5-118Starting and driving
Skid and traction capabilities of studded
snow tires, on wet or dry surfaces, may be
poorer than that of non-studded snow
tires.
Tire chains may be used. For details, see
“Tire chains”in the“8. Maintenance and
do-it-yourself” section of this manual.
For four-wheel drive
If you install snow tires, they must also be
the same size, brand, construction and
tread pattern on all four wheels.
SPECIAL WINTER EQUIPMENT
It is recommended that the following items
be carried in the vehicle during winter:
.A scraper and stiff-bristled brush to
remove ice and snow from the windows
and wiper blades.
. A sturdy, flat board to be placed under
the jack to give it firm support.
. A shovel to dig the vehicle out of
snowdrifts.
. Extra window washer fluid to refill the
reservoir tank.
DRIVING ON SNOW OR ICE
WARNING
. Wet ice (328F, 0 8C and freezing rain),
very cold snow or ice can be slick and
very hard to drive on. The vehicle will
have much less traction or “grip”under
these conditions. Try to avoid driving on
wet ice until the road is salted or
sanded.
. Whatever the condition, drive with cau-
tion. Accelerate and slow down with
care. If accelerating or downshifting too
fast, the drive wheels will lose even
more traction.
. Allow more stopping distance under
these conditions. Braking should be
started sooner than on dry pavement.
. Allow greater following distances on
slippery roads.
. Watch for slippery spots (glare ice).
These may appear on an otherwise clear
road in shaded areas. If a patch of ice is
seen ahead, brake before reaching it. Try
not to brake while on the ice, and avoid
any sudden steering maneuvers. .
Do not use the cruise control on slippery
roads.
. Snow can trap dangerous exhaust gases
under your vehicle. Keep snow clear of
the exhaust pipe and from around your
vehicle.
ENGINE BLOCK HEATER (if so
equipped)
Engine block heaters are used to assist in
cold temperature starting.
The engine block heater should be used
when the outside temperature is 208 F
(−78C) or lower.
To use the engine block heater
1. Turn the engine off.
2. Open the hood and unwrap the engine
block heater cord.
3. Plug the engine block heater cord into a grounded 3-wire, 3-pronged extension
cord.
4. Plug the extension cord into a Ground Fault Interrupt (GFI) protected,
grounded 110-volt AC (VAC) outlet.
5. The engine block heater must be plugged in for at least 2 - 4 hours,
10-8
Voltmeter .......................................................... 2-10
W
WarningCheck tire pressure warning ......................... 2-25
Dot matrix display ....................................... 2-22
Hazard warning flasher switch ....................... 6-2
Lane departure warning (LDW) system ......... 5-22
Lights .......................................................... 2-12
Loose fuel cap warning ................................ 2-25
Tire pressure monitoring
system (TPMS) ....................................... 5-4, 6-3
Warning/indicator lights and
audible reminders ........................................ 2-11
Warning labels, Air bag warning labels ............. 1-69
Warning light 4WD warning light ..................................... 5-105
Air bag warning light ......................... 1-70, 2-17
Anti-lock braking system (ABS)
warning light ............................................... 2-12
Brake warning light ...................................... 2-13
Intelligent Key warning light ........................ 2-15
Lane departure warning light ....................... 2-15
Low tire pressure warning light .................... 2-15
Seat belt warning light and chime ............... 2-17
Warranty, Emission control system warranty ..... 9-31
Washer switch
Rear window wiper and washer switch ......... 2-36
Windshield wiper and washer switch ........... 2-34
Washing ............................................................. 7-2
Waxing ............................................................... 7-3 Welcome light ................................................... 2-65
Wheel/tire size ................................................... 9-9
Wheels and tires ............................................... 8-31 Care of wheels ............................................... 7-3
Cleaning aluminum alloy wheels .................... 7-3
Window washer fluid ........................................ 8-15
Window(s)
Cleaning ........................................................ 7-3
Power windows ............................................ 2-61
Windshield wiper and washer switch ................ 2-34
Wiper Rain-sensing auto wiper system ................... 2-35
Rear window wiper and washer switch ......... 2-36
Windshield wiper and washer switch ........... 2-34
Wiper blades ............................................... 8-20
X
Xenon headlights .............................................. 2-38
