Page 116 of 674

SEATS ............................. .140
▫ Power Seats — If Equipped ..............141
▫ Power Lumbar — If Equipped ............143
▫ Manual Front Seats Forward/Rearward
Adjustment ........................ .144
▫ Manual Front Passenger Seatback Adjustment —
Recline ........................... .145
▫ Front Passenger Seat Fold-Flat Feature — If
Equipped .......................... .146
▫ Heated Seats — If Equipped ..............146
▫ Front Ventilated Seats — If Equipped .......149
▫ Head Restraints ..................... .150
▫ 60/40 Split Rear Seat ..................154
▫ Reclining Rear Seat ....................156
DRIVER MEMORY SEAT — IF EQUIPPED . . . .157
▫ Programming The Memory Feature .........158
▫ Linking And Unlinking The Remote Keyless
Entry Transmitter To Memory .............159
▫ Memory Position Recall .................160
▫ Easy Entry/Exit Seat ...................161
TO OPEN AND CLOSE THE HOOD .........162
LIGHTS ............................ .163
▫ Headlight Switch .....................163
▫ Automatic Headlights — If Equipped .......164
▫ Headlights On Automatically With Wipers . . .165
▫ Automatic High Beam — If Equipped ......165
▫ Daytime Running Lights — If Equipped .....166
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 117 of 674

▫Automatic Headlight Leveling —
HID Headlights Only ...................167
▫ Adaptive Bi-Xenon High Intensity Discharge
Headlights — If Equipped ...............167
▫ Headlight Delay ..................... .167
▫ Parking Lights And Panel Lights ...........168
▫ Fog Lights — If Equipped ...............168
▫ Interior Lights ....................... .169
▫ Lights-On Reminder ...................170
▫ Battery Saver ........................ .170
▫ Front Map/Reading Lights — If Equipped . . .170
▫ Courtesy Lights ...................... .171
▫ Ambient Light — If Equipped ............172
▫ Multifunction Lever ....................172 ▫
Turn Signals ........................ .173
▫ Lane Change Assist ...................173
▫ Flash-To-Pass ....................... .173
▫ High/Low Beam Switch .................173
WINDSHIELD WIPERS AND WASHERS ......174
▫ Windshield Wiper Operation .............174
▫ Intermittent Wiper System ...............175
▫ Windshield Washer Operation .............176
▫ Mist .............................. .177
▫ Rain Sensing Wipers — If Equipped ........178
TILT/TELESCOPING STEERING COLUMN . . .179
POWER TILT/TELESCOPING STEERING
COLUMN — IF EQUIPPED ...............180
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115
Page 167 of 674

Headlights On Automatically With Wipers
If your vehicle is equipped with Automatic Headlights, it
also has this customer-programmable feature. When
your headlights are in the automatic mode and the
engine is running, they will automatically turn on when
the wiper system is on. This feature is programmable
through the Uconnect® system screen. Refer to
“Uconnect® Settings” in “Understanding Your Instru-
ment Panel” for further information.
If your vehicle is equipped with a “Rain Sensitive Wiper
System” and it is activated, the headlights will automati-
cally turn on after the wipers complete five wipe cycles
within approximately one minute, and they will turn off
approximately four minutes after the wipers completely
stop. Refer to “Windshield Wipers And Washers” in this
section for further information.NOTE:
When your headlights come on during the day-
time, the instrument panel lights will automatically dim
to the lower nighttime intensity.
Automatic High Beam — If Equipped
The automatic high beam system provides increased
forward lighting at night by automating high beam
control through the use of a digital camera mounted on
the inside rearview mirror. This camera detects vehicle
specific light and automatically switches from high
beams to low beams until the approaching vehicle is out
of view.
NOTE:
• If the windshield or automatic high beam mirror is
replaced, the automatic high beam mirror must be
re-aimed to ensure proper performance. See your local
authorized dealer.3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165
Page 176 of 674
WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer controls are located on the
multifunction lever on the left side of the steering col-
umn. The front wipers are operated by rotating a switch,
located on the end of the lever. For information on the
rear wiper/washer, refer to “Rear Window Features” in
“Understanding The Features Of Your Vehicle”.
Windshield Wiper Operation
Rotate the end of the lever to one of the first four detent
positions for intermittent settings, the fifth detent for low
wiper operation and the sixth detent for high wiper
operation.
Multifunction Lever
174 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 178 of 674
NOTE:If the vehicle is moving less than 10 mph
(16 km/h), delay times will be doubled.
Windshield Washer Operation
To use the washer, push on the end of the lever (toward
the steering wheel) and hold while spray is desired. If the lever is pushed while in the intermittent setting, the
wipers will turn on and operate for several wipe cycles
after the end of the lever is released, and then resume the
intermittent interval previously selected.
Intermittent Wiper Operation
Windshield Washer Operation
176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 179 of 674
If the end of the lever is pushed while the wipers are in
the off position, the wipers will operate for several wipe
cycles, then turn off.
WARNING!
Sudden loss of visibility through the windshield
could lead to a collision. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with the defroster before and during
windshield washer use.
Mist
Use the Mist feature when weather conditions make
occasional usage of the wipers necessary. Rotate the end
of the lever downward to the Mist position and release
for a single wiping cycle.NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed on the
windshield. The wash function must be used in order to
spray the windshield with washer fluid.
Mist Control
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 177
Page 180 of 674

Rain Sensing Wipers — If Equipped
This feature senses moisture on the windshield and
automatically activates the wipers for the driver. The
feature is especially useful for road splash or overspray
from the windshield washers of the vehicle ahead. Rotate
the end of the multifunction lever to one of four settings
to activate this feature.
The sensitivity of the system can be adjusted with the
multifunction lever. Wiper delay position one is the least
sensitive, and wiper delay position four is the most
sensitive. Setting three should be used for normal rain
conditions. Settings one and two can be used if the driver
desires less wiper sensitivity. Setting four can be used if
the driver desires more sensitivity. Place the wiper switch
in the OFF position when not using the system.
NOTE:
•The Rain Sensing feature will not operate when the
wiper switch is in the low or high-speed position. •
The Rain Sensing feature may not function properly
when ice, or dried salt water is present on the wind-
shield.
• Use of Rain-X® or products containing wax or silicone
may reduce Rain Sensing performance.
• The Rain Sensing feature can be turned on and off
using the Uconnect® System, refer to “Uconnect®
Settings” in “Understanding Your Instrument Panel”
for further information.
The Rain Sensing system has protection features for the
wiper blades and arms, and will not operate under the
following conditions:
• Low Ambient Temperature — When the ignition is
first turned ON, the Rain Sensing system will not
operate until the wiper switch is moved, vehicle speed
is greater than 0 mph (0 km/h), or the outside tem-
perature is greater than 32°F (0°C).
178 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 181 of 674

•Transmission In NEUTRAL Position — When the
ignition is ON, and the automatic transmission is in
the NEUTRAL position, the Rain Sensing system will
not operate until the wiper switch is moved, vehicle
speed is greater than 5 mph (8 km/h), or the shift
lever/gear selector is moved out of the NEUTRAL
position.
Remote Start Mode Inhibit — On vehicles equipped
with Remote Starting system, Rain Sensing wipers are
not operational when the vehicle is in the remote start
mode. Once the operator is in the vehicle and has placed
the ignition switch in the RUN position, rain sensing
wiper operation can resume, if it has been selected, and
no other inhibit conditions (mentioned previously) exist.TILT/TELESCOPING STEERING COLUMN
This feature allows you to tilt the steering column
upward or downward. It also allows you to lengthen or
shorten the steering column. The tilt/telescoping lever is
located below the steering wheel at the end of the
steering column.
Tilt/Telescoping Lever
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 179