2014 MERCEDES-BENZ CLA engine

Engine
Display messagesPossible causes/consequences and
Solutions

Check Coolant See
Operator's Manual
The coolant level is too low.
!Avoid making long journeys with too little coolant in the engine
cooling system. The engine will otherwise be damaged.
XAdd coolant, observing the warning notes before doing so
(Ypage 283).
XIf coolant needs to be added more often than usual, have the
engine coolant system checked at a qualified specialist
workshop.
\rThe fan motor is faulty.
XAt coolant temperatures below 248 ‡ (120 †), drive to the
nearestqualified specialist workshop.
XAvoid subjecting the engineto heavy loads, e.g. driving in
mountainous terrain, and stop-and-go traffic.
\r
Coolant Too Hot
Stop Vehicle Turn
Engine Off
The coolant is too hot.
Awarning tone also sounds.
GWARNING
Do notdrive when yourengine is overheated. Thiscan cause some
fluids which may have leaked into the engine compartmentto
catch fire.
Steamfrom the overheated engine can also cause serious burns
which can occur just by opening the hood.
There is a risk of injury.
XPull over and stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
XSecure the vehicle against rolling away (Ypage 153).
XWaituntil the engine has cooled down.
XMake sure thatthe air supply to the engine radiator is not
blocked, e.g. by snow, slush or ice.
XDo not start the engine again until the display message goes out
and the coolant temperature is below 248 ‡ (120 †).
Otherwise, the engine could be damaged.
XPay attention to the coolant temperature display.
XIf the temperature increases again, visit a qualified specialist
workshop immediately.
Under normal operating conditions and with the specified coolant
level, the coolant temperature may rise to 248 ‡ (120 †).
Display messages227
On-board computer and displays
Z

Display messagesPossible causes/consequences and
Solutions
The battery is notbeing charged.
Awarning tone also sounds.
Possible causes are:
Ra defective alternator
Ra torn poly-V-belt
Ra malfunction in the electronics
XPull overand stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
XOpenthe hood.
XCheck whether the poly-V-belt is torn.
If the poly-V-belt is torn:
!Do not continue driving. The engine could otherwise overheat.
XConsult a qualified specialist workshop.
If the poly-V-belt is not damaged:
XVisit a qualified specialist workshop immediately.

Check Engine Oil
At Next Refueling
The engine oil level has dropped to the minimum level.
Awarning tone also sounds.
XCheckthe oil level when next refueling, at the latest
(Ypage 281).
XIf necessary, add engine oil (Ypage 282).
XHave the engine checked at a qualified specialist workshop if
engine oil needs to be added more often than usual.
!Avoid long journeys with too little engine oil. The engine will
otherwise be damaged.
Information on approved engine oils can be obtained from any
qualified specialist workshop or on the Internet at http://
bevo.mercedes-benz.com (USA only).


Fuel Level Low
The fuel level has dropped into the reserve range.
XRefuel at the nearest gas station.
228Display messages
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions
Blind Spot Assist
Currently
Unavailable See
Operator's Manual
Blind Spot Assistis temporarily inoperative. Possible causes are:
Rthe sensors are dirty.
Rfunction is impaired due to heavy rain or snow.
Rthe radar sensor system is outside the operating temperature
range.
Rthe radar sensor system is temporarily inoperative, e.g. due to
electromagnetic radiation emitted by nearby TV or radio
stations or other sources of electromagnetic radiation.
The yellowindicator lamps also light up in the exterior
mirrors.
When the causes stated above no longer apply, the display
message disappears.
Blind Spot Assist is operational again.
If the display message does not disappear:
XPull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
XSecure the vehicle against rolling away (Ypage 153).
XCleanthe sensors (Ypage 289).
XRestart the engine.
Blind Spot Assist
Inoperative
Blind Spot Assist is defective.
The yellowindicator lamps also light up in the exterior
mirrors.
XVisit a qualified specialist workshop.
Park Assist
Canceled
The driver's door is open and the driver's seat belt has not been
fastened.
XRepeatthe parking process with the seat belt fastened and the
driver's door closed.
You have inadvertently touched the multifunction steering wheel
while steering intervention was active.
XWhile steering intervention is active, make sure that the
multifunction steering wheel is not touched unintentionally.
The vehicle has started to skid and ESP®has intervened.
XUse Active Parking Assist again later (Ypage 178).
Display messages231
On-board computer and displays
Z

Display messagesPossible causes/consequences and
Solutions
Park Assist
Inoperative
You have just carried out a large number of turning or parking
maneuvers.
Active Parking Assistwill become available again after
approximately ten minutes (Ypage 178).
XPull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
XSwitch off and restart the engine.
If the display message continues to be displayed:
XVisit a qualified specialist workshop.
PARKTRONIC is defective.
XVisit a qualified specialist workshop.
DISTRONIC PLUS OffDISTRONIC PLUS has been deactivated (Ypage 164). If it was
deactivated automatically, a warning tone also sounds.
DISTRONICPLUSNow
Available
DISTRONIC PLUS is operational again after having been
temporarily unavailable. You can now reactivate DISTRONIC PLUS
(Ypage 164).
DISTRONIC PLUS
Currently
Unavailable See
Operator's Manual
DISTRONIC PLUS is temporarily inoperative. Possible causes are:
Rfunction is impaired due to heavy rain or snow.
Rthe sensors in the radiator trim are dirty
Rthe radar sensor system is temporarily inoperative, e.g. due to
electromagnetic radiation emitted by nearby TV or radio
stations or other sources of electromagnetic radiation.
Rthe system is outside the operating temperature range.
Rthe on-board voltage is too low.
Awarning tone also sounds.
When the causes stated above no longer apply, the display
message disappears.
DISTRONIC is operational again.
If the display message does notdisappear:
XPull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
XSecure the vehicle against rolling away (Ypage 153).
XClean the sensors in the radiator trim (Ypage 289).
XRestartthe engine.
232Display messages
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions
Tire Press.
Monitor Currently
Unavailable
Due to a source of radiointerference, no signals can be received
from the wheel sensors.The tire pressure monitor is temporarily
malfunctioning.
XDrive on.
The tire pressure monitor restarts automatically as soon as the
problem has been solved.
TirePress.
Sensor(s) Missing
There is no signal from the tire pressure sensor of one or several
wheels. The pressure of the affected tire is not displayed in the
multifunction display.
XHave the faulty tire pressure sensor replaced at a qualified
specialist workshop.
Tire Pressure
Monitor
Inoperative No
Wheel Sensors
The wheels mounted do not have a suitable tire pressure sensor.
The tire pressure monitor is deactivated.
XMount wheels with suitable tire pressure sensors.
The tire pressure monitor is activated automatically after driving
for a few minutes.
Tire Press.
Monitor
Inoperative
The tire pressure monitor is faulty.
XVisit a qualified specialist workshop.
Vehicle
Display messagesPossible causes/consequences and
Solutions
Shiftto'P'or'N'
to Start Engine
You have attempted to start the engine with the transmission in
positionRorD.
XShift the transmission to positionPorN.
Auxiliary Battery
Malfunction
The auxiliary battery for the automatic transmission is no longer
being charged.
XVisit a qualified specialist workshop at the next opportunity.
XUntil then, set the automatic transmission to positionPbefore
you switch off the engine.
XBefore leaving the vehicle, apply the electric parking brake.
Depress Brake to
Start Engine
You have attempted to start the engine with the transmission in
positionNwithout depressing the brake pedal.
XDepress the brake pedal.
236Display messages
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions
ToDeselectPorN,
Depress Brake and
Start Engine
You have attempted to shift the transmissionto positionRorD
without starting the engine.
XStart the engine.
XDepress the brake pedal.
iIt is only possible to shift the transmission from positionPto
the desired position if you depress the brake pedal. Only then
can the parking lock be deactivated. If you do not depress the
brake pedal, you can move the DIRECT SELECT lever but the
parking lock remains engaged.
iAt transmission fluid temperatures below4 ‡ (20 †) you
can only shift out of positionPinto another transmission
position when the engine is running.
Apply Brake to
Shift from 'P'
You have attempted to move the transmission selector lever to
positionR,NorDwithout depressing the brake pedal.
XDepress the brake pedal.
Transmission Not
in P
Risk of Vehicle
Rolling Away
The driver's door is open and the transmission is in positionR,N
orD.
Awarning tone also sounds.
XShift the transmission to positionP.
XSecure the vehicle against rolling away (Ypage 153).
Service Required
DoNotShiftGears
Visit Dealer
You cannotchange the transmission position due to a malfunction.
Awarning tone also sounds.
If transmission positionDis selected:
XDrive to a qualified specialist workshop without shifting the
transmission from positionD.
If transmission positionR,NorPis selected:
XNotify a qualified specialist workshop or breakdown service.
Only Sift to 'P'
when Vehicle
is Stationary
The vehicle is moving.
XPull overand stop the vehicle safely as soonas possible, paying
attention to road and traffic conditions.
XShift the transmission to positionP.
Reversing Not
Possible Service
Required
The automatic transmission is malfunctioning. You cannot back
up.
XVisit a qualified specialist workshop.
Display messages237
On-board computer and displays
Z

Display messagesPossible causes/consequences and
Solutions
Transmission
malfunction
The automatictransmission is malfunctioning.
XVisitaqualified specialist workshop.
Transmission
Malfunction Stop
The automatic transmission is malfunctioning.
XPull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
XSecure the vehicle against rolling away (Ypage 153).
XConsult a qualified specialist workshop.
StopVehicleShift
to P Leave Engine
Running
The automatic transmission has overheated.
XDrive on carefully.
The automatic transmission is available again when the display
message goes out.
If the display message continues to be displayed:
XPull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
XSecure the vehicle against rolling away (Ypage 153).
XWait until the automatic transmission has cooled down and the
display message has disappeared.
Trans. Oil
Overheated Drive
on with Care
AMG vehicles: the transmission oil has overheated.
Manual drive programMand the temporarily active manual drive
program are no longer available. The engine power output is
reduced.
XAllow the vehicle to cool down.
4matic Currently
Unavailable
4MATIC (permanentall-wheeldrive) has overheated. The vehicle
is only drivenby the frontwheels.
XDrive on.
The airflow cools 4MATIC more quickly.
When the display message goes out, 4MATIC is available again
and the vehicle is driven by all four wheels.
4matic Inoperative4MATIC is malfunctioning. The vehicle is only driven by the front
wheels.
XVisit a qualified specialist workshop.
The trunk lid is open.
XClose the trunk lid.
238Display messages
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions
Wiper
Malfunctioning
The windshield wipers are malfunctioning.
XVisit a qualified specialist workshop.
Hazard Warning
Flashers
Malfunctioning
The hazard warning lamps are faulty.
XVisit a qualified specialist workshop.
SmartKey
Display messagesPossible causes/consequences and
Solutions

Key Does Not
Belong to Vehicle
You have put the wrong SmartKey in the ignition lock.
XUse the correct SmartKey.

TakeYourKeyfrom
Ignition
The SmartKey is in the ignition lock.
XRemove the SmartKey.

Obtain a New Key
The SmartKey needs to be replaced.
XVisit a qualified specialist workshop.
Warning and indicator lamps in the instrument cluster
Seatbelts
ProblemPossible causes/consequences and
Solutions

After starting the
engine, the red seat
belt warning lamp lights
up for six seconds.
The seat belt warning lamp reminds the driver and frontpassenger
to fasten their seat belts.
XFastenyour seat belt (Ypage 50).

After starting the
engine, the red seat
belt warning lamp lights
up. In addition, a
warning tone sounds
for up to six seconds.
The driver's seat belt is not fastened.
XFasten your seat belt (Ypage 50).
The warning tone ceases.
240Warning and indicator lamps in the instrument cluster
On-board computer and displays