2014 Lexus IS300h low beam

1062. Instrument cluster
IS300h_EE(OM53C61E)
The indicators inform the driver of the operating state of the vehicle’s various sys-
tems.
Indicators
Turn signal indicator
(→P. 222)

(if equipped)
Lexus parking assist-sensor
indicator (→P. 2 6 7 )
Tail light indicator
(→P. 2 2 6 )
*1, 2 Slip indicator
(→P. 2 8 7 )
Headlight high beam indi-
cator (→P. 2 2 6 )
*1VSC OFF indicator
(→P. 2 8 8 )
(if equipped)
Automatic High Beam indi-
cator (→P. 229)
*1, 3
(if equipped)
Pre-crash safety system
warning light (→P. 2 9 3 )
(if equipped)
Front fog light indicator
(→P. 2 3 3 )*4, 5
(if equipped)
BSM (Blind Spot Monitor)
outside rear view mirror
indicators (→P. 299)
Rear fog light indicator
(→P. 2 3 3 )
*6Security indicator
(→P. 9 0 , 9 6 )
(if equipped)
Cruise control indicator
(→P. 245, 249)*7Low outside temperature
indicator (→P. 1 0 9 )
(if equipped)
Dynamic radar cruise con-
trol indicator (→P. 2 4 9 )“READY” indicator
(→P. 2 0 9 )
(if equipped)
Cruise control “SET” indica-
tor (→P. 245, 249)EV indicator (→P. 8 1 )
(if equipped)
LDA (Lane Departure
Alert) indicator (→P. 2 6 1 )*8EV drive mode indicator
(→P. 2 1 4 )
IS300h_EE_OM53C61E.book 106 ページ ２０１４年５月２０日　火曜日　午後５時４０分

226
IS300h_EE(OM53C61E)4-3. Operating the lights and wipers
Turning the end of the lever turns on the lights as follows:
The front position, tail, license
plate and instrument panel
lights turn on.
The headlights and all lights
listed above turn on.
The headlights, daytime run-
ning lights and all the lights
listed above turn on and off
automatically.
(When the power switch is in
ON mode.)
The daytime running lights turn
on.
With the headlights on, push the
lever away from you to turn on the
high beams.
Pull the lever toward you to the center
position to turn the high beams off.
Pull the lever toward you and release
it to flash the high beams once.
You can flash the high beams with the
headlights on or off.
Headlight switch
The headlights can be operated manually or automatically.
Operating instructions
1
2
3
4
Turning on the high beam headlights
1
2
IS300h_EE_OM53C61E.book 226 ページ ２０１４年５月２０日　火曜日　午後５時４０分

2304-3. Operating the lights and wipers
IS300h_EE(OM53C61E)
When all of the following conditions are met, the high beam will be automatically
turned on (after approximately 1 second):
●Vehicle speed is above approximately 40 km/h (25 mph).
●The area ahead of the vehicle is dark.
●There are no oncoming or preceding vehicles with headlights or tail lights
turned on.
●There are few streetlights on the road ahead.
If any of the following conditions are met, the high beam will be automatically
turned off:
●Vehicle speed drops below approximately 30 km/h (19 mph).
●The area ahead of the vehicle is not dark.
●Oncoming or preceding vehicles have headlights or tail lights turned on.
●There are many streetlights on the road ahead.
■Switching to low beam
Pull the lever to the original position.
The Automatic High Beam indicator
will turn off.
Push the lever away from you to acti-
vate the Automatic High Beam sys-
tem again.
■Switching to high beam
Press the Automatic High Beam
switch.
The Automatic High Beam indicator
will turn off and the high beam indi-
cator will turn on.
Press the switch to activate the Auto-
matic High Beam system again.
High beam automatic turning on or off conditions
Turning the high beam on/off manually
IS300h_EE_OM53C61E.book 230 ページ ２０１４年５月２０日　火曜日　午後５時４０分

2314-3. Operating the lights and wipers
4
Driving
IS300h_EE(OM53C61E)
■The Automatic High Beam can be operated when
The power switch is in ON mode.
■Camera sensor detection information
●High beam may not be automatically turned off in the following situations:
• When oncoming vehicles suddenly appear from a curve
• When the vehicle is cut in front of by another vehicle
• When oncoming or preceding vehicles are hidden from sight due to repeated
curves, road dividers or roadside trees
●High beam may be turned off if an oncoming vehicle that is using fog lights without
using the headlights is detected.
●House lights, street lights, red traffic signals, and illuminated billboards or signs may
cause the high beam to turn off.
●The following factors may affect the amount of time taken to turn high beam on or off:
• The brightness of headlights, fog lights, and tail lights of oncoming and preceding
vehicles
• The movement and direction of oncoming and preceding vehicles
• When an oncoming or preceding vehicle only has operational lights on one side
• When an oncoming or preceding vehicle is a two-wheeled vehicle
• The condition of the road (gradient, curve, condition of the road surface etc.)
• The number of passengers and amount of luggage
●High beam may be turned on or off when unexpected by the driver.
●Small vehicles, such as bicycles, may not be detected.
●In the situations below, the system may not be able to correctly detect the surrounding
brightness levels, and may flash or expose nearby pedestrians to the high beam. There-
fore, you should consider turning the high beams on or off manually rather than relying
on the Automatic High Beam system.
• In bad weather (rain, snow, fog, sandstorms etc.)
• The windshield is obscured by fog, mist, ice, dirt etc.
• The windshield is cracked or damaged.
• The camera sensor is deformed or dirty.
• Surrounding brightness levels are equal to those of headlights, tail lights or fog lights.
• Vehicles ahead have headlights or tail lights that are either switched off, dirty, chang-
ing color, or have improperly adjusted aim.
• When driving through an area of intermittently changing brightness and darkness.
• When frequently and repeatedly driving ascending/descending roads, or roads with
rough, bumpy or uneven surfaces (such as stone-paved roads, gravel tracks etc.).
• When frequently and repeatedly taking curves or driving on a winding road.
• There is a highly reflective object ahead of the vehicle, such as a sign or a mirror.
• The vehicle’s headlights are damaged or dirty.
• The vehicle is listing or titling, due to a flat tire, a trailer being towed etc.
• The driver believes that the high beam may be causing problems or distress to other
drivers or pedestrians nearby.
• The vehicle is used in a territory in which vehicles travel on the opposite side of the
road of the country for which the vehicle is approved, for example using a vehicle
designed for right-hand traffic in a left-hand traffic territory, or vice versa.
IS300h_EE_OM53C61E.book 231 ページ ２０１４年５月２０日　火曜日　午後５時４０分

2324-3. Operating the lights and wipers
IS300h_EE(OM53C61E)
CAUTION
■Limitations of the Automatic High Beam
Do not rely on the Automatic High Beam. Always drive safely, taking care to observe
your surroundings and turning high beam on or off manually if necessary.
NOTICE
■Notes when using the Automatic High Beam system
●Do not touch the camera sensor.
●Do not subject the camera sensor to a strong impact.
●Do not disassemble the camera sensor.
●Do not spill liquid onto the camera sensor.
●Do not apply window tinting or stickers to the camera sensor or the area of wind-
shield near the camera sensor.
●Do not place items on the dashboard. There is a possibility that the camera sensor will
mistake items reflected in the windshield for streetlights, the headlights of other vehi-
cles, etc.
●Do not install a parking tag or any other accessories near or around the camera sen-
sor.
●Do not overload the vehicle.
●Do not modify the vehicle.
●Do not replace windshield with non-genuine windshield.
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
Observe the following to ensure that the Auto-
matic High Beam functions correctly.
IS300h_EE_OM53C61E.book 232 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5178-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53C61E)
Indicates a malfunction in:
• The automatic headlight leveling system; or
• The Automatic High Beam system (if equipped)
• The LED headlight system (if equipped)
A buzzer also sounds.
→Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
Indicates that the accelerator and brake pedal are being
depressed simultaneously
→Release the accelerator or brake pedal.
Indicates that the cooling performance of the hybrid bat-
tery (traction battery) has dropped
→Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
Indicates that the washer fluid level is low
→Add washer fluid.
Indicates that remaining fuel is approximately 10 L (2.6
gal., 2.2 Imp. gal.) or less
→Refuel the vehicle.
Indicates that the TRC (Traction Control) system has
been deactivated
→Tu r n t h e T R C o n . (→P. 288)
(If equipped)
Indicates that all maintenance according to the driven
distance on the maintenance schedule
*1 should be per-
formed soon.
→If necessary, perform maintenance.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
IS300h_EE_OM53C61E.book 517 ページ ２０１４年５月２０日　火曜日　午後５時４０分

5188-2. Steps to take in an emergency
IS300h_EE(OM53C61E)
(If equipped)
Indicates that all maintenance listed in the maintenance
schedule*1 corresponding to the current vehicle mile-
age is necessary.
(The indicator will not work properly unless the mainte-
nance data has been reset.)
→Perform the necessary maintenance. Please reset
the maintenance data after the maintenance is per-
formed (→P. 4 4 2 )
(If equipped)
Indicates that the Automatic High Beam switch is
pressed while the headlights are in low beam.
→Turn the high beam on and press the Automatic
High Beam switch again.
(If equipped)
Indicates that, since the VSC (Vehicle Stability Control)
system was turned off, the pre-crash brake system oper-
ation is stopped
→Tu r n t h e V S C o n . (→P. 2 8 8 )
(If equipped)
Indicates that the PCS (Pre-Crash Safety system) is not
currently functional because the grille cover or the sen-
sor is dirty
→Check the grille cover and the sensor and clean
them if they are dirty.
Indicates that operation of large electricity consuming
systems such as the air conditioning system are sus-
pended
→Stop using unnecessary electric components to
reduce electricity consumption. Wait a while until
the electric power supply is restored.
(If equipped)
Indicates that the LDA (Lane Departure Alert) system
cannot be used because the vehicle speed is lower than
approximately 50 km/h (32 mph)
→Drive the vehicle at 50 km/h (32 mph) or higher.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
IS300h_EE_OM53C61E.book 518 ページ ２０１４年５月２０日　火曜日　午後５時４０分

591Alphabetical index
IS300h_EE(OM53C61E)
Airbag manual on-off system ............. 54
Alarm ............................................................ 96
Anchor brackets ...................................... 69
Antennas (smart entry &
start system) ......................................... 149
Anti-lock Brake System (ABS) .......286
Function ..................................................286
Warning light ...................................... 504
Approach warning ............................... 254
Armrest ..................................................... 422
ASC (Active Sound Control).......... 225
Assist grips .............................................. 424
Audio input .............................................. 323
Audio system ........................................... 316
Audio CD player .................................341
Audio input ........................................... 323
AUX port/
USB port ............................................ 323
Bluetooth
® audio ..............................365
iPod...........................................................348
Optimal use ............................................331
Portable music player......................356
Radio ........................................................339
Steering wheel audio switch ........ 322
USB memory........................................ 351Automatic headlight leveling
system ................................................... 228
Warning light.......................................505
Automatic High Beam ...................... 229
Automatic light control system ...... 226
AUX port................................................. 323
Average fuel economy ......................... 116
Average vehicle speed ......................... 116
Back-up light
Replacing light bulb ......................... 485
Wattage ................................................. 570
Battery (12-volt battery) .....................447
If the 12-volt battery is
discharged ........................................ 547
Preparing and checking
before winter........................................ 311
Warning light....................................... 503
Battery (traction battery) ..................... 83
Blind Spot Monitor (BSM) .............. 299
Blower customization......................... 405
Bluetooth
®
Audio system....................................... 365
Hands-free system
(for cellular phone) ....................... 367
Bottle holders...........................................415
B
IS300h_EE_OM53C61E.book 591 ページ ２０１４年５月２０日　火曜日　午後５時４０分