2014 INFINITI Q70 HYBRID reset

*See your Owner’s Manual for information.
01 ADAPTI v E F RONT L IGHTING S YSTEM (AFS) Sw ITCH *
02 INSTRUMENT B RIGHTNESS C ONTROL Sw ITCH ES*
03 vEHICLE INFORMATION DISPLAY
04 TRIP RESET Sw ITCH*
05 TRIP COMPUTER S w ITCHES
06 HEADLIGHT AND T URN S IGNAL Sw ITCH
07 ASSIST CHARGE GAUGE
08 Ev INDICATOR LIGHT
09 wINDSHIELD wIPER AND wASHER SwITCH
10 STEERING wHEEL Sw ITCHES FOR A UDIO / B LUETOOTH®
11 CRUISE C ONTROL
12 DYNAMIC DRIv ER ASSISTANCE S w ITCH*
13 vEHICLE DYNAMIC CONTROL (vDC) OFF SwITCH*
01
07
23
24
252625
21
13141516
12
0802
06
22
14 REAR SONAR SYSTEM OFF SwITCH
15 wARNING SYSTEMS SwITCH
16 TILT / T ELESCOPIC S TEERING wHEEL Sw ITCH *
17 INTELLIGENT B RA k E A SSIST (IBA) Sw ITCH *
18 REAR S UNSHADE Sw ITCH *
19 HEATED STEERING wHEEL SwITCH*
20 TRUN k L ID R ELEASE Sw ITCH
21 HOOD R ELEASE *
22 CONTROL PANEL DISPLAY SCREEN
23 CLIMATE CONTROL SYSTEM
24 AUDIO SYSTEM
25 CLIMATE C ONTROLLED S EAT Sw ITCH *
26 INFINITI D RI v E M ODE S ELECTOR *
1110
Behind
steering wheel
Behind
steering wheel Behind
steering wheel
17
09
0304
05
192018
1276459_14_M_Hybrid_QRG_112213.indd 411/22/13 9:38 AM

8
essential information
Warning Systems Switch (if so equipped)
The warning systems switch 01 will turn on or off any
enabled warning systems including Lane Departure
w

arning (LD
w
), Blind Spot
w
arning (BS w ), and
Forward Collision
w
arning (FC
w
). Systems that are not
enabled will always remain off.
w hen the warning systems switch is turned off, the
indicator light
02 on the switch extinguishes. If the

warning systems switch is illuminated, the system is
on. The indicator will also be off if all of the warning
systems are deactivated using the Settings menu.
To enable or disable these systems, perform the
following steps:



1.

Press the
SE tt ING button
03 on the control panel.

2.


Using the INFINITI Controller
04 , highlight the
“Driver Assistance” key
05 on the display. Then

press the EN
t
ER button 06 .
3.


Highlight the corresponding warning system key


07 , select ON (enabled) or OFF (disabled) and
press the EN t ER button
06 .
For more information, refer to the “Starting and driving (section 5)” of your
Owner’s Manual.
01
02
03
04
06
05
07
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear in the
vehicle information display
01 when the fuel-filler
cap is not tightened correctly.
To tighten, turn the cap clockwise until a single click
is heard.
The warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button
02 is pressed for more than 1 second.

If the cap is not properly tightened, the Malfunction
Indicator Light
may illuminate.
For more information, refer to the “Instruments and controls (section 2)” and

the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
01
02
1276459_14_M_Hybrid_QRG_112213.indd 811/22/13 9:39 AM

18
first drive features
FM/AM/SiriusXM®* Satellite Radio With CD/DVD Player (if so equipped)
01 VOLUME/ON•OFF CONTROL KNOB

Press the
VOL/ON•OFF control knob to turn the system on or off. Turn the knob right or



left to increase or decrease the volume.
02 t UNE/FOLDER/AUDIO CON t ROL k NOB

To manually tune the radio, turn the
t UNE/FOLDER/AUDIO knob left or right.
03 SEEk •
CA t / t RAC k BU tt ONS

To scan quickly and stop at the previous or next broadcast station, pres\
s the or



end of the

SEEK•CAT/TRACK button.

For satellite radio, press the or end of the SEEK•CAT/TRACK button to switch to the
first channel of the previous or next category.
To change tracks on a CD, press the or end of the SEEK•CAT/TRACK button.

To rewind or fast forward a track on a CD, press and hold the or end of the
SEEK•CAT/TRACK button.
04 S t A t ION PRESE t BU tt ONS

Twelve stations can be set for the FM band, six for the AM band and eigh\
teen for
satellite radio.
To store a station in a preset, you must first select a radio band by pr\
essing the FM•AM
button
05 or
XM button
06 then tune to the desired FM, AM or XM satellite radio station.
Then press and hold the desired station preset button (1-6) until the preset number is
updated on the display and the sound is briefly muted. The channel indic\
ator will then
display and the sound will resume. Programming is now complete.
To retrieve a previously set station, select the radio band where the pr\
eset was stored
then press the corresponding station select button (1-6).
*SiriusXM® Satellite Radio is only available on vehicles equipped with an optional\
satellite radio subscription service.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
01
030506
02
04
1276459_14_M_Hybrid_QRG_112213.indd 1811/22/13 9:39 AM

19
USB/iPod® Interface
The USB jack 01 is located in the center console under

the arm rest.
w hen a compatible USB memory device or iPod® is
plugged into the USB jack, compatible audio and
video files stored on the device can be played through
the vehicle’s audio system and front display.
For more information, refer to the “Monitor, climate, audio, phone and
voice recognition systems (section 4)” of your Owner’s Manual.
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has reached
25 MPH (40km/h).
The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.
To activate the cruise control, push the ON/
OFF switch
01 . The
CRUISE
indicator light in the
instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push\
the COAS t /
SE
t switch

02 and release. The
CRUISE SE
t indicator light
in the instrument panel will
illuminate. Take your foot off the accelerator pedal. Your vehicle will \
maintain the set speed.
To reset at a faster cruising speed, push and hold the ACCEL/RES switch
03 . when the
vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAS t /SE t switch
02. Release the
switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
04 .
To turn off cruise control, push the ON/OFF switch
01 . Both the CRUISE indicator light and
the SE
t
indicator light in the instrument panel will extinguish.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
03
02
04
01
1276459_14_M_Hybrid_QRG_112213.indd 1911/22/13 9:39 AM

20
0205
06
Intelligent Cruise Control (ICC) System (if so equipped)
vEHICLE-TO-vEHICLE DISTANCE CONTROL MODE
To set v ehicle-To- v ehicle Distance Control mode,
press the CRUISE ON/OFF button
01 for less than

1.5 seconds. The CRUISE indicator light
02
will illuminate.
Accelerate to the desired speed.
Push down on the COAS t /SE t switch
03 and release
it. Cruise control will be set to the desired speed.
Press the distance button 04 repeatedly to change
the set distance between long, middle and short.
w hen a vehicle is not detected ahead of you in the



lane, the set distance and set vehicle speed indicator




lights will illuminate 05 in set mode.

w hen a vehicle is detected ahead of you in the lane, the vehicle ahead
detection set distance and set vehicle speed indicator lights will
illuminate
06 in set mode.
To reset at a faster cruising speed, push and hold the
ACCEL/RES switch 07 . when the



v

ehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAS t /SE t switch
03 . Release the



switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
08 or tap the brake pedal. The set
vehicle speed indicator 05 will extinguish.
To turn off cruise control, press the
CRUISE ON/OFF button
01 . The CRUISE indicator light

02 in the instrument panel will extinguish.
To set conventional (fixed speed) cruise control mode:
w hile cruise control is off, press the CRUISE ON/OFF
button
01 and hold it down for more
than 1.5 seconds. The CRUISE
indicator light will illuminate.
Accelerate to the desired speed.
Push down on the
COAS t /SE t switch 03 and release it. The SEt indicator light will
illuminate. Cruise control should be set to the desired speed.
To switch between the two cruise control modes:
w hen one of the two cruise modes is in use, you must turn the system off \
and then turn it on



again to select the other cruise control mode.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
0807
03
01
04
1276459_14_M_Hybrid_QRG_112213.indd 2011/22/13 9:39 AM

21
system guide
Trip Computer

whe n the
button
01 is pressed, the following

modes will appear on the vehicle information
display
02 :
•

E

nergy monitor – Displays energ y f low related to
the hybrid system and the charge level of the
Li-ion batter y.
•

MPG

– Displays the current fuel consumption.
•

MPG/MPH
– Displays the average fuel
consumption and speed since the last reset.



·


T

o reset, press and hold the
button 03 for
more than one second. Both the fuel consumption
and average speed will reset at the same time.
•
t
IME/MILES – Displays the elapsed time and
total distance the vehicle has been driven since
the last reset.



·


w
hen the elapsed time and trip odometer are displayed, To reset, press an\
d hold the

button
03 for more than one second. Both the elapsed time and trip odometer will \
reset at
the same time.
•

RANGE

– Displays the estimated distance to empty (dte) the vehicle can b\
e driven
before refueling.
•

OU

t
SIDE
t
EMP – Displays the exterior air temperature including a low temperature
warning feature.
•

SE

tt
ING – Allows you to set reminders for alerts and maintenance intervals o\
r change the
language and units used in the system.



· Press the
button
03 to cycle through the various setting modes.



· Press the
button
01 to choose the selected menu.
•

WARNING

– Displays when a warning is present.
To reset t RIP A and t RIP B, press and hold the t RIP RESE t button 04 for more than one second.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
Bluetooth® Hands-free Phone System
A cellular telephone should not be used while driving
so full attention may be given to vehicle operation.*
SYSTEM OPERATING TIPS
Press the or button to interrupt the voice
prompts at any time and speak a command after
the tone.
To use the system faster, you may speak the second level commands with t\
he main menu
command on the main menu. For example, press the
or button and after the tone
say, “Call Redial” .
03
01
02
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g.
04
Bluetooth®
Controls
1276459_14_M_Hybrid_QRG_112213.indd 2111/22/13 9:39 AM