Problems with Night View Assist Plus
Problem Possible causes/consequences and
000B Solutions
The picture quality of
Night View Assist Plus
has deteriorated. The windshield wipers are smearing the windshield.
X
Replace the wiper blades (Y page 126). The windshield is smeared after the vehicle has been cleaned in a
car wash.
X
Cleant he windshield (Y page 314). There is windshield chip damage in the camera's field of vision.
X
Replace the windshield. The windshield is fogged up on the inside.
X
Defrost the windshield (Y page 140). The windshield is iced up.
X
De-ice the windshield (Y page 139). There is dirt on the inside of the windshield.
X
Cleant he inside of the windshield (Y page 314).Lane Tracking package
General notes The Lane Tracking package consistsofB
lind
Spot Assist (Y page 207) and Lane Keeping
Assist (Y page 209).
Blind Spot Assist General notes
Blind Spot Assist uses
aradar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from aspeed of
approximately 20 mph (30k m/h). Awarning
displa yinthe exterio rmirrors draws your
attention to vehicles detected in the
monitored area. If you the nswitc hont he
correspondin gturns ignal to change lanes,
you will also receive avisual and audible
collision warning. Blin dSpot Assist uses
sensors in the rear bumper for monitoring
purposes. For Blin
dSpot Assist to assist you, the radar
sensor system must be operational.
Important safety notes G
WARNING
Blin dSpot Assist does not reac tto:
R vehicles overtaken too closely on the side,
placin gthemint he blind spot area
R vehicles which approach with alarge speed
differential and overtake your vehicle
As aresult, Blind Spot Assist may not give
warnings in such situations. There is arisk of
an accident.
Always observe the traffic conditions
carefully, and maintain asafe lateral distance.
Blind Spot Assist is only an aid. It may fail to
detect some vehicles and is no substitute for
attentive driving. Always ensure that there is
sufficient distance to the side for other road
users and obstacles.
i USA only: Driving systems
207Driving and parking Z
X
Befor ecleaning the display ,make sure that
it is switched off and ha scooled down.
X Clean the display surface using a
commercially available microfiber cloth
and TFT/LCD display cleaner.
X Dry the display surface using adry
microfiber cloth.
Cleaning Night View Assist Plus !
Never clean the camera lens. When
cleaning the field of vision of the driving
systems, make sure that you do not spray
glass cleaner on the camera lens. If the
camera lens is dirty, visit aqualified
specialist workshop. X
Fold down the camera cover by recess 001A.X
Use asoft cloth to clean the windshield in
front of camera 0010. Cleaning the plastic trim G
WARNING
Care products and cleaning agents containing
solvent scause surfaces in the cockpit to
become porous. As aresult, plastic parts may
come loose in the event of air bag
deployment. There is arisk of injury.
Do not use any care products and cleaning
agents to clean the cockpit.
! Do not affix the following to plastic
surfaces:
R stickers
R films
R scented oil bottles or similar items
You can otherwise damage the plastic.
! Do not allow cosmetics, insect repellent
or sunscreen to come into contact with the
plastic trim. This maintains the high-quality
look of the surfaces.
X Wipe the plastic trim with adamp, lint-free
cloth, e.g. amicrofiber cloth.
X Heavy soiling: use care and cleaning
products recommended and approved by
Mercedes-Benz.
The surface may change color temporarily.
Wait until the surface is dry again.
Cleaning the steering wheel and gear or
selector lever X
Thoroughly wipe with adamp cloth or use
leather care agents that have been
recommended and approved by Mercedes-
Benz.
Cleaning genuine wood and trim
elements !
Do not use solvent-based cleaning agents
such as tar remover, wheel cleaners,
polishes or waxes. There is otherwise arisk
of damaging the surface.
! Do not use chrome polish on trim pieces.
The trim pieces have achrome look but are 316
CareMaintenance and care
