCEDES-BENZ GL 2014  Owners Manual Problems with the SmartKey
ProblemPossible causes/consequences and�P�PSolutions
You cannot lock or
unlock the vehicle
using the SmartKey.
The SmartKey battery is discharged or nearly discharged.
XTry

Page 88 of 462

MERCEDES-BENZ GL 2014  Owners Manual ProblemPossible causes/consequences and�P�PSolutions
The engine cannot be
started using the
SmartKey.
The on-board voltage is too low.
XSwitch off non-essential consumers, e.g. seat heating or interio

Page 89 of 462

MERCEDES-BENZ GL 2014  Owners Manual Unlocking and opening doors from
the inside
You can open a door from inside the vehicle
even if it has been locked. You can only open
the rear doors from inside the vehicle if they
are not secured by

Page 92 of 462

MERCEDES-BENZ GL 2014  Owners Manual opening or closing, this procedure is stopped.
If the tailgate is stopped during the closing
procedure, it will open again automatically.
The automatic obstacle recognition with
reversing function is

Page 93 of 462

MERCEDES-BENZ GL 2014  Owners Manual Rpress the closing or locking button on the
tailgate.
Rpull the handle on the tailgate.
GWARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. If the tailgate
is open when t

Page 97 of 462

MERCEDES-BENZ GL 2014  Owners Manual XMake sure that the SmartKey is in position
1or2in the ignition lock.
XTo open fully:press switch�Cand release.
XTo close fully:pull switch�Cand release.
XTo stop the closing procedure:press
switch�Ca

Page 98 of 462

MERCEDES-BENZ GL 2014  Owners Manual Proceed as follows if someone is trapped:
RRelease the�7button to interrupt the
closing procedure.
RPress and hold the�6button to open.
Vehicles with KEYLESS-GO:
RRelease the sensor surfaces on the ex