2014 JEEP WRANGLER UNLIMITED oil level

ENGINE BREAK-IN RECOMMENDATIONS • A long break-in period is not required for the engine and drivetrain (transmission
and axle) in your vehicle.
• Drive moderately during the first 300 miles (500 km). After the initial 60 miles
(100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
• While cruising, brief full-throttle acceleration within the limits of local traffic laws
contributes to a good break-in. Wide-open throttle acceleration in low gear can be
detrimental and should be avoided.
• The engine oil installed in the engine at the factory is a high-quality energy
conserving type lubricant. Oil changes should be consistent with anticipated
climate conditions under which vehicle operations will occur. For the recom-
mended viscosity and quality grades, refer to “Maintaining Your Vehicle”.
NOTE:
A new engine may consume some oil during its first few thousand miles (kilome-
ters) of operation. This should be considered a normal part of the break-in and not
interpreted as an indication to an engine problem or malfunction.
CAUTION!Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may
result.
TURN SIGNAL/LIGHTS LEVER
Headlights/Parking Lights/Automatic Headlights
• Rotate the end of the lever to the first detent for parking lights , the second
detent for headlights , and the third detent for AUTO.
• When set to AUTO, the system automatically turns the headlights on or off based
on ambient light levels.OPERATING YOUR VEHICLE
23

FLUIDS AND CAPACITIES Component Fluid, Lubricant, or Genuine Part Capacities
Engine Coolant–
3.6L Engine We recommend you use MOPAR ®
Antifreeze/
Coolant 10 Year/150,000 Mile Formula OAT
(Organic Additive Technology). 10.5 Quarts
(9.9 Liters)
Includes coolant
recovery bottle
filled to MAX level.
Engine Oil with
filter–3.6L Engine We recommend you use API Certified
SAE 5W-20 Engine Oil, meeting the re-
quirements of Chrysler Material Standard
MS-6395 such as MOPAR, Pennzoil ®
, and
Shell Helix ®
. Refer to your engine oil filler
cap for correct SAE grade. 6 quarts
(5.7 Liters)
Engine Oil Filter–
3.6L Engine We recommend you use MOPAR ®
brand
Engine Oil Filters. —
Spark Plug–
3.6L Engine We recommend you use MOPAR ®
Spark
Plugs (Gap 0.043 in [1.1 mm]). —
Automatic
Transmission We recommend you ONLY use MOPAR ®
ATF+4 ®
Automatic Transmission Fluid.
Failure to use ATF+4 ®
fluid may affect the
function or performance of your transmission. —
Manual
Transmission We recommend you use MOPAR ®
Manual
Transmission Lubricant. —
Transfer Case We recommend you use MOPAR ®
ATF+4 ®
Automatic Transmission Fluid. —
Axle differential
(front) We recommend you use MOPAR ®
Gear &
Axle Lubricant (SAE 80W-90) (API GL-5). —
Axle differential
(rear) 226 RBI (Model 44) - We recommend you
use MOPAR ®
Gear & Axle Lubricant
(SAE 80W-90) (API GL-5). For trailer
towing,We recommend you use MOPAR ®
Synthetic Gear & Axle Lubricant
(SAE 75W-140). Models equipped with
Trac-Lok™ require an additive. —
Brake Master
Cylinder We recommend you use MOPAR ®
DOT 3
Brake Fluid, SAE J1703. If DOT 3,
SAE J1703 brake fluid is not available,
then DOT 4 is acceptable. —
Power Steering
Reservoir We recommend you use MOPAR ®
Power
Steering Fluid +4, MOPAR ®
or ATF+4 ®
Automatic Transmission Fluid. —
Fuel Selection
2 Door 87 Octane 18.6 Gallons
(70 Liters)
(Approximate)
Fuel Selection
4 Door 87 Octane 22.5 Gallons
(85 Liters)
(Approximate)MAINTAINING YOUR VEHICLE
114

On Electronic Vehicle Information Center (EVIC) equipped vehicles, “Oil Change
Required” will be displayed in the EVIC and a single chime will sound, indicating that
an oil change is necessary.
On Non-EVIC equipped vehicles, “Change Oil” will flash in the instrument cluster
odometer and a single chime will sound, indicating that an oil change is necessary.
Your authorized dealer will reset the oil change indicator message after completing
the scheduled oil change. If a scheduled oil change is performed by someone other
than your authorized dealer, the message can be reset by referring to the steps
described under “Electronic Vehicle Information Center (EVIC)/Oil Change Re-
quired” in “Understanding Your Instrument Panel” or under “Instrument Cluster
Description/Odometer/Trip Odometer” in “Understanding Your Instrument Panel” for
further information.
NOTE:
Under no circumstances should oil change intervals exceed 10,000 miles (16,000 km)
or twelve months, whichever comes first.
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual wear or damage
• Check the fluid levels of the coolant reservoir, brake master cylinder, power
steering and automatic transmission, and fill as needed
• Check function of all interior and exterior lights
Required Maintenance Intervals .
Refer to the maintenance schedules on the following page for the required mainte-
nance intervals. At Every Oil Change Interval As Indicated By Oil Change Indicator System:
•
Change oil and filter
• Rotate the tires. Rotate at the first sign of irregular wear, even if it occurs before the oil
indicator system turns on.
•
Inspect battery and clean and tighten terminals as required
•
Inspect automatic transmission fluid if equipped with dipstick
•
Inspect brake pads, shoes, rotors, drums, hoses and park brake
•
Inspect engine cooling system protection and hoses
•
Inspect exhaust system
•
Inspect engine air cleaner if using in dusty or off-road conditions
•
Inspect all door latches for presence of grease, reapply if necessary.MAINTAINING YOUR VEHICLE
116