2014 LEXUS RX270 engine

5
587
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
If the engine will not start
If the engine will not start even though correct starting procedures are
being followed (→P. 180), consider each of the following points.
■The engine will not start, even though the starter motor operates
normally.
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●The engine may be flooded.
Try to restart the engine again following correct starting proce-
dures. (→P. 1 8 0 )
●There may be a malfunction in the engine immobilizer system.
(→P. 115)
■The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low vol-
ume.
One of the following may be the cause of the problem:
●The battery may be discharged. (→P. 5 9 4 )
●The battery terminal connections may be loose or corroded.
■The starter motor does not turn over.
The engine starting system may be malfunctioning due to an electri-
cal problem such as an open circuit or a blown fuse. However, an
interim measure is available to start the engine. (→P. 588)
RX350_270_EE_48D77E.book 587 ページ ２０１４年１月２４日　金曜日　午前１０時４分

588
5-2. Steps to take in an emergency
RX350/270_EE
Emergency start function
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the “ENGINE START STOP” switch
is functioning normally:
Set the parking brake.
Shift the shift lever to P.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch for about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may
be malfunctioning. Have the vehicle checked by any authorized Lexus
dealer or repairer, or another duly qualified and equipped professional.
■The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (→P. 5 9 4 )
●There may be a malfunction in the steering lock system.
Contact any authorized Lexus dealer or repairer, or another duly quali-
fied and equipped professional if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 588 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
589
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
If the shift lever cannot be shifted from P
If the shift lever cannot be shifted with your foot on the brake pedal, there
may be a problem with the shift lock system (a system to prevent accidental
operation of the shift lever). Have the vehicle inspected by any authorized
Lexus dealer or repairer, or another duly qualified and equipped profes-
sional immediately.
The following steps may be used as an emergency measure to ensure that
the shift lever can be shifted:
Set the parking brake.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Depress the brake pedal.
Press the shift lock override but-
ton.
The shift lever can be shifted
while the button is pressed.
STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 589 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
591
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
If the electronic key does not operate properly
Locking and unlocking the side doors and key linked functions
Use the mechanical key (→P. 2 7 )
in order to perform the following
operations (driver’s door only):
Locks all the doors
Closes the windows and moon
roof (turn and hold)
Unlocks all the doors
For some models:
An alarm will sound if the alarm is
set. (→P. 122)
Opens the windows and moon
roof (turn and hold)
If communication between the electronic key and vehicle is interrupted
(→P. 37) or the electronic key cannot be used because the battery is
depleted, the smart entry & start system and wireless remote control can-
not be used. In such cases, the doors can be opened and the engine can be
started by following the procedure below.
RX350_270_EE_48D77E.book 591 ページ ２０１４年１月２４日　金曜日　午前１０時４分

592
5-2. Steps to take in an emergency
RX350/270_EE
Starting the engine
Ensure that the shift lever is in P and depress the brake pedal.
Touch the Lexus emblem side of
the electronic key to the
“ENGINE START STOP” switch.
If any of the doors is opened or
closed after the key is being
touched to the switch, an alarm will
sound to indicate that the start
function cannot detect the elec-
tronic key.
Press the “ENGINE START STOP” switch within 10 seconds of
the buzzer sounding, keeping the brake pedal depressed.
In the event that the “ENGINE START STOP” switch still cannot be oper-
ated, contact any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
STEP1
STEP2
STEP3
RX350_270_EE_48D77E.book 592 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
593
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
■Stopping the engine
Shift the shift lever to P and press the “ENGINE START STOP” switch as you nor-
mally do when stopping the engine.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted.
(→P. 5 0 1 )
■Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered. (→P. 1 2 2 )
■Changing “ENGINE START STOP” switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the
“ENGINE START STOP” switch.
The engine does not start and modes will be changed each time the switch is
pressed. (→P. 1 8 1 )
RX350_270_EE_48D77E.book 593 ページ ２０１４年１月２４日　金曜日　午前１０時４分

594
5-2. Steps to take in an emergency
RX350/270_EE
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s
battery is discharged.
You can also call any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
If you have a set of jumper (or booster) cables and a second vehicle
with a battery, you can jump start your vehicle by following the steps
below.
Open the hood. Remove the battery cover. (→P. 4 7 1 )
RX270
STEP1
STEP2
RX350_270_EE_48D77E.book 594 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
595
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
RX350
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect a positive jumper cable clamp to the positive (+) battery
terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle.
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point away from the battery and any
moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain that level for approximately 5 min-
utes to recharge the battery of your vehicle.
Open and close any of the doors with the “ENGINE START
STOP” switch off.
Maintain the engine speed of the second vehicle and start the
engine of your vehicle by turning the “ENGINE START STOP”
switch to IGNITION ON mode.
STEP2
STEP3
STEP4
STEP5
RX350_270_EE_48D77E.book 595 ページ ２０１４年１月２４日　金曜日　午前１０時４分