2014 Lexus GS250 lights

2324-1. Before driving
GS350_250_OM_OM30E16E_(EE)
■Tire information
●Increase the tire inflation pressure to 20.0 kPa (0.2 kgf/cm2 or bar, 3 psi) greater
than the recommended value when towing. ( →P. 6 4 5 )
●Increase the air pressure of the trailer tires in accordance with the total trailer
weight and according to the values recommended by the manufacturer of your
trailer.
■Trailer lights
●Please consult at any authorized dealer or repairer, or another duly qualified and
equipped professional when installing trailer lights, as incorrect installation may
cause damage to the vehicle’s lights. Please take care to comply with your state’s
laws when installing trailer lights.
●Check that the turn signal lights and stoplights are operating correctly every time
you hitch up the trailer. Directly wiring up to your vehicle may damage the electrical
system and stop the lights from functioning correctly.
■Break-in schedule
Lexus recommends that vehicles fitted with new power train components should not
be used for towing trailers for the first 800 km (500 miles).
■Safety checks before towing
●Check that the maximum load limit for the towing hitch/bracket and hitch ball is not
exceeded. Bear in mind that the coupling weight of the trailer will add to the load
exerted on the vehicle. Also make sure that the total load exerted on the vehicle is
within the range of the weight limits. ( →P. 2 2 8 )
●Ensure that the trailer load is secure.
●Supplementary outside rear view mirrors should be added to the vehicle if the traf-
fic behind cannot be clearly seen with standard mirrors. Adjust the extending arms
of these mirrors on both sides of the vehicle so that they always provide maximum
visibility of the road behind.
■Maintenance
●Maintenance must be performed more frequently when using the vehicle for tow-
ing due to the greater weight burden placed on the vehicle compared to normal
driving.
●Retighten all bolts securing the hitching ball and bracket after towing for approxi-
mately 1000 km (600 miles).
GS350_250_OM_OM30E16E_(EE).book Page 232 Tuesday, July 8, 201 4 7:11 PM

2334-1. Before driving
4
Driving
GS350_250_OM_OM30E16E_(EE)
Your vehicle will handle differently when towing a trailer. In order to avoid
accident, death or serious injury, keep the following in mind when towing:
■Checking connections between trailer and lights
Stop the vehicle and check the operation of the connection between
the trailer and lights after driving for a brief period as well as before
starting off.
■Practicing driving with a coupled trailer
●Get the feel for turning, stopping and reversing with the trailer cou-
pled by practicing in an area with no or light traffic.
●When reversing with a coupled trailer, hold the section of the steer-
ing wheel nearest to you and rotate clockwise to turn the trailer left
or counterclockwise to turn it right. Always rotate a little at a time to
prevent steering error. Have someone guide you when reversing to
lessen the risk of an accident.
NOTICE
■When the rear bumper strengthening material is aluminum
Ensure the steel bracket part does not come directly in contact with that area.
When steel and aluminum come into contact, there is a reaction similar to corro-
sion, which will weaken the section concerned and may result in damage. Apply a
rust inhibitor to parts that will come in contact when attaching a steel bracket.
Guidance
GS350_250_OM_OM30E16E_(EE).book Page 233 Tuesday, July 8, 201 4 7:11 PM

2544-2. Driving procedures
GS350_250_OM_OM30E16E_(EE)
■Turn signals can be operated when
The engine switch is in IGNITION ON mode.
■If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
■If the turn signals stop flashing before a lane ch ange has been performed
Operate the lever again.
■Customization
The number of times the turn signals flash during a lane change can be changed.
(Customizable feature →P. 6 5 0 )
GS350_250_OM_OM30E16E_(EE).book Page 254 Tuesday, July 8, 201 4 7:11 PM

2574-2. Driving procedures
4
Driving
GS350_250_OM_OM30E16E_(EE)
■When there is a malfunction in the system
Warning lights and/or warning message will turn on or flash. (→P. 5 4 4 , 5 5 2 )
Depending on the condition, the parking brake indicator light may flash.
■Usage in winter time
→ P. 3 5 4
NOTICE
■When parking the vehicle
Before you leave the vehicle, set the parking brake, shift the shift lever to P and
make sure that the vehicle does not move.
■When the system malfunctions
Stop the vehicle in a safe place and check the warning messages.
■When the parking brake cannot be released due to a malfunction
Use the parking brake release tool to manually release the parking brake.
( → P. 6 1 5 )
Driving the vehicle with the parking brake set will lead to brake components over-
heating, which may affect braking performance and increase brake wear.
GS350_250_OM_OM30E16E_(EE).book Page 257 Tuesday, July 8, 201 4 7:11 PM

259
4
4-3. Operating the lights and wipers
Driving
GS350_250_OM_OM30E16E_(EE)
Headlight switch
Turning the end of the lever turns on the lights as follows:
The front position, tail,
license plate and instru-
ment panel lights turn on.
The headlights and all lights
listed above turn on.
The headlights, daytime
running lights and all the
lights listed above turn on
and off automatically.
(When the engine switch is
in IGNITION ON mode.)
The daytime running lights
turn on.
The headlights can be operated manually or automatically.
Operating instructions
1
2
3
4
GS350_250_OM_OM30E16E_(EE).book Page 259 Tuesday, July 8, 201 4 7:11 PM

2604-3. Operating the lights and wipers
GS350_250_OM_OM30E16E_(EE)
With the headlights on, push the
lever away from you to turn on
the high beams.
Pull the lever toward you to the center
position to turn the high beams off.
Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
This system allows the headlights and front position lights to be turned on
for 30 seconds when the engine switch is off.
Pull the lever toward you and
release it with the light switch is in or after turning the engine
switch off.
Pull the lever toward you and release it
again to turn off the lights.
Turning on the high beam headlights
1
2
Follow me home system
GS350_250_OM_OM30E16E_(EE).book Page 260 Tuesday, July 8, 201 4 7:11 PM

2614-3. Operating the lights and wipers
4
Driving
GS350_250_OM_OM30E16E_(EE)
AFS (Adaptive Front-lighting System) secures excellent visibility at inter-
sections and on curves by automatically adjusting the direction of the light
axis of the headlights according to vehicle speed and the degree of the
tire’s angle as controlled by steering input.
AFS operates at speeds of 10 km/h (6 mph) or higher.
■Deactivating AFS
Turn on the AFS OFF switch.
The indicator turns on when the
AFS is deactivated.
AFS (Adaptive Front-lighting System) (if equipped)
GS350_250_OM_OM30E16E_(EE).book Page 261 Tuesday, July 8, 201 4 7:11 PM

2624-3. Operating the lights and wipers
GS350_250_OM_OM30E16E_(EE)
■Daytime running light system
To make your vehicle more visible to other drivers, the front position lights turn on
automatically whenever the engine is started and the parking brake is released. Day-
time running lights are not designed for use at night.
■Headlight control sensor
■Automatic light off system
●When the light switch is in : The headlights turn off automatically if the engine
switch is turned to ACCESSORY mode or turned off.
●When the light switch is in : The headlights and all lights turn off automatically if
the engine switch is turned to ACCESSORY mode or turned off.
To turn the lights on again, turn the engine switch to IGNITION ON mode, or turn
the light switch off once and then back to or .
If any of the doors or trunk lid is kept op en, the lights automatically turn off after 20
minutes.
■Light reminder buzzer
A buzzer sounds when the engine switch is turned off or turned to ACCESSORY
mode and the driver’s door is opened while the lights are turned on.
■Automatic headlight leveling system
The level of the headlights is automatically adjusted according to the number of pas-
sengers and the loading condition of the vehicle to ensure that the headlights do not
interfere with other road users. The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the wind-
shield.
Doing so interferes with the sensor detecting
the level of ambient light and may cause the
automatic headlight system to malfunction.
GS350_250_OM_OM30E16E_(EE).book Page 262 Tuesday, July 8, 201 4 7:11 PM