2014 Lexus IS300h jump start

811-2. Hybrid system
1
For safety and security
IS300h_EE(OM53C61E)
■Regenerative braking
In the following situations, kinetic energy is converted to electric energy and decelera-
tion force can be obtained in conjunction with the recharging of the hybrid battery (trac-
tion battery).
●The accelerator pedal is released while driving with the shift lever in D or S.
●The brake pedal is depressed while driving with the shift lever in D or S.
■EV indicator
■Conditions in which the gasoline engine may not stop
The gasoline engine starts and stops automatically. However, it may not stop automati-
cally in the following conditions:
●During gasoline engine warm-up
●During hybrid battery (traction battery) charging
●When the temperature of the hybrid battery (traction battery) is high or low
●When the heater is switched on
■Charging the hybrid battery (traction battery)
●As the gasoline engine charges the hybrid battery (traction battery), the battery does
not need to be charged from an outside source. However, if the vehicle is left parked for
a long time the hybrid battery will slowly discharge. For this reason, be sure to drive the
vehicle at least once every few months for at least 30 minutes or 16 km (10 miles). If the
hybrid battery becomes fully discharged and you are unable to jump-start the vehicle
with a 12-volt battery, contact any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
●If the shift lever is in N, the hybrid battery (traction battery) will not be charged. Always
shift the shift lever to P when the vehicle is stopped. When driving in heavy traffic, oper-
ate the vehicle with the shift lever in D or S to avoid discharging the battery.
■Charging the 12-volt battery
→P. 5 4 9 The EV indicator comes on when the vehicle is
driven using only the electric motor (traction
motor) or the gasoline engine is stopped.
IS300h_EE_OM53C61E.book 81 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5478-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53C61E)
If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt
battery, you can jump start your vehicle by following the steps below.
Open the hood (→P. 4 3 7 ) a n d f u s e
box cover.
Remove the clips.
Push the tabs on either side to
detach the lock and lift the lid off
while pulling the lock plate.
Open the exclusive jump starting
terminal cover.
If the 12-volt battery is discharged
The following procedures may be used to start the hybrid system if the 12-volt
battery is discharged.
You can also call any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
1
1
2
2
IS300h_EE_OM53C61E.book 547 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5488-2. Steps to take in an emergency
IS300h_EE(OM53C61E)
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clamp to the exclusive jump starting ter-
minal on your vehicle.
Connect the clamp on the other end of the positive cable to the positive (+)
battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal on the
second vehicle.
Connect the clamp at the other end of the negative cable to a solid, station-
ary, unpainted metallic point away from the exclusive jump starting terminal
and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed slightly and
maintain at that level for approximately 5 minutes to recharge the 12-volt bat-
tery of your vehicle.
Open and close any of the doors of your vehicle with the power switch off.
Maintain the engine speed of the second vehicle and start the hybrid system
of your vehicle by turning the power switch to ON mode.
Make sure the “READY” indicator comes on. If the indicator does not come
on, contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional.3
1
2
3
4
4
5
6
7
IS300h_EE_OM53C61E.book 548 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5498-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53C61E)
Once the hybrid system has started, remove the jumper cables in the exact
reverse order from which they were connected.
Once the hybrid system starts, have the vehicle inspected at any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional as
soon as possible.
■Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
●Turn off any unnecessary electrical components when the vehicle is running at a low
speed for an extended period, such as in heavy traffic.
■Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and the draining effects of certain electrical appli-
ances. If the vehicle is left for a long time, the 12-volt battery may discharge, and the
hybrid system may be unable to start. (The 12-volt battery recharges automatically while
the hybrid system is operating.)
■When recharging or replacing the 12-volt battery
●For vehicles with an alarm: Make sure that the key is not inside the vehicle when
recharging or replacing the 12-volt battery. The key may be locked in the vehicle if the
alarm is activated. (→P. 9 8 )
●In some cases, it may not be possible to unlock the doors using the smart entry & start
system when the 12-volt battery is discharged. Use the wireless remote control or the
mechanical key to lock or unlock the doors.
●The hybrid system may not start on the first attempt after the 12-volt battery has
recharged but will start normally after the second attempt. This is not a malfunction.
●The power switch mode is memorized by the vehicle. When the 12-volt battery is
reconnected, the system will return to the mode it was in before the 12-volt battery was
discharged. Before disconnecting the 12-volt battery, turn the power switch off.
If you are unsure what mode the power switch was in before the 12-volt battery dis-
charged, be especially careful when reconnecting the 12-volt battery.
8
IS300h_EE_OM53C61E.book 549 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5518-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53C61E)
NOTICE
■When handling jumper cables
When connecting the jumper cables, ensure that they do not become entangled in the
cooling fans or belt.
■Exclusive jump starting terminal
The exclusive jump starting terminal is intended to charge the 12-volt battery on your
vehicle from another vehicle in an emergency. Do not use the exclusive jump starting
terminal to jump start another vehicle.
IS300h_EE_OM53C61E.book 551 ページ ２０１４年５月２０日　火曜日　午後５時４０分