2014 Lancia Delta brake

200
IN AN EMERGENCY
INFLATION PROCEDURE
Put on the protective gloves provided
with the quick tyre repair kit.
❍Engage the handbrake. Unscrew the tyre valve cap,
take out the filler hose A - fig. 4 and tighten the ring
nut B on the tyre valve;
fig. 4
L0E0077m
The bottle contains ethylene glycol. It con-
tains latex that might cause allergic reac-
tions. It is harmful if swallowed. It is irri-
tant for the eyes. It may cause sensitisation if in-
haled or on contact. Avoid contact with eyes, skin
and clothes. In the event of contact, wash immedi-
ately with plenty of water. Do not induce vomiting
if swallowed. Rinse your mouth and drink plenty of
water. Call a doctor immediately. Keep out of the
reach of children. The product must not be used by
asthmatics. Do not breathe in the vapours during
insertion and suction. Call a doctor immediately if
allergic reactions are noted. Store the bottle in the
specific compartment, away from sources of heat.
The sealant has an expiry date.Replace the bottle containing out-of-date
sealant. Dispose of the bottle and the sealant
properly. Dispose of the components in com-
pliance with national and local regulations.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 200

IN AN EMERGENCY
201
4
❍make sure that switch C - fig. 5 for the compressor is
in position 0 (off), start the engine, insert pin E - fig.
5a into the power socket and switch on the compres-
sor by placing switch C - fig. 5 in position I (on);
❍inflate the tyre to the pressure specified in the “Infla-
tion pressure” paragraph, in chapter “6”. For a more
accurate reading, check pressure value on pressure
gauge D - fig. 5 with the compressor off;
❍if after 5 minutes you cannot reach at least 1.5 bar, un-
plug the compressor from the valve and the power
socket, then move the car forward about 10 metres in
order to distribute the sealant inside the tyre evenly,
then repeat the
inflation operation;
fig. 5
L0E0078m
fig. 5a
L0E0288m
❍if after this operation it is still not possible to reach at
least 1.8 bar after 5 minutes, do not start driving since
the tyre is excessively damaged and the quick tyre re-
pair kit cannot guarantee suitable sealing. Contact a
Lancia Dealership;
❍if the tyre reaches the pressure specified in the “Infla-
tion pressure” paragraph in chapter “6”, start driving
immediately;
Apply the adhesive label in a position clear-
ly visible by the driver as a reminder that the
tyre has been treated with the quick repair
kit. Drive carefully, particularly on bends. Do not
exceed 80 km/h. Do not accelerate or brake sud-
denly.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 201

202
IN AN EMERGENCY
❍after driving for about 10 minutes stop and check the
tyre pressure again; pull up the handbrake
If the pressure falls below 1.8 bar, do not dri-
ve any further: the Fix & Go automatic quick
tyre repair kit cannot guarantee suitable
sealing because the tyre is too damaged. Contact a
Lancia Dealership.
❍if you get a pressure reading of at least 1.8 bar, re-
store the correct pressure (with engine running and
handbrake on) and resume driving;
❍drive with the utmost care to the nearest Lancia Deal-
ership.
Inform the Dealership that the tyre has been
repaired using the quick tyre repair kit. Give
the booklet to the personnel charged with
handling the treated tyre.
CHECKING AND RESTORING TYRE PRESSURE
The compressor can also be used solely for restoring pres-
sure. Release the quick coupling and connect directly to
the tyre valve fig. 6; in this way, the bottle will not be con-
nected to the compressor and no sealant will be injected.
fig. 6
L0E0287m
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 202

206
IN AN EMERGENCY
❍rest the subwoofer to one side in the luggage com-
partment, remove the container and take out the space-
saver wheel;
❍change the wheel as described in this chapter.
At the end of the operation:
❍reposition the container and place the subwoofer on
top of it, taking care to position it according to the in-
structions on the container (fig. 9) so that the arrow
on the spacer is pointing in the direction of travel.
❍rest cable B - fig. 8 on velcro attachment C to avoid
pinching it. Then tighten locking device A - fig. 8. Low-
er the luggage compartment mat.
fig. 9
L0E0177m
TAKING OUT THE SPACE-SAVER WHEEL
Please note that:
❍the jack weight is 1.76 kg;
❍the jack requires no adjustment;
❍the jack cannot be repaired; if it breaks, it must be
replaced with a new one of the same type;
❍no tool other than its cranking device may be fitted on
the jack.
To change a wheel, proceed as follows:
❍stop the car where it is not a danger to other road users
and you can replace the wheel safely. The ground
should be flat if possible, and sufficiently firm;
❍turn the engine off and engage the handbrake;
❍engage first gear or reverse;
❍lift up the luggage compartment mat using handle
A - fig. 10 (in the presence of a double load compart-
ment, first lift the upper cover and then the luggage
compartment mat).
❍unscrew the locking device B - fig. 10;
❍take out the tool box C and place it next to the wheel
to be changed;
❍take out the space-saver wheel D - fig. 10;
❍use the provided screwdriver to remove the hub cap,
levering the dedicated opening on the outer edge;
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 206

IN AN EMERGENCY
213
4
LED
LED
D1S(*) / H7
H1(*) / H7
PY 24W
LED
WY5W
LED
LED
W5W
H11
W16W
W16W
5L/5K
12V 5W
12V 5W
W5W
–
–
D
D
B
–
A
–
–
C
E
B
B
–
C
C
A
–
–
55 W
55 W
24 W
–
5 W
–
–
5 W
55 W
16 W
16 W
–
5 W
5 W
5 W
Bulbs Type Power Figure ref.Front side lights/Daytime running lightsRear side lightsDipped beam headlightsMain beam headlightsFront direction indicatorRear direction indicatorSide direction indicatorBrake lightThird brake lightNumber plate lightFog lightsRear fog lightReverse lightFront roof light (white LEDs)Rear roof light
Glove compartment/luggage compartment lightPuddle light
(*) Xenon gas discharge bulb
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 213

218
IN AN EMERGENCY
THIRD BRAKE LIGHT fig. 23
Contact a Lancia Dealership to replace the third brake
LED lights.
NUMBER PLATE LIGHTS
To replace the bulb proceed as follows:
❍remove the lens units A - fig. 24 by acting on the points
shown by the arrows;
❍remove the bulb B and replace it.
fig. 23
L0E0162m
fig. 25
L0E0282m
fig. 24
L0E0163m
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 218

IN AN EMERGENCY
227
4
F12
F12
F13
F13
F31
F33
F34
F35
F36
F37
F38
F39
F40
F41
7.5
15
7.5
15
5
20
20
5
20
7,5
10
10
30
7.5
39
39
39
39
39
39
39
39
39
39
39
39
39
39
FUSE SUMMARY TABLEELECTRIC DEVICES FUSE AMPERE FIGURERight dipped beam headlight Right dipped beam headlight (Xenon gas discharge bulb) Left dipped beam headlight, headlight alignment correctorLeft dipped beam headlight (Xenon gas discharge bulb) Climate control system fan relay coil, Body ComputerRear left electric windowRear right electric window
Reversing lights, engine compartment junction unit relay coils,
brake light pedal control (normally closed contact), water in diesel sensor, flow meter Central locking system control unit, fuel flap, dead lock, tailgate release
Third brake light, instrument panel, Adaptive Headlights Node, control unit on left-hand gas discharge headlight
Front roof lights, rear central roof light,
driver side and passenger side sun visor lights, luggage compartment light, glove compartment light (Platinum trim level with optional sun roof)
Radio setup/Radio/Radio Navigator, Blue&Me
TMnode, alarm siren, alarm
system on roof light, climate control unit, tyre pressure monitoring control
unit, diagnosis socket connector, rear roof lightsHeated rear windowElectric door mirror demisters, demisters on windscreen jets
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 227

232
IN AN EMERGENCY
When towing, remember that without the help
of the brake servo and electric power steer-
ing, a greater effort is required on the pedal
and steering wheel. Do not use flexible cables when
towing and avoid jerky movements. During towing,
make sure that the trailer hitch does not damage any
components it is touching. When towing the car, it
is compulsory to respect specific highway code reg-
ulations relating to the tow hook and procedures for
towing on the road. Do not start the engine while
towing the car. Before tightening the ring clean the
threaded housing thoroughly. Make sure that the
ring is securely fastened before towing the car.
The front and rear tow hooks must only be
used for emergency situations on the road.
The car may be towed for short distances
when a dedicated device is used in compliance with
the Highway Code (rigid bar), and in order to move
the vehicle on the road in preparation for towing
or transport via a breakdown vehicle. Tow hooks
MUST NOT be used to tow vehicles off the road or
where there are obstacles and/or for towing oper-
ations using cables or other non-rigid devices. Re-
specting the above conditions, towing must take
place with two vehicles (one towing, the other towed)
aligned as much as possible along the same centre
line.
Before towing, turn the ignition key to MAR
and then to STOP without removing it. The
steering column will automatically lock when
the key is removed and the wheels cannot be steered.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 232